![Braun ABW41 (silber)](https://upload.wikimedia.org/wikipedia/commons/f/f2/Braun_ABW41_%28silber%29.jpg)
A clock face is the part of an
analog clock
A clock or a timepiece is a device used to measure and indicate time. The clock is one of the oldest human inventions, meeting the need to measure intervals of time shorter than the natural units such as the day, the lunar month and the ...
(or
watch
A watch is a portable timepiece intended to be carried or worn by a person. It is designed to keep a consistent movement despite the motions caused by the person's activities. A wristwatch is designed to be worn around the wrist, attached by ...
) that displays
time
Time is the continued sequence of existence and events that occurs in an apparently irreversible succession from the past, through the present, into the future. It is a component quantity of various measurements used to sequence events, to ...
through the use of a flat
dial with reference marks, and revolving pointers turning on concentric shafts at the center, called hands. In its most basic, globally recognized form, the periphery of the dial is numbered 1 through 12 indicating the hours in a 12-hour cycle, and a short hour hand makes two revolutions in a day. A long minute hand makes one
revolution
In political science, a revolution (Latin: ''revolutio'', "a turn around") is a fundamental and relatively sudden change in political power and political organization which occurs when the population revolts against the government, typically due ...
every hour. The face may also include a ''
second
The second (symbol: s) is the unit of time in the International System of Units (SI), historically defined as of a day – this factor derived from the division of the day first into 24 hours, then to 60 minutes and finally to 60 seconds ...
hand'', which makes one revolution per minute. The term is less commonly used for the time display on
digital clock
A digital clock is a type of clock that displays the time digitally (i.e. in numerals or other symbols), as opposed to an analogue clock.
Digital clocks are often associated with electronic drives, but the "digital" description refers only t ...
s and
watch
A watch is a portable timepiece intended to be carried or worn by a person. It is designed to keep a consistent movement despite the motions caused by the person's activities. A wristwatch is designed to be worn around the wrist, attached by ...
es.
A second type of clock face is the
24-hour analog dial
Clocks and watches with a 24-hour analog dial have an hour hand that makes one complete revolution, 360°, in a day (24 hours per revolution). The more familiar 12-hour analog dial has an hour hand that makes two complete revolutions in ...
, widely used in
military
A military, also known collectively as armed forces, is a heavily armed, highly organized force primarily intended for warfare. It is typically authorized and maintained by a sovereign state, with its members identifiable by their distinct ...
and other organizations that use
24-hour time. This is similar to the 12-hour dial above, except it has hours numbered 1–24 around the outside, and the hour hand makes only one revolution per day. Some special-purpose
clock
A clock or a timepiece is a device used to measure and indicate time. The clock is one of the oldest human inventions, meeting the need to measure intervals of time shorter than the natural units such as the day, the lunar month and the ...
s, such as
timer
A timer is a specialized type of clock used for measuring specific time intervals.
Timers can be categorized into two main types.
The word "timer" is usually reserved for devices that counts down from a specified time interval, while devices th ...
s and sporting event clocks, are designed for measuring periods less than one hour. Clocks can indicate the hour with
Roman numerals
Roman numerals are a numeral system that originated in ancient Rome and remained the usual way of writing numbers throughout Europe well into the Late Middle Ages. Numbers are written with combinations of letters from the Latin alphabet, eac ...
or
Hindu–Arabic numerals, or with non-numeric indicator marks. The two numbering systems have also been used in combination, with the prior indicating the hour and the latter the minute.
Longcase clock
A grandfather clock (also a longcase clock, tall-case clock, grandfather's clock, or floor clock) is a tall, freestanding, weight-driven pendulum clock with the pendulum held inside the tower or waist of the case. Clocks of this style are common ...
s (grandfather clocks) typically use Roman numerals for the hours. Clocks using only Arabic numerals first began to appear in the mid-18th century.
The clock face is so familiar that the numbers are often omitted and replaced with unlabeled
graduation
Graduation is the awarding of a diploma to a student by an educational institution. It may also refer to the ceremony that is associated with it. The date of the graduation ceremony is often called graduation day. The graduation ceremony is a ...
s (marks), particularly in the case of watches. Occasionally, markings of any sort are dispensed with, and the time is read by the angles of the hands.
