Rejected Take Off
   HOME

TheInfoList



OR:

In aviation terminology, a rejected takeoff (RTO) or aborted takeoff is the situation in which it is decided to abort the takeoff of an airplane. There can be many reasons for deciding to perform a rejected takeoff, but they are usually due to a suspected or actual problem with the aircraft, such as an engine failure; fire; incorrect configuration; aircraft controllability; environmental conditions such as predictive windshear; or an instruction from Air Traffic Control. There are three phases of a takeoff. In the low-speed regime, usually below 80 kts or so, the takeoff will be rejected even for minor failures. In the high-speed regime, above usually 80 kts but below V1, minor problems are ignored, but the takeoff will still be rejected for serious problems, in particular for engine failures. The takeoff decision speed, known as V1, is calculated before each flight for larger multi-engine airplanes. Below the decision speed, the airplane should be able to stop safely before the end of the runway. Above the decision speed, the airplane may overshoot the runway if the takeoff is aborted, and, therefore, a rejected takeoff is normally not performed above this speed, unless there is reason to doubt the airplane's ability to fly. If a serious failure occurs or is suspected above V1, but the airplane's ability to fly is not in doubt, the takeoff is continued despite the (suspected) failure, and the airplane will attempt to land again as soon as possible. If the airplane's ability to fly ''is'' in doubt (for instance, in the event of a major flight-control failure which leaves the airplane unable to rotate for liftoff), the best option may well be to reject the takeoff even if after V1, accepting the likelihood of a runway overrun. Single-engine aircraft will reject any takeoff after an engine failure, regardless of speed, as there is no power available to continue the takeoff. Even if the airplane is already airborne, if sufficient runway remains, an attempt to land straight ahead on the runway may be made. This may also apply to some light twin-engine airplanes. Before the takeoff roll is started, the
autobrake An autobrake is a type of automatic wheel-based hydraulic brake system for advanced airplanes. The autobrake is normally enabled during takeoff and landing procedures, when the aircraft's longitudinal deceleration system can be handled by the autom ...
system of the aircraft, if available, is armed. The autobrake system will automatically apply maximum brakes if throttle is reduced to idle or reverse thrust during the takeoff roll once a preset speed has been reached.


RTO testing

An RTO is usually seen as one of the hardest tests an airplane has to undergo for its certification trials. The RTO test is performed under the worst possible conditions; i.e. with fully worn out brakes, the plane loaded to maximum takeoff weight and no use of
thrust reversers Thrust reversal, also called reverse thrust, is the temporary diversion of an aircraft engine's thrust for it to act against the forward travel of the aircraft, providing deceleration. Thrust reverser systems are featured on many jet aircraft to ...
. During an RTO test most of the kinetic energy of the airplane is converted to heat by the brakes, which may cause the fusible plugs of the tires to melt, causing them to deflate. Small brake fires are acceptable providing, in the first five minutes, they do not prejudice the safe and complete evacuation of the aircraft.14 CFR 25.735(g)
/ref>


Accidents involving rejected take-offs

*
2008 South Carolina Learjet 60 crash On the night of September 19, 2008, a Learjet 60 business jet (registration operating for Global Exec Aviation crashed during take-off from Columbia Metropolitan Airport in South Carolina. Four of the six people on board died in the crash. Th ...
– an RTO above V1 * Air France Flight 007 – RTO above V1 after flight-control failure, 130 fatalities *
1990 Wayne County Airport runway collision The 1990 Wayne County Airport runway collision involved the collision of two Northwest Airlines jetliners at Detroit Metropolitan Wayne County Airport on December 3, 1990. Flight 1482, a scheduled Douglas DC-9-14 operating from Detroit to Pitts ...
– RTO after collision following
runway incursion A runway incursion is an Aviation accidents and incidents, aviation incident involving improper positioning of vehicles or people on any runway, airport runway or its Critical_area_(aeronautics), protected area. When an incursion involves an ''a ...
; aircraft struck destroyed with 8 fatalities, aircraft that performed RTO damaged with no fatalities, later repaired *
Ameristar Charters Flight 9363 Ameristar Charters Flight 9363 was an air charter flight from Willow Run Airport in Ypsilanti, Michigan to Dulles International Airport in Dulles, Virginia, which experienced a rejected takeoff and runway excursion on March 8, 2017 as the resu ...
– RTO above V1 after flight-control failure, aircraft written off but no fatalities * British Airtours Flight 28M – uncontained engine failure that damaged a fuel tank, resulting in a major fire and 55 fatalities * Garuda Indonesia Flight 865 – RTO after engine failure, 3 fatalities *
TWA Flight 843 TWA Flight 843 (TW843, TWA843) was a scheduled Trans World Airlines passenger flight that crashed after an aborted takeoff from John F. Kennedy International Airport (New York) to San Francisco International Airport (California) in July 1992. D ...
– RTO after engine failure * British Airways Flight 2276 – uncontained engine failure * Korean Air Flight 2708 – uncontained engine failure


See also

* Balanced field takeoff


References


External links


Airliners.net – Photos detailing a RTO performed by a Lockheed Tristar at Amsterdam Schiphol Airport


with good explanatory notes *
Boeing 747-8 rejected take-off test, 2011
{{Types of take-off and landing Emergency aircraft operations Types of take-off and landing