The fundamental principle of bass management (also called LFE crossover) in

surround sound Surround sound is a technique for enriching the fidelity and depth of sound reproduction by using multiple audio channels from speakers that surround the listener ( surround channels). Its first application was in movie theaters. Prior to sur ...

replay systems is that bass content in the incoming signal, irrespective of channel, should be directed only to loudspeakers capable of reproducing it, whether the latter are the main system loudspeakers or one or more

subwoofer A subwoofer (or sub) is a loudspeaker designed to reproduce low-pitched audio frequencies known as bass and sub-bass, lower in frequency than those which can be (optimally) generated by a woofer. The typical frequency range for a subwoofer i ...

Mapping

There are notation differences between the pre-bass-managed signal and after it has passed through the bass manager. For example, when using 5.1 surround sound: As the table shows, the bass manager directs bass frequencies from ''all'' channels to one or more subwoofers, not just the content of the

low-frequency effects The low-frequency effects (LFE) channel is a band-limited audio track that is used for reproducing deep and intense low-frequency sounds in the 3–120 Hz frequency range. This track is normally sent to a subwoofer—a loudspeaker des ...

(LFE) channel. However, when there is no subwoofer, the bass manager directs the LFE channel to the main speakers. This is the only time the LFE channel would ''not'' be sent to the subwoofer. The key concept is that the LFE channel is ''not'' the subwoofer channel. A typical configuration of a bass-managed 5.1-channel surround-sound loudspeaker system is shown in the first diagram. As shown in the bass management block diagram, a 5.1-channel audio system consists of five discrete, full-range main channels (front left, center, front right, surround left, and surround right), plus a band-limited low-frequency effects (LFE) channel for added bass (this corresponds to the .1). In such a system, the use of bass management allows the redirection of low-frequency signals from any of the five main speakers to the subwoofer (SW). The high-pass filters applied to each of the main channels are typically 12 dB/octave and use a Butterworth filter. These are complemented by a 24 dB/octave low-pass filter in the subwoofer feed, which typically uses a Linkwitz-Riley filter topology. This approach tries to take into account the natural low-frequency responses of the main speakers, which roll off at 12 dB/octave for sealed enclosures, and 18–24 dB/octave for vented enclosures. The aim is to have the low-pass filtered and high-pass filtered signals be −6 dB at the crossover frequency, producing what is known as an acoustical 4th-order Linkwitz-Riley alignment of reasonable accuracy. This helps to ensure that the low-frequency response of each of the main channels is extended downwards with a flat acoustical response. In the diagram, a 60 Hz crossover frequency has been illustrated, but this can typically vary between 40 Hz and 80 Hz. The LFE channel is a separate channel that contains low frequencies only. It is band-limited using a 120 Hz low-pass filter, and this frequency is independent of the settings of the low-pass and high-pass filters that are applied to the main speakers. The LFE channel is usually amplified by 10 dB on playback and summed into the signal going to the subwoofer.

References

{{DEFAULTSORT:Bass Management Sound production technology Film sound production