|
Pre-echo
In audio signal processing, pre-echo, sometimes called a '' forward echo'' (not to be confused with reverse echo), is a digital audio compression artifact where a sound is heard before it occurs (hence the name). It is most noticeable in impulsive sounds from percussion instruments such as castanets or cymbals. It occurs in transform-based audio compression algorithms typically based on the modified discrete cosine transform (MDCT) such as MP3, MPEG-4 AAC, and Vorbis, and is due to quantization noise being spread over the entire transform window of the codec. Cause The psychoacoustic component of the effect is that one hears only the echo preceding the transient, not the one following because this latter is drowned out by the transient. Formally, forward temporal masking is much stronger than backwards temporal masking, hence one hears a pre-echo, but no post-echo. Mitigation In an effort to avoid pre-echo artifacts, many sound processing systems use filters where all of t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Transient (acoustics)
In acoustics and audio, a transient is a high amplitude, short-duration sound at the beginning of a waveform that occurs in phenomena such as musical sounds, noises or speech. Transients do not necessarily directly depend on the frequency of the tone they initiate. It contains a high degree of non-periodic components and a higher magnitude of high frequencies than the harmonic content of that sound. Transients are more difficult to encode with many audio compression algorithms, causing pre-echo. See also * Prefix (acoustics) * Impulse function * Onset (audio) * Transient response – a common electrical engineering term that may be the source of the idea of an acoustic "transient" References {{reflist Acoustics Sonar de:Einschwingvorgang ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Compression Artifact
A compression artifact (or artefact) is a noticeable distortion of media (including Image, images, Sound recording, audio, and video) caused by the application of lossy compression. Lossy data compression involves discarding some of the media's data so that it becomes small enough to be stored within the desired File size, disk space or Data stream, transmitted (''streamed'') within the available Bandwidth (computing), bandwidth (known as the data rate or bit rate). If the compressor cannot store enough data in the compressed version, the result is a loss of quality, or introduction of artifacts. The compression algorithm may not be intelligent enough to discriminate between distortions of little subjective importance and those objectionable to the user. The most common digital compression artifacts are DCT blocks, caused by the discrete cosine transform (DCT) compression algorithm used in many digital media standards, such as JPEG, MP3, and MPEG video file formats. These com ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Digital Room Correction
Digital room correction (or DRC) is a process in the field of acoustics where digital filters designed to ameliorate unfavorable effects of a room's acoustics are applied to the input of a sound reproduction system. Modern room correction systems produce substantial improvements in the time domain and frequency domain response of the sound reproduction system. History The use of analog filters, such as equalizers, to normalize the frequency response of a playback system has a long history; however, analog filters are very limited in their ability to correct the distortion found in many rooms. Although digital implementations of the equalizers have been available for some time, digital room correction is usually used to refer to the construction of filters which attempt to invert the impulse response of the room and playback system, at least in part. Digital correction systems are able to use acausal filters, and are able to operate with optimal time resolution, optimal fr ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Linear-phase
In signal processing, linear phase is a property of a filter where the phase response of the filter is a linear function of frequency. The result is that all frequency components of the input signal are shifted in time (usually delayed) by the same constant amount (the slope of the linear function), which is referred to as the group delay. Consequently, there is no phase distortion due to the time delay of frequencies relative to one another. For discrete-time signals, perfect linear phase is easily achieved with a finite impulse response (FIR) filter by having coefficients which are symmetric or anti-symmetric. Approximations can be achieved with infinite impulse response (IIR) designs, which are more computationally efficient. Several techniques are: * a Bessel transfer function which has a maximally flat group delay approximation function * a phase equalizer Definition A filter is called a linear phase filter if the phase component of the frequency response is a linear fun ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Print-through
Print-through is a generally undesirable effect that arises in the use of magnetic tape for storing analog information, in particular music, caused by contact transfer of signal patterns from one layer of tape to another as it sits wound concentrically on a reel. Explanation Print-through is a category of noise caused by contact transfer of signal patterns from one layer of tape to another after it is wound onto a reel. Print-through can take two forms: # thermo-remanent magnetization induced by temperature, and # anhysteretic magnetization caused by an external magnetic field. The former is unstable over time and can be easily erased by rewinding a tape and letting it sit so that the patterns formed by the contact of upper and lower layers begin to erase each other and form new patterns with the repositioning of upper/lower layers after rewinding. This type of contact printing begins immediately after a recording and increases over time at a rate dependent on the temperatur ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Breathing (noise Reduction)
