Analog transmission is a

transmission Transmission may refer to: Medicine, science and technology * Power transmission ** Electric power transmission ** Propulsion transmission, technology allowing controlled application of power *** Automatic transmission *** Manual transmission *** ...

method of conveying information using a

continuous signal In mathematical dynamics, discrete time and continuous time are two alternative frameworks within which variables that evolve over time are modeled. Discrete time Discrete time views values of variables as occurring at distinct, separate "po ...

which varies in

amplitude The amplitude of a periodic variable is a measure of its change in a single period (such as time or spatial period). The amplitude of a non-periodic signal is its magnitude compared with a reference value. There are various definitions of amplit ...

, phase, or some other property in proportion to that information. It could be the transfer of an analog

signal In signal processing, a signal is a function that conveys information about a phenomenon. Any quantity that can vary over space or time can be used as a signal to share messages between observers. The ''IEEE Transactions on Signal Processing'' ...

, using an analog

modulation In electronics and telecommunications, modulation is the process of varying one or more properties of a periodic waveform, called the ''carrier signal'', with a separate signal called the ''modulation signal'' that typically contains informatio ...

method such as

frequency modulation Frequency modulation (FM) is the encoding of information in a carrier wave by varying the instantaneous frequency of the wave. The technology is used in telecommunications, radio broadcasting, signal processing, and Run-length limited#FM: .280. ...

(FM) or

amplitude modulation Amplitude modulation (AM) is a modulation technique used in electronic communication, most commonly for transmitting messages with a radio wave. In amplitude modulation, the amplitude (signal strength) of the wave is varied in proportion to ...

(AM), or no modulation at all. Some textbooks also consider

passband A passband is the range of frequencies or wavelengths that can pass through a filter. For example, a radio receiver contains a bandpass filter to select the frequency of the desired radio signal out of all the radio waves picked up by its antenn ...

data transmission using a

digital modulation method In electronics and telecommunications, modulation is the process of varying one or more properties of a periodic waveform, called the ''carrier signal'', with a separate signal called the ''modulation signal'' that typically contains informatio ...

such as ASK, PSK and QAM, i.e. a sinewave modulated by a digital bit-stream, as analog transmission and as an

analog signal An analog signal or analogue signal (see spelling differences) is any continuous signal representing some other quantity, i.e., ''analogous'' to another quantity. For example, in an analog audio signal, the instantaneous signal voltage varies c ...

. Others define that as

digital transmission Data transmission and data reception or, more broadly, data communication or digital communications is the transfer and reception of data in the form of a digital bitstream or a digitized analog signal transmitted over a point-to-point or ...

and as a

digital signal A digital signal is a signal that represents data as a sequence of discrete values; at any given time it can only take on, at most, one of a finite number of values. This contrasts with an analog signal, which represents continuous values; at ...

Baseband In telecommunications and signal processing, baseband is the range of frequencies occupied by a signal that has not been modulated to higher frequencies. Baseband signals typically originate from transducers, converting some other variable into a ...

data transmission using

line code In telecommunication, a line code is a pattern of voltage, current, or photons used to represent digital data transmitted down a communication channel or written to a storage medium. This repertoire of signals is usually called a constrained c ...

s, resulting in a pulse train, are always considered as

, although the source signal may be a digitized analog signal.

Methods

Analog transmission can be conveyed in many different fashions: *

Optical fiber An optical fiber, or optical fibre in Commonwealth English, is a flexible, transparent fiber made by drawing glass (silica) or plastic to a diameter slightly thicker than that of a human hair. Optical fibers are used most often as a means to ...

Twisted pair Twisted pair cabling is a type of wiring used for communications in which two conductors of a single circuit are twisted together for the purposes of improving electromagnetic compatibility. Compared to a single conductor or an untwisted ba ...

coaxial cable Coaxial cable, or coax (pronounced ) is a type of electrical cable consisting of an inner conductor surrounded by a concentric conducting shield, with the two separated by a dielectric ( insulating material); many coaxial cables also have a p ...

Radio Radio is the technology of signaling and communicating using radio waves. Radio waves are electromagnetic waves of frequency between 30 hertz (Hz) and 300 gigahertz (GHz). They are generated by an electronic device called a transmit ...

Underwater acoustic communication Underwater acoustic communication is a technique of sending and receiving messages below water. There are several ways of employing such communication but the most common is by using hydrophones. Underwater communication is difficult due to factor ...

There are two basic kinds of analog transmission, both based on how they modulate data to combine an input signal with a carrier signal. Usually, this carrier signal is a specific

frequency Frequency is the number of occurrences of a repeating event per unit of time. It is also occasionally referred to as ''temporal frequency'' for clarity, and is distinct from ''angular frequency''. Frequency is measured in hertz (Hz) which is eq ...

, and data is transmitted through its variations. The two techniques are

(AM), which varies the amplitude of the carrier signal, and

(FM), which modulates the frequency of the carrier.The Froehlich/Kent Encyclopedia of Telecommunications By

Allen Kent Allen Kent (October 24, 1921 – May 1, 2014) was an information scientist. Early life He was born in New York City.
ASIS&T obitu ...

, Froehlich E. Froehlich.1991 Marcel Dekker.

Types

Most analog transmissions fall into one of several categories.

Telephony Telephony ( ) is the field of technology involving the development, application, and deployment of telecommunication services for the purpose of electronic transmission of voice, fax, or data, between distant parties. The history of telephony is i ...

and voice communication was originally primarily analog in nature, as was most television and radio transmission. Early telecommunication devices utilized analog-to-digital conversion devices called modulator/demodulators, or

modems A modulator-demodulator or modem is a computer hardware device that converts data from a digital format into a format suitable for an analog transmission medium such as telephone or radio. A modem transmits data by Modulation#Digital modulati ...

, to convert

s to

digital signals A digital signal is a Signal (electrical engineering), signal that represents data as a sequence of discrete space, discrete values; at any given time it can only take on, at most, one of a finite number of values. This contrasts with an analog ...

and back.

Benefits and drawbacks

The analog transmission method is still very popular, in particular for shorter distances, due to significantly lower costs and complex multiplexing and timing equipment is unnecessary, and in small "short-haul" systems that simply do not need multiplexed digital transmission.Telecommunication

System Engineering Systems engineering is an interdisciplinary field of engineering and engineering management that focuses on how to design, integrate, and manage complex systems over their life cycles. At its core, systems engineering utilizes systems thinking p ...

By Roger L. Freeman.2004 John Wiley and Sons. However, in situations where a signal often has high

signal-to-noise ratio Signal-to-noise ratio (SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. SNR is defined as the ratio of signal power to the noise power, often expressed in deci ...

and cannot achieve source linearity, or in long distance, high output systems, analog is unattractive due to attenuation problems. Furthermore, as digital techniques continue to be refined, analog systems are increasingly becoming legacy equipment. Recently, some nations, such as the Netherlands, have completely ceased analog transmissions (

analogue switch-off The digital television transition, also called the digital switchover (DSO), the analogue switch/sign-off (ASO), the digital migration, or the analogue shutdown, is the process in which older analogue television broadcasting technology is conv ...

) on certain media, such as television, for the purposes of the government saving money.https://www.nytimes.com/aponline/technology/AP-Netherlands-TV.html?_r=2&oref=slogin&oref=slogin

References

{{reflist Electronic design Radio modulation modes Telecommunication theory Physical layer protocols Data transmission

Methods

Types

Benefits and drawbacks

See also

References