field-programmable analog array

A field-programmable analog array (FPAA) is an integrated circuit device containing computational analog blocks (CABs) and interconnects between these blocks offering field-programmability. Unlike their digital cousin, the FPGA, the devices tend to be more application driven than general purpose as they may be current mode or voltage mode devices. For voltage mode devices, each block usually contains an operational amplifier in combination with programmable configuration of passive components. The blocks can, for example, act as summers or integrators.

FPAAs usually operate in one of two modes: ''continuous time'' and ''discrete time''.
*''Discrete-time devices'' possess a system sample clock. In a switched capacitor design, all blocks sample their input signals with a sample and hold circuit composed of a semiconductor switch and a capacitor. This feeds a programmable op amp section which can be routed to a number of other blocks. This design requires more complex semiconductor construction. An alternative, switched-current design, offers simpler construction and does not require the input capacitor, but can be less accurate, and has lower fan-out - it can drive only one following block. Both discrete-time device types must compensate for switching noise, aliasing at the system sample rate, and sample-rate limited bandwidth, during the design phase.
*''Continuous-time devices'' work more like an array of transistors or op amps which can operate at their full bandwidth. The components are connected in a particular arrangement through a configurable array of switches. During circuit design, the switch matrix's parasitic inductance, capacitance and noise contributions must be taken into account.

Currently there are very few manufactures of FPAAs. On-chip resources are still very limited when compared to that of an FPGA. This resource deficit is often cited by researchers as a limiting factor in their research.

History

The term ''FPAA'' was first used in 1991 by Lee and Gulak. They put forward the concept of CABs that are connected via a routing network and configured digitally. Subsequently, in 1992 and 1995 they further elaborated the concept with the inclusion of op-amps, capacitors, and resistors. This original chip was manufactured using 1.2 μm CMOS technology and operates in the 20 kHz range at a power consumption of 80 mW.

However, the concept of a user-definable analog array dates back 20 years earlier, to the mask-programmable analog "Monochip" invented by the designer of the famous 555 timer chip, Hans Camenzind, and his company Interdesign (later acquired by Ferranti in 1977). The Monochip was the basis for a pioneering line of chips for music synthesizers, sold by Curtis Electromusic (CEM).

Pierzchala et al introduced a similar concept named electronically-programmable analog circuit (EPAC). It featured only a single integrator. However, they proposed a local interconnect architecture in order to try to avoid the bandwidth limitations.

The reconfigurable analog signal processor (RASP) and a second version were introduced in 2002 by Hall et al. Their design incorporated high-level elements such as second order bandpass filters and 4 by 4 vector matrix multipliers into the CABs. Because of its architecture, it is limited to around 100 kHz and the chip itself is not able to support independent reconfiguration.

In 2004 Joachim Becker picked up the parallel connection of OTAs (operational transconductance amplifiers) and proposed its use in a hexagonal local interconnection architecture. It did not require a routing network and eliminated switching the signal path that enhances the frequency response.

In 2005 Fabian Henrici worked with Joachim Becker to develop a switchable and invertible OTA which doubled the maximum FPAA bandwidth. This collaboration resulted in the first manufactured FPAA in a 0.13 μm CMOS technology.

In 2016 Dr. Jennifer Hasler from Georgia Tech designed a FPAA system on a chip that uses analog technology to achieve unprecedented power and size reductions.

See also

* Field-programmable RF – field programmable radio frequency devices
* Complex programmable logic device (CPLD)
* PSoC – programmable system-on-chip
* NoC – network on a chip
* Network architecture

References

External links

"Analog's Answer to FPGA Opens Field to Masses"
Sunny Bains, ''EE Times'', February 21, 2008. Issue 1510.


Tim Edwards, Johns Hopkins University project, 1999.

"Field programmable analog arrays"
Joachim Becker, et al., University of Freiburg, Department of Microsystems Engineering. Hex FPAA Research Project.


Field programmable analog arrays (FPAAs) from Anadigm

"Integrated Computational Electronics (ICE) Laboratory"
Georgia Institute of Technology Project

{{DEFAULTSORT:Field-Programmable Analog Array
Gate arrays
Analog circuits
Signal processing
Integrated circuits