Red River Carts

The Red River cart is a large two-wheeled cart made entirely of non-metallic materials. Often drawn by oxen, though also by horses or mules, these carts were used throughout most of the 19th century in the fur trade and in westward expansion in Canada and the United States, in the area of the Red River and on the plains west of the Red River Colony. The cart is a simple conveyance developed by Métis for use in their settlement on the Red River in what later became Manitoba. With carts, the Metis were not restricted to river travel to hunt bison. The Red River cart was largely responsible for commercializing the buffalo hunt.

Description

According to the journal of North West Company fur-trader Alexander Henry the younger, the carts made their first appearance in 1801 at Fort Pembina, just south of what is now the Canada–United States border.A Few Thoughts About Red River Carts
Mark Peihl: 'A Few Thoughts About Red River Carts.' In: Clay County Historical Society (Hrsg.): CCHS Newsletter. March/April 2000. Republished as article on Clay County Historical Society website. Retrieved 12 January 2017. Derived either from the two-wheeled used in French Canada or from Scottish carts, it was adapted to use only local materials.

Because nails were unavailable or very expensive in the early West, these carts contain no iron at all, being entirely constructed of wood and animal hide. The cart can be dismantled, the wheels covered with bison hides to make floats and the box placed on top. Thus the cart can be floated across streams. Red River carts are strong enough to carry loads as heavy as . Two parallel oak shafts or "trams" bracket the draft animal in front and form the frame of the cart to the rear. Crosspieces hold the floorboards, and front, side and rear boards or rails made of willows or dimension lumber enclose the box. These wooden pieces are joined by mortices and tenons. Also of seasoned oak is the axle, lashed to the cart by strips of bison hide or " shaganappi" attached when wet, which shrink and tighten as they dry. The axles connect two spoked wheels, in diameter, which are "dished" outward from the hub, in the form of a shallow cone, for extra stability.

Motive power for the carts was originally supplied by small horses obtained from the First Nations. After cattle were brought to the Selkirk Settlement in the 1820s, oxen were used, preferred because of their strength, endurance, and cloven hooves, which spread their weight in swampy areas. The cart, constructed of native materials, can easily be repaired. A supply of shaganappi and wood are brought; a cart can break a half-dozen axles in a one-way trip. The axles are ungreased, as grease will capture dust, which acts as sandpaper and can immobilize the cart. The resultant squeal sounds like an untuned violin, giving it the sobriquet "the North West fiddle"; one visitor wrote that "a den of wild beasts cannot be compared with its hideousness."This noise can be heard by listening to a recording of a modern reconstruction of a full-scale cart.

Uses

The Red River Trails on which the carts were used extended from the Red River Colony via fur-trading posts, such as Pembina and St. Joseph in the Red River Valley, to Mendota and St. Paul, Minnesota. Furs were the usual cargo on the trip to St. Paul, and trade goods and supplies were carried on the trip back to the colony.

The Carlton Trail was also an important route for the carts, running from the Red River Colony west to Fort Carlton and Fort Edmonton in present-day Saskatchewan and Alberta, with branches such as the Fort à la Corne Trail. The carts were the primary conveyance in the Canadian West from early settlement until the coming of the Canadian Pacific Railway toward the end of the century. Carts could not be used west of Fort Edmonton because there were no roads or trails passable by wheeled vehicles over the Rocky Mountains.

The Hudson's Bay Company would use Red River carts as their main commercial cart in the 1860s. This was due to an increased success of the Minnesota cart route instead of the York Factory boat route.

Invented and developed by the Métis and Anglo-Metis peoples the Red River cart became a symbol of their heritage rooted in mobility and social networks.

Surviving examples, models and replicas

The National Museum of American History displays a Red River cart collected in the 1850s in its American Enterprise exhibition. Models may be found at St. Louis, Selkirk, Manitoba, Duck Lake and Prince Albert, Saskatchewan. The Clay County, Minnesota, Historical Society, an
Fort Vancouver National Historic Site
in Vancouver, Washington has a full-scale replica cart. Fort Nisqually Living History Museum in Washington State has a half-scale replica.

Fort Snelling, a historic site near Saint Paul, Minnesota operated by the Minnesota Historical Society, has a full-sized replica. The fort was an important early stop for traffic on what would become the Red River Trail.

The Remington Carriage Museum, Cardston, Alberta, also has a full-size replica of a Red River cart, as does Bent's Old Fort National Historic Site in La Junta, Colorado.

The Faculty of Native Studies at the University of Alberta displays a full-size replica of a Red River Cart in front of their home in Pembina Hall. This Red River Cart was donated to the Faculty by the Métis Nation of Alberta in November 2015. The Métis also donated an example to the Juno Beach Centre in France to commemorate their participation in the invasion of Normandy in 1944 and the liberation of Europe.''La charrette de la Rivière Rouge du CJB''
(fr.) an
''Les Métis et la charette de la rivière Rouge (The Métis and the Red River Cart)''
(fr. and en.), both Centre Juno Beach.

See also

* York boat
*Métis

References

External links

{{commons category, Red River carts
Living Prairie MuseumHistorical and Cultural Society of Clay CountyManitoba Historical Society: ''The Red River Cart and Trails: The Fur Trade''
*Barkwell, Lawrence. https://www.scribd.com/doc/24822945/Red-River-Cart

Carts
Red River Colony
Métis in Manitoba