HOME

TheInfoList



OR:

The Sunbeam S7 and S8 are British
motorcycle A motorcycle (motorbike, bike, or trike (if three-wheeled)) is a two or three-wheeled motor vehicle steered by a handlebar. Motorcycle design varies greatly to suit a range of different purposes: long-distance travel, commuting, cruising ...
s designed by
Erling Poppe Erling Poppe (12 November 1898 – 1970) was an Austrian-born English-raised motor vehicle designer who studied engineering in Birmingham, England, and designed Packman & Poppe Motorcycles, Sunbeam S7 and S8, Sunbeam motorcycles and Gordon (1954- ...
with styling loosely based on the
BMW R75 : ''For the 1970s 750 cc motorcycles see BMW R75/5, BMW R75/6, or BMW R75/7'' The BMW R75 is a World War II-era motorcycle and sidecar combination produced by the German company BMW. The BMW R75 stands out by its integral two-wheel drive des ...
designs that were acquired as war reparations by BSA (full rights to the
Sunbeam A sunbeam, in meteorological optics, is a beam of sunlight that appears to radiate from the position of the Sun. Shining through openings in clouds or between other objects such as mountains and buildings, these beams of particle-scattered sunl ...
brand had been acquired from AMC in 1943). Built in
Redditch Redditch is a town, and local government district, in north-east Worcestershire, England, approximately south of Birmingham. The district has a population of 85,000 as of 2019. In the 19th century, it became the international centre for the ...
, the unusual engine layout was similar to that of a car. The engine was a longitudinally mounted inline vertical OHC 500 cc twin based on an experimental 1932 BSA design (the Line-Ahead-Twin - LAT) with coil ignition and wet sump lubrication which, through a dry clutch, drove a shaft drive to the rear wheel. The inline engine made this technologically feasible—horizontally-opposed ("flat") twin engines on BMW motorcycles had already used shaft drives following the system employed by the four cylinder Nimbus since 1918. The early S7 was expensive and over engineered, which is why it is now the most sought-after and commands a premium over the S7 De Luxe and the S8, which were produced with fewer features to reduce costs, while retaining many of the innovative parts of the early Sunbeam and updating some ideas.


Models

Three models were produced, the S7, S7 "de luxe" and the S8. All three were very expensive with only modest performance resulting in low sales. The original model was the S7 (the "Tourer") (2,104 produced from 1946 to 1948), in 1949 the S7 was updated to become the S7 de luxe (5,554 produced) and the S8 (8,530 produced). Both had new cylinder linings, redesigned frames and increased oil capacity. The lighter S8 was sold as a "sportier" model with a top speed of . It also had new (BSA) forks, a cast aluminium silencer and chromed wheels (with narrower tyres to replace the 'balloon' tyres which had led to uncertain handling at speed). S9 and S10 models were planned but never made as BSA decided to concentrate on the more traditional twins. Another "sports" model was also tested but never put into production. This had a much higher compression ratio with a different OHC design but was never sold, reputedly because of the undampened front fork system which affected handling. There were also trials with a rigid version for a cheaper model but this design was also abandoned. The original S7 was produced in black. The S7 de luxe came in either "Mist Green" or black and the S8 in "Silver Grey" or black. For export abroad BSA would supply Sunbeams in any BSA colour.


Design problems

Erling Poppe’s design was originally based on a captured
BMW R75 : ''For the 1970s 750 cc motorcycles see BMW R75/5, BMW R75/6, or BMW R75/7'' The BMW R75 is a World War II-era motorcycle and sidecar combination produced by the German company BMW. The BMW R75 stands out by its integral two-wheel drive des ...
but so soon after the end of the war BSA did not want the S series to look too "German", so an in-line OHC parallel twin was designed instead of a flat twin "across the frame". Serious problems with vibration made the new Sunbeam bikes uncomfortable to ride and the initial production originally sent to South Africa was recalled. The excessive vibration was cured by mounting the engine on two bonded rubber engine mounts. The in-line engine was inherently suitable for
shaft drive A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a component for transmitting mechanical power and torque and rotation, usually used to connect ...
, and BMW-style
bevel gear Bevel gears are gears where the axes of the two shafts intersect and the tooth-bearing faces of the gears themselves are conically shaped. Bevel gears are most often mounted on shafts that are 90 degrees apart, but can be designed to work at oth ...
s would have been ideal. However, having inherited some worm-gear machinery from the
Lanchester Motor Company The Lanchester Motor Company Limited was a car manufacturer located until early 1931 at Armourer Mills, Montgomery Street, Sparkbrook, Birmingham, and afterwards at Sandy Lane, Coventry England. The marque has been unused since the last Lanches ...
, BSA opted to specify
worm drive A worm drive is a gear arrangement in which a worm (which is a gear in the form of a screw) meshes with a worm wheel (which is similar in appearance to a spur gear). The two elements are also called the worm screw and worm gear. The terminolo ...
rather than bevel gears. Reputedly this created problems with the shaft drive, as the gears tended to strip under power. It is said that Sunbeam's "solution" to this was to reduce the power to , which did nothing to help post-war sales.


Owners clubs

The Sunbeam Motor Cycle Club is one of the longest established in the UK and was founded in July 1924 at the London showrooms of John Marston Ltd in Holborn Viaduct who made the Sunbeam motorcycles in their factory at Wolverhampton. The Sunbeam Motor Cycle Club is, however, a sporting motorcycle club that organises trials and vintage bike rallies and runs and the "owners section" was just a small part of it. When Sunbeam production ended BSA sold the remaining stock of parts to Stewart Engineering. Bob and Chines Stewart were longtime fans of the Sunbeam and for a time members of the Sunbeam Motorcycle Club. In 1963 they, along with other enthusiasts, broke away from the Sunbeam Motorcycle Club and formed the Sunbeam Owners Fellowship (SOF) to support owners of an S7 or S8 with any problems. A good number of Sunbeams motorcycles survive in perfect working order and many owners have been fellows of the SOF since its inception, having owned their Sunbeam since bought new or second hand in the 1960s. A web-based owners club has been created.


See also

*
List of motorcycles of the 1940s This a listing of motorcycles of the 1940s, including those on sale, introduced, or otherwise relevant in this period. Motorcycle *Acme motorcycle (1939–49) * AJS 18 * AJS 7R *AJS Model 16 * AJS Model 20 *AJS Porcupine * Ariel Red Hunter * ...
*
List of motorcycles of the 1950s This a listing of motorcycles of the 1950s, including those on sale, introduced, or otherwise relevant in this period. * AJS 18 (1949-1963)


References

Shaft drive motorcycles


External links

{{Commons category, Sunbeam S8
The Sunbeam Owners Fellowship. The Club for owners and past owners
Sunbeam motorcycles Motorcycles introduced in the 1940s Motorcycles powered by straight-twin engines