The Procaer Cobra was a two-seat

turbojet The turbojet is an airbreathing jet engine which is typically used in aircraft. It consists of a gas turbine with a propelling nozzle. The gas turbine has an air inlet which includes inlet guide vanes, a compressor, a combustion chamber, an ...

powered

light aircraft A light aircraft is an aircraft that has a maximum gross takeoff weight of or less.Crane, Dale: ''Dictionary of Aeronautical Terms, third edition'', page 308. Aviation Supplies & Academics, 1997. Light aircraft are used as utility aircraft co ...

designed and built in Italy and flown in the early 1960s. Only one was completed.

Design and development

The Cobra was a

cantilever A cantilever is a rigid structural element that extends horizontally and is supported at only one end. Typically it extends from a flat vertical surface such as a wall, to which it must be firmly attached. Like other structural elements, a cant ...

low wing monoplane with a wooden structure covered in plywood, which had an outer thin

aluminium Aluminium (aluminum in American and Canadian English) is a chemical element with the symbol Al and atomic number 13. Aluminium has a density lower than those of other common metals, at approximately one third that of steel. I ...

skin bonded to it. The single

spar SPAR, originally DESPAR, styled as DE SPAR, is a Dutch multinational that provides branding, supplies and support services for independently owned and operated food retail stores. It was founded in the Netherlands in 1932, by Adriaan van Well, ...

wings had a maximum thickness to chord ratio of 16.5%; in plan they were unswept and straight tapered. There was 6° of dihedral. The ailerons were fitted with electrically operated

trim tab Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a pa ...

s and the inboard flaps were hydraulically powered. The small

Turbomeca Marboré The Turbomeca Marboré is a small turbojet engine that was produced by Turbomeca from the 1950s into the 1970s. The most popular uses of this engine were in the Fouga CM.170 Magister and the Morane-Saulnier MS.760 Paris. It was also licensed fo ...

turbojet engine was mounted in the central lower

fuselage The fuselage (; from the French ''fuselé'' "spindle-shaped") is an aircraft's main body section. It holds crew, passengers, or cargo. In single-engine aircraft, it will usually contain an engine as well, although in some amphibious aircraf ...

, fed from

wing root The wing root is the part of the wing on a fixed-wing aircraft or winged-spaceship that is closest to the fuselage The fuselage (; from the French ''fuselé'' "spindle-shaped") is an aircraft's main body section. It holds crew, passengers, o ...

inlets and exhausting under the raised rear fuselage just aft of the wing

trailing edge The trailing edge of an aerodynamic surface such as a wing is its rear edge, where the airflow separated by the leading edge meets.Crane, Dale: ''Dictionary of Aeronautical Terms, third edition'', page 521. Aviation Supplies & Academics, 199 ...

. Fuel was supplied from one fuselage and two wing tanks. The horizontal tail was unswept and straight tapered, with squared tips, the starboard

elevator An elevator or lift is a cable-assisted, hydraulic cylinder-assisted, or roller-track assisted machine that vertically transports people or freight between floors, levels, or decks of a building, vessel, or other structure. They a ...

carrying an electrically operated trim tab. The

fin A fin is a thin component or appendage attached to a larger body or structure. Fins typically function as foils that produce lift or thrust, or provide the ability to steer or stabilize motion while traveling in water, air, or other fluids. Fin ...

and

rudder A rudder is a primary control surface used to steer a ship, boat, submarine, hovercraft, aircraft, or other vehicle that moves through a fluid medium (generally air or water). On an aircraft the rudder is used primarily to counter adve ...

were also straight tapered but swept, with a long, low

dorsal Dorsal (from Latin ''dorsum'' ‘back’) may refer to: * Dorsal (anatomy), an anatomical term of location referring to the back or upper side of an organism or parts of an organism * Dorsal, positioned on top of an aircraft's fuselage * Dorsal c ...

strake On a vessel's hull, a strake is a longitudinal course of planking or plating which runs from the boat's stempost (at the bows) to the sternpost or transom (at the rear). The garboard strakes are the two immediately adjacent to the keel on ea ...

. The cockpit, positioned forward of the wing, seated two side by side. It had a one piece windscreen and a single piece, rear hinged

canopy Canopy may refer to: Plants * Canopy (biology), aboveground portion of plant community or crop (including forests) * Canopy (grape), aboveground portion of grapes Religion and ceremonies * Baldachin or canopy of state, typically placed over an ...

. The Cobra had a retractable

tricycle undercarriage Tricycle gear is a type of aircraft undercarriage, or ''landing gear'', arranged in a tricycle fashion. The tricycle arrangement has a single nose wheel in the front, and two or more main wheels slightly aft of the center of gravity. Tricycle g ...

, the wing mounted main members swinging inwards close to the air inlet ducts. The Cobra first flew on 16 November 1960. The construction of a second prototype, the four seat Cobra 480, was begun but not finished.

Operational history

The sole flying Cobra was lost in an accident in August 1965. The unfinished Cobra 480 still exists and building continues in 2010.

Variants

;Cobra 400: First prototype, two seater. ;Cobra 480: Second prototype, four seater ,only partly built.

Specifications (Cobra 400)

References

External links

NACA 643218 airfoil
{{Frati aircraft 1960s Italian sport aircraft Single-engined jet aircraft Low-wing aircraft Aircraft first flown in 1960