In music notation, a note value indicates the relative duration (music), duration of a note (music), note, using the texture or shape of the ''notehead'', the presence or absence of a ''stem (music), stem'', and the presence or absence of ''flags/beam (music), beams/hooks/tails''. Unmodified note values are fractional powers of two, for example one, one-half, one fourth, etc. A rest (music), rest indicates a silence of an equivalent duration.

List

Shorter notes can be created theoretically ''ad infinitum'' by adding further flags, but are very rare.

Variations

The breve appears in several different versions. Sometimes the longa or breve is used to indicate a very long note of indefinite duration, as at the end of a piece (e.g. at the end of Mozart's Mass KV 192). A single eighth note, or any faster note, is always stemmed with flags, while two or more are usually beamed in groups.Gerou, Tom (1996). ''Essential Dictionary of Music Notation'', p.211. Alfred. When a stem is present, it can go either up (from the right side of the note head) or down (from the left side), except in the cases of the ''longa'' or ''maxima'' which are nearly always written with downward stems. In most cases, the stem goes down if the notehead is on the center line or above, and up otherwise. Any flags always go to the right of the stem.

Modifiers

A note value may be augmentation (music), augmented by adding a dot after it. This Dotted note, dot adds the next briefer note value, making it one and a half times its original duration. A number of dots (''n'') lengthen the note value by its value, so Dotted note, two dots add two lower note values, making a total of one and three quarters times its original duration. The rare Dotted note, three dots make it one and seven eighths the duration, and so on. The double dot was first used in 1752 by Johann Joachim Quantz, J. J. Quantz;Willi Apel, "Dotted Notes", ''Harvard Dictionary of Music'', second edition, revised and enlarged (Cambridge, Massachusetts: Belknap Press of Harvard University Press, 1972) . in music of the 18th century and earlier the amount by which the dot augmented the note varied: it could be more or less than the modern interpretation, to fit into the context. The ''vertical'' double dot was introduced by Willi Apel and is commonly used in modern transcriptions of medieval and renaissance music. It lengthens an already dotted note by half: a dotted half note (minim) consisting of 6 quarter notes becomes 9 quarters when vertically double-dotted. This greatly simplifies modern notation (which otherwise would require a dotted half note tied to a dotted quarter note). To divide a note value to three equal parts, or some other value than two, tuplets may be used. However, see swung note and notes inégales.

History

Gregorian chant

Although note heads of various shapes, and notes with and without stems appear in early Gregorian chant manuscripts, many scholars agree that these symbols do not indicate different durations, although the dot is used for augmentation. See neume. In the 13th century, chant was sometimes performed according to rhythmic modes, roughly equivalent to Metre (music), meters; however, the note shapes still did not indicate duration in the same way as modern note values.

Mensural notation

Around 1250, Franco of Cologne invented different symbols for different durations, although the relation between different note values could vary; three was the most common ratio. Philippe de Vitry's treatise Ars nova (treatise), Ars nova (1320) described a system in which the ratios of different note values could be 2:1 or 3:1, with a system of mensural time signatures to distinguish between them. This black mensural notation gave way to ''white mensural notation'' around 1450, in which all note values were written with white (outline) noteheads. In white notation the use of tuplet, triplets was indicated by ''coloration'', i.e. filling in the noteheads to make them black (or sometimes red). Both black and white notation periodically made use of Ligature (music), ligatures, a holdover from the ''clivis'' and ''porrectus'' neumes used in Gregorian chant, chant. Around 1600 the modern notational system was generally adopted, along with bar (music), barlines and the practice of writing multipart music in scores rather than only individual parts. In the 17th century, however, old usages came up occasionally.

Origins of the names

The British names go back at least to English renaissance music, and the terms of Latin origin had international currency at that time. ''Longa'' means 'long', and many of the rest indicate relative shortness. ''Breve'' is from Latin ''brevis'', 'short', ''minim'' is from ''minimus'', 'very small', and ''quaver'' refers to the quavering effect of very fast notes. The elements ''semi-'', ''demi-'' and ''hemi-'' mean 'half' in Latin, French and Greek respectively. The chain semantic shift whereby notes which were originally perceived as short came progressively to be long notes is interesting both linguistically and musically. However, the ''crotchet'' is named after the shape of the note, from the Old French for a 'little hook', and it is possible to argue that the same is true of the ''minim'', since the word is also used in palaeography to mean a vertical stroke in mediaeval handwriting.

References

{{Rhythm and meter Note values,