Clubman Sports 1300
   HOME

TheInfoList



OR:

The Australian Clubman, later known as Sports 1300 class catered for small capacity front engine rear wheel drive sportscars initially similar to the road going sports cars such as the
Lotus 7 The Lotus Seven is a small, simple, lightweight, two-seater, open-top, open-wheel, sports car produced by the British manufacturer Lotus Cars (initially called Lotus Engineering) between 1957 and 1972. It was designed by Lotus founder Colin Cha ...
and to other Clubman series internationally. These cars were simple two seat cars based on widely available road car components in a purpose-built
space frame In architecture and structural engineering, a space frame or space structure ( 3D truss) is a rigid, lightweight, truss-like structure constructed from interlocking struts in a geometric pattern. Space frames can be used to span large areas with ...
chassis and simple bodywork using cycle guards over the front wheels. The basic features of these cars were * Front engine
Hotchkiss drive The Hotchkiss drive is a shaft drive form of power transmission. It was the dominant means for front-engine, rear-wheel drive layout cars in the 20th century. The name comes from the French automobile manufacturer Hotchkiss, although other makers, ...
*
Live axle A beam axle, rigid axle or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically they have als ...
rear with open differential * Basic bodywork with front cycle guards * Engine and transmission modifications limited These cars represented great bang for your buck and could even keep up with
Australian Formula 3 Australian Formula 3 has been the name applied to two distinctly different motor racing categories, separated by over twenty years. The original Australian Formula 3 was introduced in 1964 based on the FIA Formula 3 of the period and intended ...
cars in the 1970s when both classes ran similar engines while being much cheaper.


History

Clubman racing in Australia dates back to the 1950s but didn't emerge as a distinct category with its own set of rules separate to other sportscars until the 60's. at this point an engine capacity limit of 1100cc was introduced. However, alongside this class were 1500cc cars of a similar design and construction that would run alongside the 1100cc cars as invited sportscars. These cars were not technically clubman class cars although very similar and because of that they had to run to Group A Sports Cars regulations. This meant they had to run doors for example, as opposed to the clubman cars which just had a cut-out to allow access. The Confederation of Australian Motorsport, who ran Motorsport in Australia, decided to change the capacity of the open wheel classes to 1300cc and 1600cc for
Australian Formula 3 Australian Formula 3 has been the name applied to two distinctly different motor racing categories, separated by over twenty years. The original Australian Formula 3 was introduced in 1964 based on the FIA Formula 3 of the period and intended ...
and
Australian Formula 2 Australian Formula 2, sometimes abbreviated to AF2 or ANF2, is a "wings and slicks" formula racing category in Australia. The category is one of Australia's oldest, dating back to 1964. The current format of AF2 was introduced in 1978. Brian Shea ...
respectively and with that the clubman class was changed to 1300cc to mirror the F3 car engine regulations. These regulations specified an engine of no more than 1.3 litres, single camshaft engine of production car origin. These new 1300cc engines were mainly sourced from Japanese manufacturers such as Datsun and Toyota. These engines outshone the older style 1500cc cars and these became less popular. The class went through distinct but overlapping periods where new ideas on design or rule changes lead to new directions in car design. Initially clubman style cars looked very similar to their road going counterparts such as the
Lotus 7 The Lotus Seven is a small, simple, lightweight, two-seater, open-top, open-wheel, sports car produced by the British manufacturer Lotus Cars (initially called Lotus Engineering) between 1957 and 1972. It was designed by Lotus founder Colin Cha ...
. This was followed by lower cars that were potentially more aerodynamic but probably just reflected a lower centre of gravity. These cars though were still very similar to their road going cousins with no attempt at gaining aerodynamic downforce being attempted or allowed by the rules. This period was replaced by cars that began to use upswept tails and full width sportscar noses to create more aerodynamic cars capable of producing some level of downforce. The final stage of this evolution before the class morphed into the
Supersports Supersports is an Australian motor racing class designed as a relatively cheap class of sports racing car. While looking like international sports cars the vehicles themselves are smaller and lighter. Engines are liquid-cooled, four stroke, natural ...
category was the addition of wings first allowed in the early 2000s. At about this time there was a change to engines too with the twin cam Suzuki G13B engine being allowed into the category.


References

{{Class of Auto racing Sports car racing Racing car classes Sports cars