ITU G.992.3 is an ITU (
International Telecommunication Union
The International Telecommunication Union is a specialized agency of the United Nations responsible for many matters related to information and communication technologies. It was established on 17 May 1865 as the International Telegraph Unio ...
) standard, also referred to as ADSL2 or G.dmt.bis. It optionally extends the capability of basic
ADSL
Asymmetric digital subscriber line (ADSL) is a type of digital subscriber line (DSL) technology, a data communications technology that enables faster data transmission over copper telephone lines than a conventional voiceband modem can provide. ...
in data rates to 12
Mbit/s downstream and, depending on
Annex version, up to 3.5 Mbit/s upstream (with a mandatory capability of ADSL2 transceivers of 8 Mbit/s downstream and 800 kbit/s upstream).
ADSL2 uses the same bandwidth as ADSL but achieves higher throughput via improved modulation techniques. Actual speeds may decrease depending on line quality; usually the most significant factor in line quality is the distance from the
DSLAM
A digital subscriber line access multiplexer (DSLAM, often pronounced ''DEE-slam'') is a network device, often located in telephone exchanges, that connects multiple customer digital subscriber line (DSL) interfaces to a high-speed digital co ...
to the customer's equipment.
Annex versions
ADSL2 has multiple modes for
DSL providers to offer services for different needs. Below is a list of available features based on
ADSL2 specs from the
ITU standards.
See also
*
ADSL
Asymmetric digital subscriber line (ADSL) is a type of digital subscriber line (DSL) technology, a data communications technology that enables faster data transmission over copper telephone lines than a conventional voiceband modem can provide. ...
*
ADSL2+
*
List of interface bit rates
This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels. The distinction can ...
*
Wetting current
In electrical and electronics engineering, wetting current is the minimum electric current needing to flow through a contact to break through the surface film resistance at a contact. It is typically far below the contact's nominal maximum curre ...
References
External links
ITU-T Recommendation G.992.3 Asymmetric digital subscriber line transceivers 2 (ADSL2)
{{DSL technologies
Digital subscriber line
ITU-T recommendations
ITU-T G Series Recommendations
Telecommunications-related introductions in 2002