Society of Automotive Engineers
SAE International, formerly named the Society of Automotive Engineers, is a United States-based, globally active professional association and standards developing organization for engineering professionals in various industries. SAE Internatio ...
standard SAE J1708 is a standard used for
serial communications
In telecommunication and data transmission, serial communication is the process of sending data one bit at a time, sequentially, over a communication channel or computer bus. This is in contrast to parallel communication, where several bits are ...
between
ECUs on a heavy duty vehicle and also between a computer and the vehicle. With respect to Open System Interconnection model (OSI), J1708 defines the
physical layer
In the seven-layer OSI model of computer networking, the physical layer or layer 1 is the first and lowest layer; The layer most closely associated with the physical connection between devices. This layer may be implemented by a PHY chip.
The ...
. Common higher layer protocols that operate on top of J1708 are SAE
J1587
Society of Automotive Engineers standard SAE J1587 is an automotive diagnostic protocol standard developed by the Society of Automotive Engineers (SAE) for heavy-duty and most medium-duty vehicles built after 1985. The J1587 protocol uses differen ...
and SAE
J1922
SAE protocol J1922 is a standard for "Powertrain Control Interface for Electronic Controls Used in Medium- and Heavy-Duty Diesel On-Highway Vehicle Applications" (published December 4, 2008). This SAE Recommended Practice provides a development o ...
. The protocol is maintained by
SAE International
SAE International, formerly named the Society of Automotive Engineers, is a United States-based, globally active professional association and standards developing organization for engineering professionals in various industries. SAE Internatio ...
.
Description
The standard defines a 2-wire 18
gauge
Gauge ( or ) may refer to:
Measurement
* Gauge (instrument), any of a variety of measuring instruments
* Gauge (firearms)
* Wire gauge, a measure of the size of a wire
** American wire gauge, a common measure of nonferrous wire diameter, es ...
wire cable that can run up to and operates at 9600 bit/s. A message is composed of up to 21 characters, unless the engine is stopped and the vehicle is not moving in which case transmitters are allowed to exceed the 21 byte max message length. Messages start with a Message ID (MID) character and finish with a
checksum
A checksum is a small-sized block of data derived from another block of digital data for the purpose of detecting errors that may have been introduced during its transmission or storage. By themselves, checksums are often used to verify data ...
at the end. Characters are transmitted in the common
8N1
8-N-1 is a common shorthand notation for a serial port parameter setting or computer configuration, configuration in Asynchronous start-stop, asynchronous mode, in which there is one start bit, eight (8) Bit, data bits, no (N) parity bit, and one ...
format.
The hardware utilized are
RS-485
RS-485, also known as TIA-485(-A) or EIA-485, is a standard defining the electrical characteristics of drivers and receivers for use in serial communications systems. Electrical signaling is balanced, and multipoint systems are supported. The st ...
transceivers wired for
open collector
An open collector is a common type of output found on many integrated circuits (IC), which behaves like a switch that is either connected to ground or disconnected. Instead of outputting a signal of a specific voltage or current, the output sig ...
operation through the use of a pullup and pulldown of the separate data lines. Transmission is accomplished by controlling the driver enable pin of the transceiver. This method allows multiple devices to share the bus without the need for a single master node.
Collisions
In physics, a collision is any event in which two or more bodies exert forces on each other in a relatively short time. Although the most common use of the word ''collision'' refers to incidents in which two or more objects collide with great f ...
are avoided by monitoring the bus while transmitting the MID to ensure that another node has not simultaneously transmitted a MID with a higher priority.
History
SAE J1708, although still widely used, is replaced by SAE
J1939
Society of Automotive Engineers standard SAE J1939 is the vehicle bus recommended practice used for communication and diagnostics among vehicle components. Originating in the car and heavy-duty truck industry in the United States, it is now widely ...
which is a
CAN
Can may refer to:
Containers
* Aluminum can
* Drink can
* Oil can
* Steel and tin cans
* Trash can
* Petrol can
* Metal can (disambiguation)
Music
* Can (band), West Germany, 1968
** ''Can'' (album), 1979
* Can (South Korean band)
Other
* C ...
protocol.
External links
TMC RP1210 Example Source Code5270ending
SAE International WebsiteApplication Note Explaining J1708 Implementation
{{List of Automation Protocols
Automotive standards