Blood Alcohol Content

Blood alcohol content (BAC), also called blood alcohol concentration or blood alcohol level, is a measurement of alcohol intoxication used for legal or medical purposes.

BAC is expressed as mass of alcohol per volume of blood. In the US and many international publications, BAC levels are written as a percentage such as 0.08%, meaning that there is 0.08 g of alcohol for every 100 of blood. In different countries, the maximum permitted BAC when driving ranges from the limit of detection ( zero tolerance) to 0.08%. BAC levels above 0.40% are potentially fatal.

Units of measurement

BAC is generally defined as a fraction of weight of alcohol per volume of blood, with an SI coherent derived unit of kg/m³ or equivalently grams per liter (g/L). Countries differ in how this quantity is normally expressed. Common formats are listed in the table below. For example, the US and many international publications present BAC as a percentage, such as 0.05%. This would be interpreted as 0.05 grams per deciliter of blood. This same concentration could be expressed as 0.5‰ or 50 mg% in other countries.

It is also possible to use other units. For example, in the 1930s Widmark measured alcohol and blood by mass, and thus reported his concentrations in units of g/kg or mg/g, weight alcohol per weight blood. Blood is denser than water and 1 mL of blood has a mass of approximately 1.055 grams, thus a mass-volume BAC of 1 g/L corresponds to a mass-mass BAC of 0.948 mg/g. Sweden, Denmark, Norway, Finland, Germany, and Switzerland use mass-mass concentrations in their laws, but this distinction is often skipped over in public materials, implicitly assuming that 1 L of blood weighs 1 kg.

In pharmacokinetics, it is common to use the amount of substance, in moles, to quantify the dose. As the molar mass of ethanol is 46.07 g/mol, a BAC of 1 g/L is 21.706 mmol/L (21.706 mM).

Effects by alcohol level

The magnitude of sensory impairment may vary in people of differing weights. The NIAAA defines the term "binge drinking" as a pattern of drinking that brings a person's blood alcohol concentration (BAC) to 0.08 grams percent or above."Quick Stats: Binge Drinking." The Centers for Disease Control and Prevention. April 200

Estimation

Direct measurement

Blood samples for BAC analysis are typically obtained by taking a venous blood sample from the arm. A variety of methods exist for determining blood-alcohol concentration in a blood sample. Forensic laboratories typically use Headspace gas chromatography for dissolved gas measurement, headspace-gas chromatography combined with mass spectrometry or flame ionization detection, as this method is accurate and efficient. Hospitals typically use enzyme multiplied immunoassay technique, enzyme multiplied immunoassay, which measures the co-enzyme NADH. This method is more subject to error but may be performed rapidly in parallel with other blood sample measurements.

In Germany, BAC is determined by measuring the serum level and then converting to whole blood by dividing by the factor 1.236. This calculation underestimates BAC by 4% to 10% compared to other methods.

By breathalyzer

The amount of alcohol on the breath can be measured, without requiring drawing blood, by blowing into a breathalyzer, resulting in a breath alcohol content (BrAC). The BrAC specifically correlates with the concentration of alcohol in arterial blood, satisfying the equation . Its correlation with the standard BAC found by drawing venous blood is less strong. Jurisdictions vary in the statutory conversion factor from BrAC to BAC, from 2000 to 2400. Many factors may affect the accuracy of a breathalyzer test, but they are the most common method for measuring alcohol concentrations in most jurisdictions.