Reading a modern clock face
![1214Clock](https://upload.wikimedia.org/wikipedia/commons/f/f8/1214Clock.svg)
Most modern clocks have the numbers 1 through 12 printed at equally spaced intervals around the periphery of the face with the 12 at the top, indicating the hour, and on many models, sixty dots or lines evenly spaced in a ring around the outside of the dial, indicating minutes and seconds. The time is read by observing the placement of several "hands", which emanate from the centre of the dial:
*A short, thick "hour" hand;
*A long, thinner "minute" hand;
*On some models, a very thin "second" or "sweep" hand
All three hands continuously rotate around the dial in a
clockwise
Two-dimensional rotation can occur in two possible directions. Clockwise motion (abbreviated CW) proceeds in the same direction as a clock's hands: from the top to the right, then down and then to the left, and back up to the top. The opposite ...
direction – in the direction of increasing numbers.
*The second, or sweep, hand moves relatively quickly, taking a full minute (sixty seconds) to make a complete rotation from 12 to 12. For every rotation of the second hand, the minute hand will move from one minute mark to the next.
*The minute hand rotates more slowly around the dial. It takes one hour (sixty minutes) to make a complete rotation from 12 to 12. For every rotation of the minute hand, the hour hand will move from one hour mark to the next.
*The hour hand moves slowest of all, taking twelve hours (half a day) to make a complete rotation. It starts from "12" at midnight, makes one rotation until it is pointing at "12" again at noon, and then makes another rotation until it is pointing at "12" again at midnight of the next morning.
Historical development
![Gdańsk Bazylika Mariacka (zegar astronomiczny)](https://upload.wikimedia.org/wikipedia/commons/7/7d/Gda%C5%84sk_Bazylika_Mariacka_%28zegar_astronomiczny%29.jpg)
The word ''clock'' derives from the medieval
Latin
Latin (, or , ) is a classical language belonging to the Italic branch of the Indo-European languages. Latin was originally a dialect spoken in the lower Tiber area (then known as Latium) around present-day Rome, but through the power of the ...
word for "bell"; ''clocca'', and has
cognate
In historical linguistics, cognates or lexical cognates are sets of words in different languages that have been inherited in direct descent from an etymology, etymological ancestor in a proto-language, common parent language. Because language c ...
s in many European languages. Clocks spread to England from the
Low Countries
The term Low Countries, also known as the Low Lands ( nl, de Lage Landen, french: les Pays-Bas, lb, déi Niddereg Lännereien) and historically called the Netherlands ( nl, de Nederlanden), Flanders, or Belgica, is a coastal lowland region in N ...
,
so the English word came from the Middle Low German and Middle Dutch ''Klocke''.
The first mechanical clocks, built in 13th-century Europe, were
striking clocks: their purpose was to ring bells upon the
canonical hours, to call the local community to prayer. These were
tower clock
Clock towers are a specific type of structure which house a turret clock and have one or more clock faces on the upper exterior walls. Many clock towers are freestanding structures but they can also adjoin or be located on top of another buildi ...
s installed in
bell tower
A bell tower is a tower that contains one or more bells, or that is designed to hold bells even if it has none. Such a tower commonly serves as part of a Christian church, and will contain church bells, but there are also many secular bell tower ...
s in public places, to ensure that the bells were audible over a wide area. Soon after these first mechanical clocks were in place clockmakers realized that their wheels could be used to drive an indicator on a dial on the outside of the tower, where it could be widely seen, so the local population could tell the time between the hourly strikes.
Before the late 14th century, a fixed hand (often a carving literally shaped like a hand) indicated the hour by pointing to numbers on a rotating dial; after this time, the current
convention of a rotating hand on a fixed dial was adopted. Minute hands (so named because they indicated the small, or ''minute'', divisions of the hour) only came into regular use around 1690, after the invention of the
pendulum
A pendulum is a weight suspended from a pivot so that it can swing freely. When a pendulum is displaced sideways from its resting, equilibrium position, it is subject to a restoring force due to gravity that will accelerate it back toward the ...
and
anchor escapement
In horology, the anchor escapement is a type of escapement used in pendulum clocks. The escapement is a mechanism in a mechanical clock that maintains the swing of the pendulum by giving it a small push each swing, and allows the clock's wheels ...
increased the precision of time-telling enough to justify it.
In some precision clocks, a third hand, which rotated once a minute, was added in a separate subdial. This was called the "second-minute" hand (because it measured the ''secondary minute'' divisions of the hour), which was shortened to "second" hand.
