Singer Gazelle

The Singer Gazelle name has been applied to two generations of motor cars from the British manufacturer Singer. It was positioned between the basic Hillman range and the more sporting Sunbeam versions.

Gazelle I and II

The Gazelle was the first Singer to be produced following the take-over of the Singer company by the Rootes Group in 1956 and was a version of the mainstream Hillman Minx differing mainly in retaining the Singer overhead cam engine. Externally the only significant difference was a restyled nose based around a traditional Singer grille. The new car was announced in late September 1956.

The body style followed by the Gazelle between 1956 and 1967 came to be known as the "Audax" body, with significant input from the US based Loewy design organisation, highly regarded at the time partly on account of Loewy's input to several iconic Studebaker designs.

The Gazelle was initially offered in saloon and convertible body styles. The Gazelle Series II, offered from autumn 1957, was also available as an estate car, and had optional overdrive and larger fuel tank.

The suspension was independent at the front using coil springs while at the rear was a live axle and half elliptic leaf springs. The steering gear used a worm and nut system.

As standard, the car had a bench front seat but individual seats were available as an option. To allow for the bench seat, the handbrake lever was between the seat and the door.

The convertible version had a two position hood where it could be either completely lowered or rolled back to just behind the front seats described as the '' coupé de ville'' position. All side windows could be completely lowered. To compensate for the loss of body rigidity by the removal of the roof, extra cross bracing was fitted under the car.

A car with overdrive was tested by the British magazine ''The Motor'' in 1957. It had a top speed of and could accelerate from 0- in 24.8 seconds. A fuel consumption of was recorded. The test car cost £1016 including taxes of £332. This included the optional overdrive, heater and radio.

Gazelle IIA to IIIC

The Gazelle II was re-designated as the IIA in 1958. The standard Hillman pushrod overhead valve engine replaced the Singer overhead cam unit. The new engine was more powerful, developing 56 bhp against 49 bhp.

In line with Rootes Group policy the car kept getting small upgrades each with a new designation. In September 1958 the Gazelle, now re-designated III, received better seats, enhanced at the front by a folding central arm rest. A new two-tone paint became available with this upgrade.

The IIIA, introduced September 1959, gained small tail fins and a larger windscreen. The engine was upgraded with twin Solex carburettors replacing the single Solex, distinguishing it from the Minx, and lifting output to 60 bhp. Home market cars got a floor gear change and as well as overdrive, Smith's Easidrive automatic transmission also became an option.

Autocar Magazine carried out a Used Car Test, No.214 in their famous series, on a Singer Gazelle III first registered on 2 January 1961. What is not made clear is whether this was a Gazelle IIIb or an earlier Gazelle IIIa model, fitted with the twin carburettors. In comparison with the new Gazelle IIIb tested on 17 March 1961, it reached 0-60 mph in 23.9secs,compared with the used car at only 19.9secs. A 4sec saving. The standing quarter mile was also covered in 21.3sec. compared with 22.2 for the new IIIb model.

The IIIB, launched September 1960, reverted to a single carburettor which improved fuel consumption and facilitated servicing "in remoter territories". The IIIB also received a new back axle featuring a hypoid bevel in place of the former model's spiral bevel.

The IIIC, launched July 1961, was fitted with a larger engine of 1592 cc developing 53 bhp. The convertible was discontinued in February 1962 followed by the estate car in March 1962.

A Series III convertible with the 1494 cc engine was tested by ''The Motor'' in 1959. It was recorded as having a top speed of and could accelerate from 0- in 21.2 seconds. A fuel consumption of was recorded. The test car cost £1,003 including taxes of £295. This included the optional overdrive. The convertible cost £67 more than the saloon.

File:Singer Gazelle Series III Saloon.jpg, Singer Gazelle III Saloon
File:Singer Gazelle Convertible Rear.jpg, Singer Gazelle III Convertible
File:Singer_Gazelle_Interior.jpg, Singer Gazelle III Convertible
File:Singer Gazelle Series III (15895644366).jpg, Singer Gazelle III Station Wagon (Australia)
File:Singer Gazelle Convertible (1960).jpg, Singer Gazelle IIIA Convertible of 1960
File:1960.singer.gazelle.arp.jpg, Singer Gazelle IIIB Convertible of 1960

Gazelle IV

In July 1961 the Rootes Group released the new Singer Vogue, using the body of what was intended to be the Gazelle IV. As a consequence, the Gazelle IV designation was not used.

Gazelle V

The Gazelle V was introduced in August 1963, following the Hillman Minx update. It had an updated body with longer rear doors and no longer having a wrap-around rear window.

The front brakes became discs and from 1964 it gained a new gearbox with synchromesh on first gear. The optional Borg Warner automatic got a floor mounted selector lever.

File:Singer Gazelle V of 1964 (back).jpg, Singer Gazelle V of 1964

Gazelle VI

The Gazelle VI, which was introduced in 1965, was the last of the "Audax" Gazelles. The engine was all new, with a five-bearing crankshaft and capacity of 1725 cc at first developing 65 bhp but this was later reduced to 59 bhp.

The grille, now rectangular instead of the traditional Singer oval shape, was no longer attached to the opening bonnet but remained fixed to the front panels on opening.

Gazelle VII

The Gazelle VII was introduced in 1967 as one of numerous models in the Rootes Arrow range. It was offered only as a 4 door saloon. Initially only available with automatic transmission and a 1725cc engine, subsequently a manual transmission variant with the 1496 cc engine was introduced. Production ceased in 1970, the last example produced also being the last Singer to be built.

Australian production

Singer Gazelle

The Singer Gazelle was also produced in Australia from 1957 to 1961 by Rootes Australia. It was offered in Sports Saloon, Station Wagon and Estate Van models.

Hillman Gazelle

Following the purchase of Rootes Australia in 1965, Chrysler Australia produced a variant of the Gazelle VI as the Hillman Gazelle.

Scale models

*Meccano Dinky Toys; No. 168 (production 1959–63), Series 1 Gazelle, (1:44, approximately O scale).

References

{{Reflist

1960s cars
1970s cars
Rear-wheel-drive vehicles
Gazelle
Cars introduced in 1956
Sedans
Station wagons