|
Tire-pressure Control System
A tire-pressure monitoring system (TPMS) monitors the air pressure inside the pneumatic tires on vehicles. A TPMS reports real-time tire-pressure information to the driver, using either a gauge, a pictogram display, or a simple low-pressure warning light. TPMS can be divided into two different types – direct (dTPMS) and indirect (iTPMS). TPMS are installed either when the vehicle is made or after the vehicle is put to use. The goal of a TPMS is avoiding traffic accidents, poor fuel economy, and increased tire wear due to under-inflated tires through early recognition of a hazardous state of the tires. This functionality first appeared in luxury vehicles in Europe in the 1980s, while mass-market adoption followed the USA passing the 2000 TREAD Act after the Firestone and Ford tire controversy. Mandates for TPMS technology in new cars have continued to proliferate in the 21st century in Russia, the EU, Japan, South Korea and many other Asian countries. From November 2014 ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Air Pressure
Atmospheric pressure, also known as barometric pressure (after the barometer), is the pressure within the atmosphere of Earth. The Standard atmosphere (unit), standard atmosphere (symbol: atm) is a unit of pressure defined as , which is equivalent to 1013.25 Bar (unit), millibars, 760millimetre of mercury, mm Hg, 29.9212inch of mercury, inchesHg, or 14.696pounds per square inch, psi.International Civil Aviation Organization. ''Manual of the International Standard Atmosphere, ICAO Standard Atmosphere'', Doc 7488-CD, Third Edition, 1993. . The atm unit is roughly equivalent to the mean sea-level atmospheric pressure on Earth; that is, the Earth's atmospheric pressure at sea level is approximately 1 atm. In most circumstances, atmospheric pressure is closely approximated by the fluid pressure, hydrostatic pressure caused by the weight of Earth's atmosphere, air above the measurement point. As elevation increases, there is less overlying atmospheric mass, so atmospheric pressure dec ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Peugeot 607
The Peugeot 607 is an executive car produced by the French manufacturer Peugeot from September 1999 to June 2010. The 607, along with the smaller 407, were superseded by the 508 in March 2011. History The 607 was launched in October 1999, to replace the discontinued 605. It used its predecessor's chassis but had an all-new, more modern exterior design. The engine range (2.2 and 3.0 petrol, and 2.2 diesel) was completely new. Built in Sochaux until March 2009, manufacture was transferred to PSA's Rennes plant in July the same year as production was being wound down. Equipment levels were high, with all models getting air conditioning, CD player, electric windows, 8 airbags, anti-lock braking system, tyre-pressure monitor, and central locking as standard. Available was AMVAR nine-stage electronic damping control. In France, its home market, the 607 was often chosen for official government use. Safety Facelift The 607 was restyled in November 2004, with the most notable m ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Tire Pressure Monitoring System 02
A tire (American English) or tyre (British English) is a ring-shaped component that surrounds a wheel's rim to transfer a vehicle's load from the axle through the wheel to the ground and to provide traction on the surface over which the wheel travels. Most tires, such as those for automobiles and bicycles, are pneumatically inflated structures, which also provide a flexible cushion that absorbs shock as the tire rolls over rough features on the surface. Tires provide a footprint, called a contact patch, that is designed to match the weight of the vehicle with the bearing strength of the surface that it rolls over by providing a bearing pressure that will not deform the surface excessively. The materials of modern pneumatic tires are synthetic rubber, natural rubber, fabric, and wire, along with carbon black and other chemical compounds. They consist of a tread and a body. The tread provides traction while the body provides containment for a quantity of compressed air ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Electromagnetic Induction
Electromagnetic or magnetic induction is the production of an electromotive force (emf) across an electrical conductor in a changing magnetic field. Michael Faraday is generally credited with the discovery of induction in 1831, and James Clerk Maxwell mathematically described it as Faraday's law of induction. Lenz's law describes the direction of the induced field. Faraday's law was later generalized to become the Maxwell–Faraday equation, one of the four Maxwell equations in his theory of electromagnetism. Electromagnetic induction has found many applications, including electrical components such as inductors and transformers, and devices such as electric motors and generators. History Electromagnetic induction was discovered by Michael Faraday, published in 1831. It was discovered independently by Joseph Henry in 1832. In Faraday's first experimental demonstration (August 29, 1831), he wrapped two wires around opposite sides of an iron ring or "torus" (an arrangement ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
TPMS Front Side , an aspect of differential geometry
{{Disambiguation ...