The convention of the hands moving
clockwise
Two-dimensional rotation can occur in two possible directions. Clockwise motion (abbreviated CW) proceeds in the same direction as a clock's hands: from the top to the right, then down and then to the left, and back up to the top. The opposite ...
evolved in imitation of the
sundial
A sundial is a horological device that tells the time of day (referred to as civil time in modern usage) when direct sunlight shines by the apparent position of the Sun in the sky. In the narrowest sense of the word, it consists of a flat ...
. In the Northern hemisphere, where the clock face originated, the shadow of the
gnomon on a horizontal sundial moves clockwise during the day.
French decimal time
![Clock-french-republic](https://upload.wikimedia.org/wikipedia/commons/2/2f/Clock-french-republic.jpg)
During the
French Revolution
The French Revolution ( ) was a period of radical political and societal change in France that began with the Estates General of 1789 and ended with the formation of the French Consulate in November 1799. Many of its ideas are considere ...
in 1793, in connection with its
Republican calendar, France attempted to introduce a decimal time system. This had 10 decimal hours in the day, 100 decimal minutes per hour, and 100 decimal seconds per minute. Therefore, the decimal hour was more than twice as long (144 min) as the present hour, the decimal minute was slightly longer than the present minute (86 seconds) and the decimal second was slightly shorter (0.86 sec) than the present second. Clocks were manufactured with this alternate face, usually combined with traditional hour markings. However, it did not catch on, and France discontinued the mandatory use of decimal time on 7 April 1795, although some French cities used decimal time until 1801.
Stylistic development
![Rew17h09 1978](https://upload.wikimedia.org/wikipedia/commons/e/e9/Rew17h09_1978.jpg)
Until the last quarter of the 17th century, hour markings were etched into metal faces and the recesses filled with black wax. Subsequently, higher contrast and improved readability was achieved with white enamel plaques painted with black numbers. Initially, the numbers were printed on small, individual plaques mounted on a brass substructure. This was not a stylistic decision, rather
enamel production technology had not yet achieved the ability to create large pieces of enamel. The "13-piece face" was an early attempt to create an entirely white enamel face. As the name suggests, it was composed of 13 enamel plaques: 12 numbered wedges fitted around a circle. The first single-piece enamel faces, not unlike those in production today, began to appear .
It is customary for modern advertisements to display clocks and watches set to approximately 10:10 or 1:50,
as this V-shaped arrangement roughly makes a smile, imitates a human figure with raised arms, and leaves the watch company's logo unobscured by the hands.
In the 1970s, German designer Tian Harlan invented the
Chromachron, a wristwatch with a clock face that has no dials but a disc with pie-shaped pattern rotating by the minute over color patterns representing both hours and minutes.
Technological obsolescence
In the 2010s, some
United Kingdom
The United Kingdom of Great Britain and Northern Ireland, commonly known as the United Kingdom (UK) or Britain, is a country in Europe, off the north-western coast of the continental mainland. It comprises England, Scotland, Wales and North ...
schools started replacing analogue clocks in examination halls with
digital clock
A digital clock is a type of clock that displays the time digitally (i.e. in numerals or other symbols), as opposed to an analogue clock.
Digital clocks are often associated with electronic drives, but the "digital" description refers only t ...
s because an increasing number of pupils were unable to read analogue clocks. Smartphone and computer clocks are often digital rather than analogue, and proponents of replacing analogue clock faces argue that they have become technologically obsolete. However, reading analogue clocks is still part of American elementary school curricula; proponents of analogue clocks argue that their inclusion in the curriculum reinforces basic mathematical concepts that are taught in elementary school.
See also
*
List of largest clock faces
A list of permanent working clocks with the largest faces in the world. Entries include all clocks with faces at least in diameter. Clocks can be located on the exterior or interior of buildings, and towers as well as on the ground as is the case ...
*
Clock position
A clock position, or clock bearing, is the direction of an object observed from a vehicle, typically a vessel or an aircraft, relative to the orientation of the vehicle to the observer. The vehicle must be considered to have a front, a back, a ...
*
Roman numerals
Roman numerals are a numeral system that originated in ancient Rome and remained the usual way of writing numbers throughout Europe well into the Late Middle Ages. Numbers are written with combinations of letters from the Latin alphabet, eac ...
Footnotes
{{DEFAULTSORT:Clock Face
Timekeeping components