Traditional systems
In traditional systems over-pressure is dealt with through relief systems. A relief system will open an alternative outlet for the fluids in the system once a set pressure is exceeded, to avoid further build-up of pressure in the protected system. This alternative outlet generally leads to aAdvantages of HIPPS
HIPPS provides a solution to protect equipment in cases where: *high-pressures and / or flow rates are processed *the environment is to be protected *the economic viability of a development needs improvement *the risk profile of the plant must be reduced HIPPS is an instrumented safety system that is designed and built in accordance with theComponents of HIPPS
A system that closes the source of over-pressure within a specified time with at least the same reliability as a safety relief valve is usually called a HIPPS. Such a HIPPS is a complete functional loop consisting of: *sensors, (or initiators) that detect the high pressure *a logic solver, which processes the input from the sensors to an output to the final element *final elements, that actually perform the corrective action in the field by bringing the process to a safe state. In case of a HIPPS this means shutting off the source of overpressure. The final element consists of a valve, actuator and solenoids.Diagram
The scheme above presents three pressure transmitters (PT) connected to a logic solver. The solver will decide based on 2-out-of-3 ( 2oo3) voting whether or not to activate the final element. the 1oo2 solenoid panel decides which valve to be closed. The final elements consist here of two block valves that stop flow to the downstream facilities (right) to prevent them from exceeding a maximum pressure. The operator of the plant is warned through a pressure alarm (PA) that the HIPPS was activated. This system has a high degree of redundancy: *failure of one of the three pressure transmitters will not compromise the HIPPS functionality, as two readings of high pressure are needed for activation. *failure of one of the two block valves will not compromise the HIPPS functionality, as the other valve will close on activation of the HIPPS. One must not confine self to the above design as the only means of materializing the HIPPS definition. One must always think of the HIPPS generically, as a means of isolating a source of a high pressure when down stream flow have been blocked, isolating the upstream equipment (source of the high pressure) in a highly reliable manner. Be this source of the high pressure a pump (in case of liquid) or a gas compressor (in case of gas), the aim of the HIPPS in these cases is to reliably shut down the pump or the gas compressor creating the high pressure condition in a reliable and safe manner.Standards and design practices
The ever-increasing flow rates in combination with the environmental constraints initiated the widespread and rapid acceptance in the last decades of HIPPS as the ultimate protection system. The International Electrotechnical Commission (IEC) has introduced theExternal links