HOME

TheInfoList



OR:

The autoignition temperature or kindling point of a
substance Substance may refer to: * Matter, anything that has mass and takes up space Chemistry * Chemical substance, a material with a definite chemical composition * Drug substance ** Substance abuse, drug-related healthcare and social policy diagnosis ...
is the lowest
temperature Temperature is a physical quantity that expresses quantitatively the perceptions of hotness and coldness. Temperature is measured with a thermometer. Thermometers are calibrated in various temperature scales that historically have relied o ...
in which it spontaneously ignites in a normal atmosphere without an external source of ignition, such as a
flame A flame (from Latin ''flamma'') is the visible, gaseous part of a fire. It is caused by a highly exothermic chemical reaction taking place in a thin zone. When flames are hot enough to have ionized gaseous components of sufficient density they ...
or
spark Spark commonly refers to: * Spark (fire), a small glowing particle or ember * Electric spark, a form of electrical discharge Spark may also refer to: Places * Spark Point, a rocky point in the South Shetland Islands People * Spark (surname) * ...
. This temperature is required to supply the
activation energy In chemistry and physics, activation energy is the minimum amount of energy that must be provided for compounds to result in a chemical reaction. The activation energy (''E''a) of a reaction is measured in joules per mole (J/mol), kilojoules pe ...
needed for
combustion Combustion, or burning, is a high-temperature exothermic redox chemical reaction between a fuel (the reductant) and an oxidant, usually atmospheric oxygen, that produces oxidized, often gaseous products, in a mixture termed as smoke. Combusti ...
. The temperature at which a chemical ignites decreases as the
pressure Pressure (symbol: ''p'' or ''P'') is the force applied perpendicular to the surface of an object per unit area over which that force is distributed. Gauge pressure (also spelled ''gage'' pressure)The preferred spelling varies by country and e ...
is increased. *The ignition temperature of a substance is the lowest temperature at which the substance starts combustion. *Substances which spontaneously ignite in a normal atmosphere at naturally ambient temperatures are termed
pyrophoric A substance is pyrophoric (from grc-gre, πυροφόρος, , 'fire-bearing') if it ignites spontaneously in air at or below (for gases) or within 5 minutes after coming into contact with air (for liquids and solids). Examples are organolith ...
. Autoignition temperatures of liquid chemicals are typically measured using a flask placed in a temperature-controlled oven in accordance with the procedure described in
ASTM ASTM International, formerly known as American Society for Testing and Materials, is an international standards organization that develops and publishes voluntary consensus technical standards for a wide range of materials, products, systems, an ...
E659. When measured for
plastics Plastics are a wide range of synthetic polymers, synthetic or semi-synthetic materials that use polymers as a main ingredient. Their Plasticity (physics), plasticity makes it possible for plastics to be Injection moulding, moulded, Extrusion, e ...
, autoignition temperature can be also measured under elevated pressure and at 100% oxygen concentration. The resulting value is used as a predictor of viability for high-oxygen service. The main testing standard for this is ASTM G72.


Autoignition time equation

The time t_\text it takes for a material to reach its autoignition temperature T_\text when exposed to a
heat flux Heat flux or thermal flux, sometimes also referred to as ''heat flux density'', heat-flow density or ''heat flow rate intensity'' is a flow of energy per unit area per unit time. In SI its units are watts per square metre (W/m2). It has both a ...
q'' is given by the following equation: :t_\text = \frac k \rho c \left \frac \right2, where ''k'' =
thermal conductivity The thermal conductivity of a material is a measure of its ability to conduct heat. It is commonly denoted by k, \lambda, or \kappa. Heat transfer occurs at a lower rate in materials of low thermal conductivity than in materials of high thermal ...
, ''ρ'' = density, and ''c'' =
specific heat capacity In thermodynamics, the specific heat capacity (symbol ) of a substance is the heat capacity of a sample of the substance divided by the mass of the sample, also sometimes referred to as massic heat capacity. Informally, it is the amount of heat t ...
of the material of interest, T_0 is the initial temperature of the material (or the temperature of the bulk material).


Autoignition point of selected substances

Temperatures vary widely in the literature and should only be used as estimates. Factors that may cause variation include
partial pressure In a mixture of gases, each constituent gas has a partial pressure which is the notional pressure of that constituent gas as if it alone occupied the entire volume of the original mixture at the same temperature. The total pressure of an ideal gas ...
of oxygen, altitude, humidity, and amount of time required for ignition. Generally the autoignition temperature for hydrocarbon/air mixtures decreases with increasing
molecular mass The molecular mass (''m'') is the mass of a given molecule: it is measured in daltons (Da or u). Different molecules of the same compound may have different molecular masses because they contain different isotopes of an element. The related quanti ...
and increasing chain length. The autoignition temperature is also higher for branched-chain hydrocarbons than for straight-chain hydrocarbons.Zabetakis, M. G. (1965), Flammability characteristics of combustible gases and vapours, U.S. Department of Mines, Bulletin 627.


See also

*
Pyrolysis The pyrolysis (or devolatilization) process is the thermal decomposition of materials at elevated temperatures, often in an inert atmosphere. It involves a change of chemical composition. The word is coined from the Greek-derived elements ''py ...
*
Fire point The fire point of a fuel is the lowest temperature at which the vapour of that fuel will continue to burn for at least five seconds after ignition by an open flame of standard dimension. At the flash point, a lower temperature, a substance will ig ...
*
Flash point The flash point of a material is the "lowest liquid temperature at which, under certain standardized conditions, a liquid gives off vapours in a quantity such as to be capable of forming an ignitable vapour/air mixture". (EN 60079-10-1) The fl ...
*
Gas burner A gas burner is a device that produces a controlled flame by mixing a fuel gas such as acetylene, natural gas, or propane with an oxidizer such as the ambient air or supplied oxygen, and allowing for ignition and combustion. The flame is gen ...
(For flame temperatures, combustion heat energy values and ignition temperatures) *
Spontaneous combustion Spontaneous combustion or spontaneous ignition is a type of combustion which occurs by self-heating (increase in temperature due to exothermic internal reactions), followed by thermal runaway (self heating which rapidly accelerates to high tem ...


References


External links


Analysis of Effective Thermal Properties of Thermally Thick Materials
{{DEFAULTSORT:Autoignition Temperature Chemical properties Fire Threshold temperatures sv:Självantändning#Självantändningspunkt