Noise reduction is the process of removing noise from a signal. Noise reduction techniques exist for audio and images. Noise reduction algorithms may distort the signal to some degree. Noise rejection is the ability of a circuit to isolate an undesired signal component from the desired signal component, as with common-mode rejection ratio. All signal processing devices, both analog and digital, have traits that make them susceptible to noise. Noise can be random with an even frequency distribution (white noise), or frequency-dependent noise introduced by a device's mechanism or signal processing algorithms. In electronic systems, a major type of noise is ''hiss'' created by random electron motion due to thermal agitation. These agitated electrons rapidly add and subtract from the output signal and thus create detectable noise. In the case of photographic film and magnetic tape, noise (both visible and audible) is introduced due to the grain structure of the medium. In photogr ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Equalization (audio)
Equalization, or simply EQ, in sound recording and reproduction is the process of adjusting the volume of different frequency bands within an audio signal. The circuit or equipment used to achieve this is called an equalizer. Most hi-fi equipment uses relatively simple Electronic filter, filters to make Bass (sound), bass and Treble (sound), treble adjustments. Graphic and parametric equalizers have much more flexibility in tailoring the frequency content of an audio signal. Broadcast and recording studios use sophisticated equalizers capable of much more detailed adjustments, such as eliminating unwanted sounds or making certain instruments or voices more prominent. Because of this ability, they can be aptly described as "frequency-specific volume knobs." Equalizers are used in recording studio, recording and radio studios, production control rooms, and live sound reinforcement and in instrument amplifiers, such as guitar amplifiers, to correct or adjust the response of m ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Noise Reduction
Noise reduction is the process of removing noise from a signal. Noise reduction techniques exist for audio and images. Noise reduction algorithms may distort the signal to some degree. Noise rejection is the ability of a circuit to isolate an undesired signal component from the desired signal component, as with common-mode rejection ratio. All signal processing devices, both analog and digital, have traits that make them susceptible to noise. Noise can be random with an even frequency distribution ( white noise), or frequency-dependent noise introduced by a device's mechanism or signal processing algorithms. In electronic systems, a major type of noise is ''hiss'' created by random electron motion due to thermal agitation. These agitated electrons rapidly add and subtract from the output signal and thus create detectable noise. In the case of photographic film and magnetic tape, noise (both visible and audible) is introduced due to the grain structure of the medium. In pho ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Algorithm
In mathematics and computer science, an algorithm () is a finite sequence of Rigour#Mathematics, mathematically rigorous instructions, typically used to solve a class of specific Computational problem, problems or to perform a computation. Algorithms are used as specifications for performing calculations and data processing. More advanced algorithms can use Conditional (computer programming), conditionals to divert the code execution through various routes (referred to as automated decision-making) and deduce valid inferences (referred to as automated reasoning). In contrast, a Heuristic (computer science), heuristic is an approach to solving problems without well-defined correct or optimal results.David A. Grossman, Ophir Frieder, ''Information Retrieval: Algorithms and Heuristics'', 2nd edition, 2004, For example, although social media recommender systems are commonly called "algorithms", they actually rely on heuristics as there is no truly "correct" recommendation. As an e ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Codec
A codec is a computer hardware or software component that encodes or decodes a data stream or signal. ''Codec'' is a portmanteau of coder/decoder. In electronic communications, an endec is a device that acts as both an encoder and a decoder on a signal or data stream, and hence is a type of codec. ''Endec'' is a portmanteau of encoder/decoder. A coder or encoder encodes a data stream or a signal for transmission or storage, possibly in encrypted form, and the decoder function reverses the encoding for playback or editing. Codecs are used in videoconferencing, streaming media, and video editing applications. History Originally, in the mid-20th century, a codec was a hardware device that coded analog signals into digital form using pulse-code modulation (PCM). Later, the term was also applied to software for converting between digital signal formats, including companding functions. Examples An audio codec converts analog audio signals into digital signals for transmissi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Lossy
In information technology, lossy compression or irreversible compression is the class of data compression methods that uses inexact approximations and partial data discarding to represent the content. These techniques are used to reduce data size for storing, handling, and transmitting content. Higher degrees of approximation create coarser images as more details are removed. This is opposed to lossless data compression (reversible data compression) which does not degrade the data. The amount of data reduction possible using lossy compression is much higher than using lossless techniques. Well-designed lossy compression technology often reduces file sizes significantly before degradation is noticed by the end-user. Even when noticeable by the user, further data reduction may be desirable (e.g., for real-time communication or to reduce transmission times or storage needs). The most widely used lossy compression algorithm is the discrete cosine transform (DCT), first published by N ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
