Mallet Finger
   HOME

TheInfoList



OR:

A mallet finger, also known as hammer finger or PLF finger or Hannan finger, is an extensor tendon injury at the farthest away finger joint. This results in the inability to extend the finger tip without pushing it. There is generally pain and bruising at the back side of the farthest away finger joint. A mallet finger usually results from overbending of the finger tip. Typically this occurs when a ball hits an outstretched finger and jams it. This results in either a tear of the tendon or the tendon pulling off a bit of bone. The diagnosis is generally based on symptoms and supported by
X-rays An X-ray, or, much less commonly, X-radiation, is a penetrating form of high-energy electromagnetic radiation. Most X-rays have a wavelength ranging from 10 Picometre, picometers to 10 Nanometre, nanometers, corresponding to frequency, ...
. Treatment is generally with a splint that holds the fingertip straight continuously for 8 weeks. The middle joint is allowed to move. This should be begun within a week of the injury. If the finger is bent during these weeks, healing may take longer. If a large piece of bone has been torn off surgery may be recommended. Without proper treatment a permanent deformity of the finger may occur.


Diagnosis

The diagnosis is generally based on symptoms and supported by
X-rays An X-ray, or, much less commonly, X-radiation, is a penetrating form of high-energy electromagnetic radiation. Most X-rays have a wavelength ranging from 10 Picometre, picometers to 10 Nanometre, nanometers, corresponding to frequency, ...
. The injury can be accompanied by swelling and
ecchymosis A bruise, also known as a contusion, is a type of hematoma of tissue, the most common cause being capillaries damaged by trauma, causing localized bleeding that extravasates into the surrounding interstitial tissues. Most bruises occur close e ...
. File:MalletFinger.PNG, X-ray showing fracture at the insertion of the extensor tendon File:Mallet finger.PNG, A mallet finger without an associated fracture


Treatment

The management goal is to restore extension of the joint. Treatment is generally with a splint that holds the first joint of the finger straight continuously for 8 weeks. This should begin within a week of the injury. The splint may be worn just at night for a few additional weeks after this. The splint acts to immobilize flexing of the joint. Surgery generally does not improve outcomes. It may be required if the finger cannot be straightened by pushing on it or the break has pulled off more than 30% of the joint surface. Surgery may be preferred over the use of a split if a child is non-compliant. If the problem has been present a long time surgery may also be required. An open fracture may be another reason. Surgery will put the finger in a neutral position and drill a wire through the distal interphalangeal joint (DIP) to the proximal interphalangeal joint (PIP), forcing immobilization. File:Splint1.JPG, An example of a splint for mallet finger. File:Splint2.JPG, Lateral view of a splint for mallet finger. Note the lower side is open to allow the second joint to flex.


See also

*
Busch fracture In medicine a Busch fracture is a type of fracture of the base of the distal phalanx of the fingers, produced by the removal of the bone insertion ( avulsion) of the extensor tendon. Without the appropriate treatment, the finger becomes a hammer ...
*
Jersey finger Jersey finger, also known as rugby finger, is a finger-related tendon injury that is common in sport and can result in permanent loss of flexion of the end of the finger if not surgically repaired. The injury is common when one player grabs another ...


References


External links

{{Acquired musculoskeletal deformities Fingers Injuries of wrist and hand Musculoskeletal disorders Wikipedia medicine articles ready to translate