HOME

TheInfoList



OR:

The two types of pagoda finial (''sōrin''), in bronze
('' tahōtō'') and stone ('' hōkyōintō'')
The is the vertical shaft (
finial A finial () or hip-knob is an element marking the top or end of some object, often formed to be a decorative feature. In architecture, it is a small decorative device, employed to emphasize the Apex (geometry), apex of a dome, spire, tower, roo ...
) which tops a Japanese pagoda, whether made of stone or wood.Pagodas can be made of wood or stone, and the two types are very different. Stone pagodas like the '' hōkyōintō'' are always small compared to wooden ones (usually below three meters), and offer little or no usable space inside. For details, see the article '' '' The ''sōrin'' of a wooden pagoda is usually made of bronze and can be over 10 meters tall. That of a stone pagoda is also of stone and less than a meter long. The ''sōrin'' is divided in several sections possessing a symbolic meaning and, as a whole, in turn itself represents a pagoda. Although quintessentially Buddhist, in Japan pagodas and their ''sōrin'' can be found both at Buddhist temples and
Shinto shrine A Stuart D. B. Picken, 1994. p. xxiii is a structure whose main purpose is to house ("enshrine") one or more kami, , the deities of the Shinto religion. The Also called the . is where a shrine's patron is or are enshrined.Iwanami Japanese dic ...
s. This is because until the Kami and Buddhas Separation Act of 1868 a Shinto shrine was normally also a Buddhist temple and vice versa. Itsukushima Shrine for example has one.


Support system

The ''sōrin'' is supported by a long shaft, often obtained by joining two or even three shorter ones, that runs to the base of the edifice. Although it is often believed that the pillar at the core of a Japanese pagoda is a device to strengthen it against earthquakes, its sole purpose is to support the long and heavy bronze ''sōrin''. In many cases the central shaft doesn't reach the ground, but has its base somewhere above it within the pagoda, where it is supported by beam or other means. At Nikkō Tōshō-gū (1818), for example, it is suspended with chains from the fourth floor. From its base exits a long tenon which, penetrating a mortise in a , prevents it from oscillating. This structure was adopted not as a measure against earthquakes but because, with aging, the wood of the pagoda, whose grain is mostly horizontal, tends to shrink more than that of the vertical shaft, causing the opening of a gap between the two at the roof. From the gap rain would enter, causing rot. In other cases, this was done to allow the opening of a room at the ground floor and therefore create some usable space. (Early wooden pagodas had no usable space.)


Structure


Wooden pagodas

The ''sōrin'' of a wooden pagoda is usually made of bronze and is divided in several segments called (from top to bottom): * The , a spherical or tear-shaped object, shapes sacred to Buddhism. Believed to repel evil and fulfill wishes, it can be also found on top of pyramidal temple roofs, of stone lanterns or of tall poles. It can have flames, in which case it is called . Those made before the Momoyama period tend to be rounder. * The , the piece immediately below the ''hōju'' * The , consisting of four decorative sheets of metal set at 90° to each other and installed over the top of the main pillar of a pagoda. *The , small bells attached to the edges of a ''sōrin's'' rings or of the ''suien''. * The , the largest component of the ''sōrin''. In spite of their name, there can sometimes be only eight or even seven of them. *The , a circle of upturned lotus petals, usually eight in number. There can also be another circle of petals facing down. * The , which sits between the ''ukebana'' and the ''roban''. *The , on which rests the entire finial. Because it covers the top of the roof in order to prevent leaks, it normally has as many sides as the roof itself (four, six or eight).


Stone pagodas

The most important stone pagoda having a finial is the '' hōkyōintō''. Usually made in stone and occasionally metal or wood, ''hōkyōintō'' started to be made in their present form during the
Kamakura period The is a period of History of Japan, Japanese history that marks the governance by the Kamakura shogunate, officially established in 1192 in Kamakura, Kanagawa, Kamakura by the first ''shōgun'' Minamoto no Yoritomo after the conclusion of the G ...
. Like a '' gorintō'', they are divided in five main sections, of which the ''sōrin'' is the uppermost. Its components are, from the top down: *''Hōju'' *''Ukebana'' *''Kurin'' *''Ukebana'' *''Roban''. The sōrin sits on the or , a stepped pyramid with four wings at the corners called or .Shinkō no Katachi - Hōkyōintō
Yatsushiro Municipal Museum, accessed on June 10, 2011


Sōrintō

The is a type of small pagoda consisting just of a pole and a ''sōrin''.


Notes


References

{{DEFAULTSORT:Sorin Japanese architectural features Roofs