By intake

Blood alcohol content can be quickly estimated by a model developed by Swedish professor Erik Widmark in the 1920s. The model corresponds to a pharmacokinetic single-compartment model with instantaneous absorption and zero-order kinetics for elimination. The model is most accurate when used to estimate BAC a few hours after drinking a single dose of alcohol in a fasted state, and can be within 20% Coefficient of variation, CV of the true value. It is not at all realistic for the absorption phase, and is not accurate for BAC levels below 0.2 g/L (alcohol is not eliminated as quickly as predicted) and consumption with food (overestimating the peak BAC and time to return to zero). The equation varies depending on the units and approximations used, but in its simplest form is given by:
:$EBAC = \frac-\beta\times T$
where:
* is the estimated blood alcohol concentration (in g/L)
* is the mass of alcohol consumed (g).
* is the amount time during which alcohol was present in the blood (usually time since consumption began), in hours.
* is the rate at which alcohol is Elimination (pharmacology), eliminated, averaging around 0.15 g/L/hr.
* is the volume of distribution (L); typically body weight (kg) multiplied by 0.71 L/kg for men and 0.58 L/kg for women although estimation using TBW is more accurate.

A standard drink, defined by the WHO as 10 grams of pure alcohol, is the Standard_drink#Definitions_in_various_countries, most frequently used measure in many countries. Examples:
* A 80 kg man drinks 20 grams ethanol. After one hour:
$EBAC = 20/(0.71 \cdot 80) - (0.148 \cdot 1) \approx 0.204 \text = 0.0204% \text$
* A 70 kg woman drinks 10 grams ethanol. After one hour:
$EBAC = 10/(0.58 \cdot 70) - (0.156 \cdot 1) \approx 0.098 \text = 0.0098% \text$

In terms of fluid ounces of alcohol consumed and weight in pounds, Widmark's formula can be simply approximated as
:$EBAC=8\times\text/\text-\beta\times T$
for a man or
:$EBAC=10\times\text/\text-\beta\times T$
for a woman, where EBAC and factors are given as g/dL (% BAC), such as a factor of 0.015% BAC per hour.

By standard drinks

The examples above define a standard drink as 0.6 fluid ounces (14 g or 17.7 mL) of ethanol, whereas other definitions exist, for example 10 grams of ethanol.

By training

If individuals are asked to estimate their BAC, then given accurate feedback via a breathalyzer, and this procedure is repeated a number of times during a drinking session, studies show that these individuals can learn to discriminate their BAC, to within a mean error of 9 mg/100 mL (0.009% BAC). The ability is robust to different types of alcohol, different drink quantities, and drinks with unknown levels of alcohol. Trained individuals can even drink alcoholic drinks so as to adjust or maintain their BAC at a desired level. Training the ability does not appear to require any information or procedure besides breathalyzer feedback, although most studies have provided information such as intoxication symptoms at different BAC levels. Subjects continue to retain the ability one month after training.

Post-mortem

After fatal accidents, it is common to check the blood alcohol levels of involved persons. However, soon after death, the body begins to Putrefaction, putrefy, a biological process which produces ethanol. This can make it difficult to conclusively determine the blood alcohol content in autopsies, particularly in bodies recovered from water. For instance, following the 1975 Moorgate tube crash, the driver's kidneys had a blood alcohol concentration of 80 mg/100 mL, but it could not be established how much of this could be attributed to natural decomposition. Newer research has shown that vitreous (eye) fluid provides an accurate estimate of blood alcohol concentration that is less subject to the effects of decomposition or contamination.

Legal limits

For purposes of law enforcement, blood alcohol content is used to define intoxication and provides a rough measure of impairment. Although the degree of impairment may vary among individuals with the same blood alcohol content, it can be measured objectively and is therefore legally useful and difficult to contest in court. Most countries forbid operation of motor vehicles and heavy machinery above prescribed levels of blood alcohol content. Operation of boats and aircraft is also regulated. Some jurisdictions also regulate bicycling under the influence. The alcohol level at which a person is considered legally impaired to drive varies by country.

Test assumptions

Extrapolation

Retrograde extrapolation is the mathematical process by which someone's blood alcohol concentration at the time of driving is estimated by projecting backwards from a later chemical test. This involves estimating the absorption and elimination of alcohol in the interim between driving and testing. The rate of elimination in the average person is commonly estimated at 0.015 to 0.020 grams per deciliter per hour (g/dL/h), although again this can vary from person to person and in a given person from one moment to another. Metabolism can be affected by numerous factors, including such things as body temperature, the type of alcoholic beverage consumed, and the amount and type of food consumed.

