A runoff model is a mathematical model describing the
rainfall
Rain is water droplets that have condensed from atmospheric water vapor and then fall under gravity. Rain is a major component of the water cycle and is responsible for depositing most of the fresh water on the Earth. It provides water f ...
–
runoff
Runoff, run-off or RUNOFF may refer to:
* RUNOFF, the first computer text-formatting program
* Runoff or run-off, another name for bleed, printing that lies beyond the edges to which a printed sheet is trimmed
* Runoff or run-off, a stock market ...
relations of a rainfall ''catchment area'',
drainage basin
A drainage basin is an area of land where all flowing surface water converges to a single point, such as a river mouth, or flows into another body of water, such as a lake or ocean. A basin is separated from adjacent basins by a perimeter, t ...
or ''watershed''. More precisely, it produces a surface runoff
hydrograph
A hydrograph is a graph showing the rate of flow (discharge) versus time past a specific point in a river, channel, or conduit carrying flow. The rate of flow is typically expressed in cubic meters or cubic feet per second (cms or cfs).
It can als ...
in response to a rainfall event, represented by and input as a
hyetograph. In other words, the model calculates the conversion of rainfall into runoff.
A well known runoff model is the ''linear reservoir'', but in practice it has limited applicability.
The runoff model with a ''non-linear reservoir'' is more universally applicable, but still it holds only for catchments whose surface area is limited by the condition that the rainfall can be considered more or less uniformly distributed over the area. The maximum size of the watershed then depends on the rainfall characteristics of the region. When the study area is too large, it can be divided into sub-catchments and the various runoff hydrographs may be combined using
flood routing techniques.
![Water cycle](https://upload.wikimedia.org/wikipedia/commons/9/94/Water_cycle.png)
Rainfall-runoff models need to be
calibrated
In measurement technology and metrology, calibration is the comparison of measurement values delivered by a device under test with those of a calibration standard of known accuracy. Such a standard could be another measurement device of known ...
before they can be used.
Linear reservoir
![LinReserv](https://upload.wikimedia.org/wikipedia/commons/b/be/LinReserv.svg)
The hydrology of a linear reservoir (figure 1) is governed by two equations.
#flow equation: Q = A·S, with units
/T where L is length (e.g. mm) and T is time (e.g. h, day)
#continuity or water balance equation: R = Q + dS/dT, with units
/Twhere:
Q is the ''runoff'' or'' discharge''
R is the ''effective rainfall'' or ''rainfall excess'' or ''recharge''
A is the constant ''reaction factor'' or ''response factor'' with unit
/T
S is the water storage with unit
dS is a differential or small increment of S
dT is a differential or small increment of T
Runoff equation
A combination of the two previous equations results in a
differential equation
In mathematics, a differential equation is an equation that relates one or more unknown functions and their derivatives. In applications, the functions generally represent physical quantities, the derivatives represent their rates of change, an ...
, whose solution is:
* Q2 = Q1 exp + R
− expThis is the ''runoff equation'' or ''discharge equation'', where Q1 and Q2 are the values of Q at time T1 and T2 respectively while T2−T1 is a small time step during which the recharge can be assumed constant.
Computing the total hydrograph
Provided the value of A is known, the ''total hydrograph'' can be obtained using a successive number of time steps and computing, with the ''runoff equation'', the runoff at the end of each time step from the runoff at the end of the previous time step.
Unit hydrograph
The discharge may also be expressed as: Q = − dS/dT . Substituting herein the expression of Q in equation (1) gives the differential equation dS/dT = A·S, of which the solution is: S = exp(− A·t) . Replacing herein S by Q/A according to equation (1), it is obtained that: Q = A exp(− A·t) . This is called the
instantaneous unit hydrograph (IUH) because the Q herein equals Q2 of the foregoing runoff equation using ''R'' = 0, and taking S as ''unity'' which makes Q1 equal to A according to equation (1).
The availability of the foregoing ''runoff equation'' eliminates the necessity of calculating the ''total hydrograph'' by the summation of partial hydrographs using the ''IUH'' as is done with the more complicated
convolution
In mathematics (in particular, functional analysis), convolution is a operation (mathematics), mathematical operation on two function (mathematics), functions ( and ) that produces a third function (f*g) that expresses how the shape of one is ...
method.
Determining the response factor A
When the ''response factor'' A can be determined from the characteristics of the watershed (catchment area), the reservoir can be used as a ''deterministic model'' or ''analytical model'', see
hydrological modelling A hydrologic model is a simplification of a real-world system (e.g., surface water, soil water, wetland, groundwater, estuary) that aids in understanding, predicting, and managing water resources. Both the flow and quality of water are commonly stud ...
.
Otherwise, the factor A can be determined from a data record of rainfall and runoff using the method explained below under ''non-linear reservoir''. With this method the reservoir can be used as a
black box
In science, computing, and engineering, a black box is a system which can be viewed in terms of its inputs and outputs (or transfer characteristics), without any knowledge of its internal workings. Its implementation is "opaque" (black). The te ...
model.
