Specific energy

Specific energy or massic energy is energy per unit mass. It is also sometimes called gravimetric energy density, which is not to be confused with energy density, which is defined as energy per unit volume. It is used to quantify, for example, stored heat and other thermodynamic properties of substances such as specific internal energy, specific enthalpy, specific Gibbs free energy, and specific Helmholtz free energy. It may also be used for the kinetic energy or potential energy of a body. Specific energy is an intensive property, whereas energy and mass are extensive properties.

The SI unit for specific energy is the joule per kilogram (J/kg). Other units still in use in some contexts are the kilocalorie per gram (Cal/g or kcal/g), mostly in food-related topics, watt hours per kilogram in the field of batteries, and the Imperial unit BTU per pound (Btu/lb), in some engineering and applied technical fields.
Kenneth E. Heselton (2004)
"Boiler Operator's Handbook"
Fairmont Press, 405 pages.

The concept of specific energy is related to but distinct from the notion of molar energy in chemistry, that is energy per mole of a substance, which uses units such as joules per mole, or the older but still widely used calories per mole.
Jerzy Leszczynski (2011)
"Handbook of Computational Chemistry"
Springer, 1430 pages.

Table of some non-SI conversions

The following table shows the factors for conversion to J/kg of some non-SI units:

For a table giving the specific energy of many different fuels as well as batteries, see the article Energy density.

Ionising radiation

For ionising radiation, the gray is the SI unit of specific energy absorbed by matter known as absorbed dose, from which the SI unit the sievert is calculated for the stochastic health effect on tissues, known as dose equivalent. The International Committee for Weights and Measures states: "In order to avoid any risk of confusion between the absorbed dose ''D'' and the dose equivalent ''H'', the special names for the respective units should be used, that is, the name gray should be used instead of joules per kilogram for the unit of absorbed dose ''D'' and the name sievert instead of joules per kilogram for the unit of dose equivalent ''H''."

Energy density of food

Energy density is the amount of energy per mass or volume of food. The energy density of a food can be determined from the label by dividing the energy per serving (usually in kilojoules or food calories) by the serving size (usually in grams, milliliters or fluid ounces). Energy density is thus expressed in cal/g, kcal/g, J/g, kJ/g, cal/mL, kcal/mL, J/mL, or kJ/mL. The "calorie" commonly used in nutritional contexts is the kilocalorie (abbreviated "Cal" and sometimes called the "dietary calorie", "food calorie" or "Calorie" with a capital "C"). This is equivalent to a thousand calories (abbreviated "cal") or one kilocalorie (kcal). Because food energy is commonly measured in Calories, the energy density of food is commonly called "caloric density".

Energy density measures the energy released when the food is metabolized by a healthy organism when it ingests the food (see food energy for calculation) and the food is metabolized with oxygen, into waste products such as carbon dioxide and water. Besides alcohol the only sources of food energy are carbohydrates, fats and proteins, which make up ninety percent of the dry weight of food. Therefore, water content is the most important factor in energy density. Carbohydrates provide four calories per gram (17 kJ/g), and proteins offer slightly less at 16kJ/g whereas fat provides nine calories per gram (38 kJ/g), times as much energy. Fats contain more carbon-carbon and carbon-hydrogen bonds than carbohydrates or proteins and are therefore richer in energy. Foods that derive most of their energy from fat have a much higher energy density than those that derive most of their energy from carbohydrates or proteins, even if the water content is the same. Nutrients with a lower absorption, such as fiber or sugar alcohols, lower the energy density of foods as well. A moderate energy density would be 1.6 to 3 calories per gram (7–13 kJ/g); salmon, lean meat, and bread would fall in this category. High-energy foods would have more than three calories per gram and include crackers, cheese, dark chocolate, and peanuts.

Fuel

Energy density is sometimes useful for comparing fuels. For example, liquid hydrogen fuel has a higher specific energy (energy per unit mass) than gasoline does, but a much lower volumetric energy density.

Astrodynamics

Specific mechanical energy, rather than simply energy, is often used in astrodynamics, because gravity changes the kinetic and potential specific energies of a vehicle in ways that are independent of the mass of the vehicle, consistent with the conservation of energy in a Newtonian gravitational system.

The specific energy of an object such as a meteoroid falling on the earth from outside the earth's gravitational well is at least one half the square of the escape velocity of 11.2 km/s. This comes to 63 MJ/kg (15 kcal/g, or 15 tonnes TNT equivalent per tonne). Comets have even more energy, typically moving with respect to the sun, when in our vicinity, at about the square root of two times the speed of the earth. This comes to 42 km/s, or a specific energy of 882 MJ/kg. The speed relative to the earth may be more or less, depending on direction. Since the speed of the earth around the sun is about 30 km/s, a comet's speed relative to the earth can range from 12 to 72 km/s, the latter corresponding to 2592 MJ/kg. If a comet with this speed fell to the earth it would gain another 63 MJ/kg, yielding a total of 2655 MJ/kg with a speed of 72.9 km/s. Since the equator is moving at about 0.5 km/s, the impact speed has an upper limit of 73.4 km/s, giving an upper limit for the specific energy of a comet hitting the earth of about 2690 MJ/kg.

If the Hale-Bopp comet (50 km in diameter) had hit Earth, it would have vaporized the oceans and sterilized the surface of Earth.

Miscellaneous

* Kinetic energy per unit mass: ''v''², where ''v'' is the speed (giving J/kg when ''v'' is in m/s). See also kinetic energy per unit mass of projectiles.
* Potential energy with respect to gravity, close to earth, per unit mass: ''gh'', where ''g'' is the acceleration due to gravity (standardized as ≈9.8 m/s²) and ''h'' is the height above the reference level (giving J/kg when ''g'' is in m/s² and ''h'' is in m).
* Heat: energies per unit mass are specific heat capacity times temperature difference, and specific melting heat, and specific heat of vaporization

See also

* Energy density, which has tables of specific energies of devices and materials
* Specific power
* Heat of combustion
* Specific orbital energy

References

*

{{DEFAULTSORT:Specific Energy
Energy (physics)
Thermodynamic properties