Profitronic VCR7501VPS - controller board - Philips TDA8341-93705

Intermediate-frequency (IF) amplifiers are

amplifier An amplifier, electronic amplifier or (informally) amp is an electronic device that can increase the magnitude of a signal (a time-varying voltage or current). It may increase the power significantly, or its main effect may be to boost the v ...

stages used to raise signal levels in radio and television receivers, at frequencies intermediate to the higher

radio-frequency Radio frequency (RF) is the oscillation rate of an alternating electric current or voltage or of a magnetic, electric or electromagnetic field or mechanical system in the frequency range from around to around . This is roughly between the upp ...

(RF) signal from the antenna and the lower (baseband) audio or video frequency that the receiver is recovering.

Uses

IF amplifiers in

heterodyne receiver A superheterodyne receiver, often shortened to superhet, is a type of radio receiver that uses frequency mixing to convert a received signal to a fixed intermediate frequency (IF) which can be more conveniently processed than the original car ...

s apply gain in a frequency band between the input

radio frequency Radio frequency (RF) is the oscillation rate of an alternating electric current or voltage or of a magnetic, electric or electromagnetic field or mechanical system in the frequency range from around to around . This is roughly between the upp ...

and output

audio frequency An audio frequency or audible frequency (AF) is a periodic vibration whose frequency is audible to the average human. The SI unit of frequency is the hertz (Hz). It is the property of sound that most determines pitch. The generally accepted ...

video frequency In broadcast television systems, VF bandwidth, video bandwidth or more formally video frequency bandwidth is the range of frequencies between 0 and the highest frequency used to transmit a live television image. The maximum frequency can be found ...

, often following one stage of

RF amplifier A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency signal into a higher-power signal. Typically, RF power amplifiers drive the antenna of a transmitter. Design goa ...

. This allows most of the gain in the form of a fixed-frequency amplifier, simplifying tuning. Compare to its predecessor, the

tuned RF receiver A tuned radio frequency receiver (or TRF receiver) is a type of radio receiver that is composed of one or more tuned radio frequency (RF) amplifier stages followed by a detector ( demodulator) circuit to extract the audio signal and usually ...

. IF amplifiers might use

double-tuned amplifier A double-tuned amplifier is a tuned amplifier with transformer coupling between the amplifier stages in which the inductances of both the primary and secondary windings are tuned separately with a capacitor across each. The scheme results in a w ...

s or

staggered tuning Staggered tuning is a technique used in the design of multi-stage tuned amplifiers whereby each stage is tuned to a slightly different frequency. In comparison to synchronous tuning (where each stage is tuned identically) it produces a wider Band ...

to generate the appropriate frequency response needed. Some use more than one IF frequency.

Commonly used circuits

* Mutual inductance coupling: contains two windings that are joined by mutual inductance. * Shunt capacitance coupling: These circuits have a wide pass band. * composite IF transformers: receivers used for A-M and F-M receivers.

References

External links

{{Commonscat-inline, IF amplifiers Electronic amplifiers