Conversions
1 mm/day corresponds to 10 m
3/day per ha of the watershed
1 L/s per ha corresponds to 8.64 mm/day or 86.4 m
3/day per ha
Non-linear reservoir
![NonLinRes](https://upload.wikimedia.org/wikipedia/commons/5/56/NonLinRes.svg)
Contrary to the linear reservoir, the non linear reservoir has a reaction factor A that is not a constant, but it is a function of S or Q (figure 2, 3).
Normally A increases with Q and S because the higher the water level is the higher the discharge capacity becomes. The factor is therefore called Aq instead of A.
The non-linear reservoir has ''no'' usable
unit hydrograph.
During periods without rainfall or recharge, i.e. when ''R'' = 0, the runoff equation reduces to
* Q2 = Q1 exp , or:
or, using a ''unit time step'' (T2 − T1 = 1) and solving for Aq:
* Aq = − ln (Q2/Q1)
Hence, the reaction or response factor Aq can be determined from runoff or discharge measurements using ''unit time steps'' during dry spells, employing a
numerical method
In numerical analysis, a numerical method is a mathematical tool designed to solve numerical problems. The implementation of a numerical method with an appropriate convergence check in a programming language is called a numerical algorithm.
Mathem ...
.
Figure 3 shows the relation between Aq (Alpha) and Q for a small valley (Rogbom) in Sierra Leone.
Figure 4 shows observed and ''simulated'' or ''reconstructed'' discharge
hydrograph
A hydrograph is a graph showing the rate of flow (discharge) versus time past a specific point in a river, channel, or conduit carrying flow. The rate of flow is typically expressed in cubic meters or cubic feet per second (cms or cfs).
It can als ...
of the watercourse at the downstream end of the same valley.
Recharge
![Surface water cycle](https://upload.wikimedia.org/wikipedia/commons/8/80/Surface_water_cycle.svg)
The recharge, also called ''effective rainfall'' or ''rainfall excess'', can be modeled by a ''pre-reservoir'' (figure 6) giving the recharge as ''overflow''. The pre-reservoir knows the following elements:
*a maximum storage (Sm) with unit length
*an actual storage (Sa) with unit
*a relative storage: Sr = Sa/Sm
*a maximum escape rate (Em) with units length/time
/T It corresponds to the maximum rate of
evaporation
Evaporation is a type of vaporization that occurs on the surface of a liquid as it changes into the gas phase. High concentration of the evaporating substance in the surrounding gas significantly slows down evaporation, such as when humidi ...
plus ''percolation'' and
groundwater recharge
Groundwater recharge or deep drainage or deep percolation is a hydrologic process, where water moves downward from surface water to groundwater. Recharge is the primary method through which water enters an aquifer. This process usually occurs in ...
, which will not take part in the runoff process (figure 5, 6)
*an actual escape rate: Ea = Sr·Em
*a storage deficiency: Sd = Sm + Ea − Sa
The recharge during a unit time step (T2−T1=1) can be found from ''R'' = Rain − Sd
The actual storage at the end of a ''unit time step'' is found as Sa2 = Sa1 + Rain − ''R'' − Ea, where Sa1 is the actual storage at the start of the time step.
The
Curve Number method (CN method) gives another way to calculate the recharge. The ''initial abstraction'' herein compares with Sm − Si, where Si is the initial value of Sa.
Nash model
![Tank Model](https://upload.wikimedia.org/wikipedia/commons/b/b7/Tank_Model.jpg)
The Nash model uses a series (cascade) of linear reservoirs in which each reservoir empties into the next until the runoff is obtained. For
calibration
In measurement technology and metrology, calibration is the comparison of measurement values delivered by a device under test with those of a calibration standard of known accuracy. Such a standard could be another measurement device of know ...
, the model requires considerable research.
Software
Figures 3 and 4 were made with the RainOff program, designed to analyse rainfall and runoff using the non-linear reservoir model with a pre-reservoir. The program also contains an example of the hydrograph of an agricultural subsurface drainage system for which the value of A can be obtained from the system's characteristics.
The SMART hydrological model
includes agricultural subsurface drainage flow, in addition to soil and groundwater reservoirs, to simulate the flow path contributions to streamflow.
V''flo'' is another software program for modeling runoff.
V''flo'' uses
radar rainfall and
GIS
A geographic information system (GIS) is a type of database containing Geographic data and information, geographic data (that is, descriptions of phenomena for which location is relevant), combined with Geographic information system software, sof ...
data to generate physics-based, distributed runoff simulation.
The
WEAP (Water Evaluation And Planning) software platform models runoff and percolation from climate and land use data, using a choice of linear and non-linear reservoir models.
Th
RS MINERVEsoftware platform simulates the formation of free surface run-off flow and its propagation in rivers or channels. The software is based on object-oriented programming and allows hydrologic and hydraulic modeling according to a semi-distributed conceptual scheme with different rainfall-runoff model such as HBV, GR4J, SAC-SMA or SOCONT.
References
{{Agricultural water management models
Drainage
Hydrology
Hydrology models
Water management
Land management
Scientific models
Simulation software
Scientific simulation software