Lifting equipment
The regulations define lifting equipment as "work equipment for lifting or lowering loads and includes its attachments used for anchoring, fixing or supporting it".Safe working load
APassenger lifts
The regulations stated that all lifts provided for use with work activities should be thoroughly examined by a 'competent person' at regular intervals. Regulation 9 of the Lifting Operations and Lifting Equipment Regulations requires all employers to have their equipment thoroughly examined prior to it being put into service and after there has been any major alteration that could affect its operation. Owners or people responsible for the safe operation of a lift at work are known as 'dutyholders' and have a responsibility to ensure that the lift has been thoroughly examined and is safe to use. Lifts when in use should be thoroughly examined every six months if, at any time, the lift has been used to carry people. Lifts used to only carry loads should be examined every 12 months. Any substantial or significant changes should have been made to the equipment then this would also require an examination as would any change in operating condition which is likely to affect the integrity of the equipment.HSE - Thorough examination and testing of lifts - simple guidanceLOLER Inspections
These are a legal requirement and should be carried out by a competent person. Though a "competent person" is not defined within the legislation, guidance is given in the HSE LOLER Approved Code of Practice and guidance which gives further details that the person should have the "appropriate practical and theoretical knowledge and experience of the lifting equipment" which would allow them to identify safety issues. In practice, an insurance company may provide a competent person or request a third party independent inspector. These inspections should be carried out at 6 monthly intervals for all lifting items and at least every 12 months for those that could be covered by PUWER, although a competent person may determine different time scales. Standards state that as a minimum; * Every six months for lifting equipment used for lifting/lowering persons. * Every six months for lifting accessories. * Every 12 months for all other lifting equipment not falling into either of the above categories * A competent person may deem different time scale LOLER Frequency (in months):Employers' and workers' obligations
LOLER 1998 put in place four key protocols that all employers and workers must abide by. All equipment must be safe and suitable for purpose. The manufacturer must identify any hazards associated with the equipment in question, they must then assess these hazards to bring them down to acceptable levels. All lifting equipment is normally put through an independent type testing process to establish that it will safely perform the tasks required to one of the below standards. *BS (British Standard, used mainly in the UK) *ISO Standards (International Standard) *EN ( Euronorm, used throughout Europe) *CEN/CENELEC (Euronorm Standards) The above standards are a published specification that establishes a common language and contains a technical specification or other precise criteria. They are designed to be used consistently as a rule, guideline or definition. All personnel must be suitably trained. All manufacturers of lifting equipment are obliged to send out instructions for use of all products. The employer is then obliged to make sure employees are aware of these instructions and use the lifting equipment correctly. To achieve this the employees must be competent. Competence is achieved through experience, technical knowledge and training. All equipment must be maintained in a safe condition. It is good practice for all personnel using lifting equipment to conduct a pre-use inspection on all items. Regulation 9 of LOLER also outlines specific requirements for the formal inspection of lifting equipment at mandatory intervals. These inspections are to be performed by a competent person and the findings of the inspections recorded. Maximum fixed periods for thorough examinations and inspection of lifting equipment as stated in regulation 9 of LOLER are: *Equipment used for lifting persons – 6 Months *Lifting accessories – 6 Months *Other lifting appliances – 12 Months or in accordance with a written scheme of examination. Any inspection record must be made in line with the requirements of schedule 1 of LOLER. The only exception to this is: If the lifting equipment has not been used before and; In the case of lifting equipment issued with an EC declaration of conformity, the employer has possession of such declaration and it is not made more than 12 months before the lifting equipment is put into service.Record keeping
Operators of lifting equipment are legally required to ensure that reports of thorough examinations are kept available for consideration by health and safety inspectors for at least two years or until the next report, whichever is longer. Records must be kept for all equipment. All equipment manufactured should be given a “birth certificate”. This should prove that when first made, it complied with any requirement. In Europe today, this document would normally be an EC Declaration of conformity plus a manufacturers certificate if called for by the standard worked to. They may be kept electronically as long as you can provide a written report if requested. To gain an understanding of the your Health and Safety requirements in the motor vehicle repair industry in full read document HSG261.Prosecutions arising from the regulations
On 17 January 2011, a Liverpool nursing home was fined £18,000 after Frances Shannon, an 81-year-old woman fell to the ground whilst being lifted out of bed. The Christopher Grange nursing home, run by the Catholic Blind Institute, was prosecuted by theNotes
References
{{reflist 1998 in British law Health and safety in the United Kingdom Lifting equipment Safety engineering Safety codes Statutory Instruments of the United Kingdom