LNER Class W1

The LNER W1 No. 10000 (also known as the ''Hush-Hush'' due to its secrecy) was an experimental steam locomotive fitted with a high pressure water-tube boiler. Nigel Gresley was impressed by the results of using high-pressure steam in marine applications and so in 1924 he approached Harold Yarrow of shipyard and boilermakers Yarrow & Company of Glasgow to design a suitable boiler for a railway locomotive, based on Yarrow's design.

Boiler

The boiler was not the usual Yarrow design. In operation, particularly its circulation paths, the boiler had more in common with other three-drum designs such as the Woolnough. It has also been described as an evolution of the Brotan-Deffner water-tube firebox, with the firebox extended to become the entire boiler.

The boiler resembled two elongated marine Yarrow boilers, joined end to end. Both had the usual Yarrow triangular arrangement of a central large steam drum above two separated water drums, linked by multiple rows of slightly curved tubes. The rearward "firebox" area was wide and spanned the frames, placing the water drums at the limits of the loading gauge. The forward "boiler" region was narrow-set, with its water drums placed between the frames. The space outboard of the tubes formed a pair of exhaust flues leading forwards. A large space outside these flue walls but inside the boiler casing was used as an air duct from the air inlet, a crude rectangular slot beneath the smokebox door, which had the effect of both pre-heating the combustion air and also cooling the outer casing to prevent overheating. Longitudinal superheater tubes were placed between the steam generating tubes. The third area forwards contained superheater headers, the regulators and the smokebox. The external boiler casing remained at much the same width throughout, giving an overall triangular, but curved, appearance. The lower edge of each section stepped upwards, and was obvious externally.

Working pressure was of as opposed to the of the contemporary Gresley A1 locomotives.

The heavy forgings for the main drums were built in Sheffield by the John Brown shipyard. Nock, British Steam Railway Locomotive, p. 106 The boiler was constructed and fitted to the frames by Yarrow in Glasgow, involving the rolling chassis being carried over the LMS, carefully sheeted over to avoid inspection by a rival railway company. This chassis was a 4-2-2-4 at this point, as the centre drivers and rods had not yet been fitted. The first works photographs, with the boiler cladding in grey, were taken in Glasgow, with a wooden dummy centre driver and coupling rod added for the photo.

Motion

This apparatus was based on a Gresley Pacific 4-6-2 chassis, although with an additional axle to accommodate the extra length. This resulted in a 4-6-4 wheel arrangement, making No. 10000 the only standard gauge 4-6-4 tender engine to run on a British railway (although there were several standard gauge 4-6-4 T classes that ran in Great Britain) .

In UIC notation this wheel arrangement could be described as a 2′C1′1′ (or more fully, 2′C1′1′h4vS) as the two trailing axles were independent, rather than a four-wheeled bogie as for those leading. The forward axle was similar to that of the Pacifics, having outside frames and Cartazzi axleboxes. The rear axle was an inside-framed Bissel truck, pivoted ahead of the leading axle.

The high pressure necessitated compound expansion; steam being supplied to the two high-pressure inside cylinders and then fed into two larger low-pressure outside cylinders before going to exhaust. High-pressure cylinder diameter was subsequently reduced to . Gresley incorporated an ingenious unique system for giving independent cutoff to the high-pressure cylinders using only two sets of Walschaerts valve gear derived from the outside cranks on the Von Borries principle van Riemsdijk, Compound Locomotives and using an inside half-length expansion link. Brown, Gresley, p.104 and fold-out drawing

In service

The locomotive was completed at Darlington Works in 1929.

The locomotive had a corridor tender and ran non-stop London-Edinburgh services to time in 1930; nevertheless steaming was relatively poor during test runs, and in spite of a number of modifications initially to the exhaust, boiler performance never reached the standards of an equivalent firetube boiler. A problem never fully solved was air leakage into the casing. Brown, Gresley, p.106

Tender

The corridor tender was similar to the ten built in 1928 for those locomotives of classes A1 and A3 that were used on non-stop services such as the ''Flying Scotsman''. The 1929 tender differed from the 1928 tenders in a few details, such as being provided with disc wheels instead of spoked, and having the in-curved front ends of the side sheets finishing apart instead of , in order to suit the W1 cab as opposed to the A1/A3 cab.

Rebuilding

When it was deemed that no further progress could be made, the locomotive was taken to Doncaster Works in 1936 and rebuilt with a conventional boiler and three simple expansion cylinders on the normal Gresley layout. A modified A4 boiler was fitted which had of grate area and diameter cylinders. The valves were considered undersized for the large cylinder diameter and this somewhat limited the speed capabilities of the engine. Its haulage capacity was nonetheless appreciated. The rebuilt engine still retained its additional axle, resulting in a more spacious cab for the driver and fireman. The tender was not rebuilt, but was modified slightly at the front so that the ends of the curved side sheets now finished apart; it was also given streamlined plating at the top (which was removed again in January 1938) and a longer coal chute.After the rebuild, the water-tube boiler returned to Darlington for pressure experiments and space heating, before being broken up on 10 April 1965, six years after the rebuilt W1.

No. 10000 never carried a name, although it did carry small works plates on the smoke deflectors bearing the number 10000. In its early form, it was known unofficially as the ''Hush-Hush'' as a result of the initial secrecy surrounding the project, and also the ''Galloping Sausage'' as a result of its bulging boiler shape. Plans in 1929 to name the original engine ''British Enterprise'' were dropped, although nameplates had already been cast; a 1951 plan to name the rebuilt engine ''Pegasus'' did not come to fruition either. During a works visit in May/June 1948, the corridor tender was exchanged for one of the non-corridor type, and it was given British Railways livery and renumbered 60700.

On 1 September 1955, 60700 had just departed from Peterborough when the front bogie frame broke. The locomotive derailed at a speed of at Westwood Junction. It was recovered and repaired.

60700 was withdrawn on 1 June 1959 and was broken up for scrap at the Doncaster Works later that year. The first of its two tenders did survive into preservation. Corridor tender No. 5484 is now attached to No. 4488 ''Union of South Africa''.

Models

In January 2020 Hornby Railways announced that it would be producing a model Hush Hush/W1 in both original and rebuilt forms in 00 gauge covering the locomotive's lifespan. These were original condition as No. 10000, original condition but with the ''British Enterprise'' nameplates that were cast but never used, original condition in LNER apple green as seen on collectible cards of the time, rebuilt LNER garter blue and rebuilt in BR green with early emblem as No. 60700. In January 2021 three more versions were announced, including original condition but with a double chimney as No. 10000, Rebuilt in LNER photographic grey, and rebuilt in BR with late crest as No. 60700. Previously the model was only available as a metal kit.

Notes

References

*
*
*
*
*
*

Literature

*
*

External links

LNER encyclopedia"Hush-Hush Locomotive has Streamline Boiler" ''Popular Mechanics'', March 1930

{{DEFAULTSORT:Lner Class W1
W1
4-6-4 locomotives
Streamlined steam locomotives
Compound locomotives
Individual locomotives of Great Britain
Experimental locomotives
High-pressure steam locomotives
Railway locomotives introduced in 1929
Scrapped locomotives
Unique locomotives
Standard gauge steam locomotives of Great Britain
Passenger locomotives