S-IC

The S-IC (pronounced S-one-C) was the first stage of the American Saturn V rocket. The S-IC stage was manufactured by the Boeing Company. Like the first stages of most rockets, most of its mass of more than at launch was propellant, in this case RP-1 rocket fuel and liquid oxygen (LOX) oxidizer. It was tall and in diameter, and provided of thrust to get the rocket through the first of ascent. The stage had five F-1 engines in a quincunx arrangement. The center engine was fixed in position, while the four outer engines could be hydraulically gimballed to control the rocket.

Manufacturing

The Boeing Co. was awarded the contract to manufacture the S-IC on December 15, 1961. By this time the general design of the stage had been decided on by the engineers at the Marshall Space Flight Center (MSFC). The main place of manufacture was the Michoud Assembly Facility, New Orleans. Wind tunnel testing took place in Seattle and the machining of the tools needed to build the stages at Wichita, Kansas.

MSFC built the first three test stages (S-IC-T, the S-IC-S, and the S-IC-F) and the first two flight models (S-IC-1 and -2). They were built using tools produced in Wichita.

It took roughly seven to nine months to build the tanks and 14 months to complete a stage. The first stage built by Boeing was S-IC-D, a test model.

Components

The largest and heaviest single component of the S-IC was the thrust structure, with a mass of .http://www.apolloexplorer.co.uk/pdf/saturnv/First%20Stage.pdf
/ref> It was designed to support the thrust of the five engines and redistribute it evenly across the base of the rocket. There were four anchors which held down the rocket as it built thrust. These were among the largest aluminum forgings produced in the U.S. at the time, long and in weight. The four stabilizing fins withstood a temperature of .

Above the thrust structure was the fuel tank, containing of RP-1 fuel. The tank itself had a mass of over dry and could release . Nitrogen was bubbled through the tank before launch to keep the fuel mixed. During flight the fuel was pressurized using helium, which was stored in tanks in the liquid oxygen tank above.

Between the fuel and liquid oxygen tanks was the intertank.

The liquid oxygen tank held of LOX. It raised special issues for the designer. The lines through which the LOX ran to the engine had to be straight and therefore had to pass through the fuel tank. This meant insulating these lines inside a tunnel to stop fuel freezing to the outside and also meant five extra holes in the top of the fuel tank.

Two solid motor retrorockets were located inside each of the four conical engine fairings. At separation of the S-IC from the flight vehicle, the eight retrorockets fired, blowing off removable sections of the fairings forward of the fins, and backing the S-IC away from the flight vehicle as the engines on the S-II stage were ignited.

It also carried the ODOP transponder to track the flight after takeoff.

Image:SaturnV S-IC.jpg, Cutaway diagram of the S-IC.
Image:apmisc-MSFC-6870792.jpg, Saturn V first stages S-1C-10, S-1C-11, and S-1C-9 at Michoud Assembly Facility.
File:Apollo 11 first stage separation.jpg, Apollo 11 S-IC separation.

Stages built

See also

* S-II
* S-IVB
* Apollo (spacecraft)

References

External links

Stages to Saturn

Apollo Saturn Reference Page

{{DEFAULTSORT:S-Ic
Apollo program
Rocket stages