Centro De Estudos Aeronáuticos Da Universidade Federal De Minas Gerais
   HOME

TheInfoList



OR:

Centro de Estudos Aeronáuticos da Universidade Federal de Minas Gerais (''in English: The Center for Aeronautical Studies'') or simply CEA, is a Brazilian research organization part of the Department of Mechanical Engineering of the School of Engineering at the Federal University of Minas Gerais. It is similar to the
Akaflieg Akaflieg is an abbreviation for ''Akademische Fliegergruppe'', groups of aeronautical engineering students from individual German Technical Universities, pre and postwar, who design aircraft, often gliders. History Otto Lilienthal published his bo ...
s of German Universities in that students make designs with advice from staff to give practical experience before seeking employment.


History

The first project came in 1964 with the creation of the CB-1 basic instruction single-seat glider “Gaivota”. The Gaivota was a basic instruction
glider Glider may refer to: Aircraft and transport Aircraft * Glider (aircraft), heavier-than-air aircraft primarily intended for unpowered flight ** Glider (sailplane), a rigid-winged glider aircraft with an undercarriage, used in the sport of glidin ...
, built in wood, from a simple project developed by the recently graduated engineer Cláudio de Barros. The whole project of this glider was developed with the help of the boo
''L'aliante''
by the Italian engineer
Stelio Frati Stelio Frati (born in Milan Italy in 1919, died 14 May 2010) was an Italian mechanical engineer and aeroplane designer. He graduated from the Politecnico of Milan as a mechanical engineer in 1943, participating in the design of the Aeronautica Lom ...
, which until today shows its influences in the projects developed in this center. After the success of the Gaivota, in 1969, the project for the CB-2 “Minuano” high-performance glider was started. Looking for equality with the machines that were being developed abroad, the then professor Cláudio de Barros, managed to design an aircraft that until today presents the highest aerodynamic performance of aircraft manufactured in the country. Built by José de Carvalho e Silva, the Minuano incorporated the most modern construction techniques at the time, such as metal-to-metal gluing, wood-to-metal gluing, and sandwich lining of plywood-cellulose acetate honeycomb. Its first flight was in December 1975. In 1980 the RPR-1 "Jegue" a single-seat glider of the "self-launched" category was designed. The first prototype still under construction was destroyed by flooding that inundated the workshops of the Center for Aeronautical Studies. In 1985 the development of the CB-7 "Vesper" biplace motor-glider began. This high performance aircraft was the first fully developed (national design, calculation and construction) in composite materials in the country. This project received support from the German aeronautical authorities (DLR). The first flight of the Vesper was in 1988. Today the prototype is available to the Center for Aeronautical Studies for research flights and flight tests. Between 1989 and 1992 the state-of-the-art CB-9 "Curumim" ultralight aircraft was developed - the "Curumim" successfully flew in 1993. Currently, with more than 150 flight hours and over 600 landings, the Curumim has served as an excellent in-flight laboratory for testing new equipment and for initiating the Center for Aeronautical Studies' students in the practice of flight testing.


Wind Tunnels

;Subsonic Wind Tunnel - CEA-WT1 :Wind tunnel designed and developed at the UFMG's Center for Aeronautical Studies with the purpose of supporting research activities in flight testing, especially sensor calibration, as well as supporting the teaching of applied aerodynamics at undergraduate and graduate levels. The construction of the tunnel was entirely done in the workshops of the Aeronautical Studies Center in 2005. ;CEA-WT2 Subsonic Wind Tunnel :Closed-circuit wind tunnel for research and product development, was funded by FAPEMIG through its call for large equipment acquisition. It will have two test sections with 1.2x1.0x3.2m and 2.4x2.4x2.0m, with respective speeds of 120m/s and 40m/s. It is driven by an electronically controlled 385hp electric motor. Its construction is in its final stage of execution and the civil work for its installation is already being finished. The forecast for inauguration is December 2011.


Minas Gerais Facilities

The UFMG Aeronautical Studies Center Hangar is located in Conselheiro Lafaiete, 96 km from
Belo Horizonte Belo Horizonte (, ; ) is the sixth-largest city in Brazil, with a population around 2.7 million and with a metropolitan area of 6 million people. It is the 13th-largest city in South America and the 18th-largest in the Americas. The metropol ...
. It has a hangar area of .


Aircraft


See also

*
Advanced Composites Solutions Advanced Composites Solutions, commonly shortened to ACS is an engineering company specialized in composite materials technology, mainly their application to the development and construction of light aircraft. History Founded by professionals wi ...


References


External links


University homepage
{{Education in South America Aircraft manufacturers of Brazil Glider manufacturers Vehicle manufacturing companies established in 1964 1964 establishments in Brazil Educational institutions established in 1964