Design and development
The SK-1 was a wooden two-seat mid-wing cantilever monoplane with aStructure
The main structure comprised a spruce main spar and spruce fuselage stringers with a birch 3-ply skin. The front fuselage skins were moulded ply. The wing and rear fuselage were covered from flat sheets of ply. However, in certain areas, notably the top quadrant of the rear fuselage and the top surfaces of the tail surfaces were skinned with light alloy sheet which had been bonded to a thin wooden veneer, enabling them to be glued in the normal manner. This type of material was also used to make some components such as the control columns and to reinforce the stub spars which supported the tail surfaces. The nose and tail cones and the wing tips were fibreglass mouldings. The forward engine cowling and the air intakes were moulded from Durestos.Systems
Undercarriage retraction was pneumatic, using bleed air from the engine. The main landing gear was a Gemini strut and wheel, whilst the nose gear was a Gemini tail wheel assembly. The wingtip outriggers were purpose built. Engine start and instrumentation was electric, as was the gear down/up display. To save weight and space silver-zinc batteries were fitted. Radio and oxygen systems were not fitted.Novel construction techniques
The aerofoil section was a NACA laminar flow one to have a low profile drag. It was very important, therefore, that the sections be accurately made and surface waviness be kept small. To achieve this, the basic wing structure (spars and ribs) was built in a jig. Accurately profiled root and tip aerofoil sections were made in thick metal and carefully secured to one half wing. Two very straight heavy weight bars were held securely relative to each other and a router was fixed to a carriage which could slide along the bars. Using this set-up the entire half wing profile could be machined very accurately. The process was repeated for the other side. The skins could then be glued to the profiled structure. When work on the aircraft was nearing completion the wing surfaces were coated in epoxy resin and then carefully rubbed down to minimise any waviness. That process took several days, with careful profile checking as it went ahead. Flight observations suggested that the procedure had produced the required result. This is supported by the fact that the measured level speed at sealevel of 323 mph was close to the design estimate of 330 mph. The fuselage was constructed in a somewhat similar fashion, except that the frames were supported on a stiff central box which could be rotated rather like a lathe. Again the fuselage was routered to shape. A mould for the forward skins was produced by the same method.Team
Chief designer, test pilot and constructor—Hugh M Kendall Technician (aerodynamics, structure, drawing, systems) and flight test observer—John C Chaplin Two carpenters - John Caunter (former flying instructor with No. 8 EFTS at Woodley) and one other unidentified person Inspector—Douglas Bianchi Turbomeca provided support staff for supervising the engine installation and monitoring the initial engine runs. ARB team R J Fenner—design liaison surveyor P Hagger—Inspection Surveyor G Howitt—Test Pilot Other ARB staff as appropriateSpecifications
See also
References
Notes
Bibliography
* * {{refend 1950s British sport aircraft V-tail aircraft Mid-wing aircraft Single-engined jet aircraft Aircraft first flown in 1955