In an increasing number of states, laws have been enacted to facilitate this speculative task: the blood alcohol content at the time of driving is legally presumed to be the same as when later tested. There are usually time limits put on this presumption, commonly two or three hours, and the defendant is permitted to offer evidence to rebut this presumption.

Forward extrapolation can also be attempted. If the amount of alcohol consumed is known, along with such variables as the weight and sex of the subject and period and rate of consumption, the blood alcohol level can be estimated by extrapolating forward. Although subject to the same infirmities as retrograde extrapolation—guessing based upon averages and unknown variables—this can be relevant in estimating BAC when driving and/or corroborating or contradicting the results of a later chemical test.

Metabolism

The pharmacokinetics of ethanol are well characterized by the ADME acronym (absorption, distribution, metabolism, excretion). Besides the dose ingested, factors such as the person's total body water, speed of drinking, the drink's nutritional content, and the contents of the stomach all influence the profile of blood alcohol content (BAC) over time. Breath alcohol content (BrAC) and BAC have similar profile shapes, so most forensic pharmacokinetic calculations can be done with either. Relatively few studies directly compare BrAC and BAC within subjects and characterize the difference in pharmacokinetic parameters. Comparing arterial and venous BAC, arterial BAC is higher during the absorption phase and lower in the postabsorptive declining phase.

Highest levels

There have been reported cases of blood alcohol content higher than 1%:

* In 1982, a 24-year-old woman was admitted to the UCLA emergency room with a serum alcohol content of 1.51%, corresponding to a blood alcohol content of 1.33%. She was alert and oriented to person and place and survived. Serum alcohol concentration is not equal to nor calculated in the same way as blood alcohol content.
* In 1984, a 30-year-old man survived a blood alcohol concentration of 1.5% after vigorous medical intervention that included Kidney dialysis, dialysis and intravenous therapy with fructose.
* In 1995, a man from Wrocław, Poland, caused a car accident near his hometown. He had a blood alcohol content of 1.48%; he was tested five times, with each test returning the same reading. He died a few days later of injuries from the accident.
* In 2004, an unidentified Taiwanese woman died of alcohol intoxication after immersion for twelve hours in a bathtub filled with 40% ethanol. Her blood alcohol content was 1.35%. It was believed that she had immersed herself as a response to the Severe acute respiratory syndrome, SARS epidemic.
* In South Africa, a man driving a Mercedes-Benz Vito light van containing 15 sheep allegedly stolen from nearby farms was arrested on December 22, 2010, near Queenstown, Eastern Cape, Queenstown in Eastern Cape. His blood had an alcohol content of 1.6%. Also in the vehicle were five boys and a woman, who were also arrested.
* On 26 October 2012, a man from Gmina Olszewo-Borki, Poland, who died in a car accident, recorded a blood alcohol content of 2.23%; however, the blood sample was collected from a wound and thus possibly contaminated.
* On 26 July 2013 a 30-year-old man from Alfredówka, Poland, was found by Municipal Police Patrol from Nowa Dęba lying in the ditch along the road in Tarnowska Wola. At the hospital, it was recorded that the man had a blood alcohol content of 1.374%. The man survived.

Notes

References

Citations

General and cited references

* Carnegie Library of Pittsburgh. Science and Technology Department. ''The Handy Science Answer Book''. Pittsburgh: The Carnegie Library, 1997. .
*
* Taylor, L., and S. Oberman. ''Drunk Driving Defense'', 6th edition. New York: Aspen Law and Business, 2006. .

External links

Estimated alcohol

{{Authority control

Alcohol law
Alcohol policy
Concentration indicators
Driving under the influence
Metabolism