TPMS may refer to: * Takoma Park Middle School, in Maryland, US * Tire-pressure monitoring system * Transaction Processing Management System, ICL computer software * Triply periodic minimal surface In differential geometry, a triply periodic minimal surface (TPMS) is a minimal surface in ℝ3 that is invariant under a rank-3 lattice of translations. These surfaces have the symmetries of a crystallographic group. Numerous examples are known ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
World Forum For Harmonization Of Vehicle Regulations
The World Forum for Harmonization of Vehicle Regulations is a working party (WP.29) of the Inland Transport Committee (ITC) of the United Nations Economic Commission for Europe (UNECE). Its responsibility is to manage the multilateral Agreements signed in 1958, 1997 and 1998 concerning the technical prescriptions for the construction, approval of wheeled vehicles as well as their Periodic Technical Inspection and, to operate within the framework of these three Agreements to develop and amend UN Regulations, UN Global Technical Regulations and UN Rules, kind of vehicle regulation. WP.29 was established in June 1952 as the "Working Party of experts on technical requirement of vehicles", while its current name was adopted in 2000. At its inception, WP.29 had a broader European scope. Since 2000, the global scope of this forum was recognized given the active participation of Countries in all continents, excluding the United States and Canada, who developed incompatible standards. T ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Type Approval
Type approval or certificate of conformity is granted to a product that meets a minimum set of regulatory, technical and safety requirements. Generally, type approval is required before a product is allowed to be sold in a particular country, so the requirements for a given product will vary around the world. Processes and certifications known as 'type approval' in English are generally called ' homologation', or some cognate expression, in other European languages. Compliance to type-approval requirements can be denoted by a third-party marking on the back of the product (e.g. ABS, TÜV, UL, CSA, KIWA), or by a type-approval certificate obtained by a manufacturer and kept on file. The CE mark found on the back of many electronic devices does not mean that the product has obtained type approval in the European Union. The CE mark is the manufacturer's declaration that the system/assembly meets the minimum safety requirements of all the directives (laws) applicable to it, and of ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Indirect TPMS
A tire-pressure monitoring system (TPMS) monitors the air pressure inside the pneumatic tires on vehicles. A TPMS reports real-time tire-pressure information to the driver, using either a gauge, a pictogram display, or a simple low-pressure warning light. TPMS can be divided into two different types – direct (dTPMS) and indirect (iTPMS). TPMS are installed either when the vehicle is made or after the vehicle is put to use. The goal of a TPMS is avoiding traffic accidents, poor fuel economy, and increased tire wear due to under-inflated tires through early recognition of a hazardous state of the tires. This functionality first appeared in luxury vehicles in Europe in the 1980s, while mass-market adoption followed the USA passing the 2000 TREAD Act after the Firestone and Ford tire controversy. Mandates for TPMS technology in new cars have continued to proliferate in the 21st century in Russia, the EU, Japan, South Korea and many other Asian countries. From November 2014 ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Vehicle Category
A vehicle category classifies a land vehicle or trailer for regulatory purposes. UNECE categories United Nations Economic Commission for Europe Information from Consolidated Resolution on the Construction of Vehicles (R.E.3), Revision 6. Some categories have further sub classes. See Consolidated Resolution on the Construction of Vehicles (R.E.3) for further information. Vehicles in the table listed within parentheses are examples of the vehicle in that category, e.g. (Bus). Category notes EU classification In the European Union, the classifications for vehicle category are based on UNECE standards and defined by: * Regulation (EU) No 168/2013 of the European Parliament and of the Council of 15 January 2013 on the approval and market surveillance of two- or three-wheel vehicles and quadricycles. * Directive 2007/46/EC of the European Parliament and of the Council of 5 September 2007 establishing a framework for the approval of motor vehicles and their trailers, and of s ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
United States Congress
The United States Congress is the legislature of the federal government of the United States. It is bicameral, composed of a lower body, the House of Representatives, and an upper body, the Senate. It meets in the U.S. Capitol in Washington, D.C. Senators and representatives are chosen through direct election, though vacancies in the Senate may be filled by a governor's appointment. Congress has 535 voting members: 100 senators and 435 representatives. The U.S. vice president has a vote in the Senate only when senators are evenly divided. The House of Representatives has six non-voting members. The sitting of a Congress is for a two-year term, at present, beginning every other January. Elections are held every even-numbered year on Election Day. The members of the House of Representatives are elected for the two-year term of a Congress. The Reapportionment Act of 1929 establishes that there be 435 representatives and the Uniform Congressional Redistricting Act requires ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Vehicle Rollover
A rollover is a type of vehicle collision, vehicle crash in which a vehicle tips over onto its side or roof. Rollovers have a higher fatality rate than other types of vehicle collisions. Dynamics Vehicle rollovers are divided into two categories: tripped and untripped. Tripped rollovers are caused by forces from an external object, such as a curb or a collision with another vehicle. Untripped rollovers are the result of steering input, speed, and friction with the ground. Trailers that are not roll-coupled (i.e. those that use a trailer coupling rather than a fifth wheel) are more prone to rolling as they do not have the tractor unit or prime mover for additional stability. Untripped rollovers Untripped rollovers occur when cornering forces destabilize the vehicle. As a vehicle rounds a corner, three forces act on it: tire forces (the centripetal force), inertial effects (the centrifugal force), and gravity. The cornering forces from the tire push the vehicle towards the center ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
