|
Point Of Appearance
Point of appearance is a generic term for any point in a telephone/data circuit from which a technician can test or pull stats. Some appearances are virtual, such as a Digital cross connect system computer terminal. Others are physical, like a punch down COSMIC frame where a technician can place a test set, or a heat coil socket. In the outside plant there is an appearance at the cross box, pedestal, and network interface device. The ultimate appearance is the telephone or other customer premises equipment (CPE). See also *Demarcation point *Point of presence A point of presence (PoP) is an artificial demarcation point or network interface point between communicating entities. A common example is an ISP point of presence, the local access point that allows users to connect to the Internet with their ... Communication circuits {{Tech-stub ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Telecommunication Circuit
A telecommunication circuit is a path in a telecommunications network used to transmit information. Circuits have evolved over time from generally being built on physical connections between individual hardware cables, as in an analog phone switch, to virtual circuits established over packet switching networks. Definitions A telecommunication circuit may be defined as follows: * The complete path between two terminals over which one-way or two-way communications may be provided. * An electronic path between two or more points, capable of providing a single or multiple communication channels. * An electronic closed-loop path among two or more points used for signal transfer. In operational terms, a telecommunication circuit may be capable of transmitting information in only one direction (''simplex'' circuit), or it may be bi-directional (''duplex'' circuit). Bi-directional circuits may support half- duplex operation, when only one end of the channel transmits at any one time, ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Digital Cross Connect System
A digital cross-connect system (DCS or DXC) is a piece of circuit-switched network equipment, used in telecommunications networks, that allows lower-level TDM bit streams, such as DS0 bit streams, to be rearranged and interconnected among higher-level TDM signals, such as DS1 bit streams. DCS units are available that operate on both older T-carrier/E-carrier bit streams, as well as newer SONET/SDH bit streams. DCS devices can be used for " grooming" telecommunications traffic, switching traffic from one circuit to another in the event of a network failure, supporting automated provisioning, and other applications. Having a DCS in a circuit-switched network provides important flexibility that can otherwise only be obtained at higher cost using manual " DSX" cross-connect patch panels. It is important to realize that while DCS devices "switch" traffic, they are ''not'' packet switches—they switch ''circuits'', not packets, and the circuit arrangements they are used to man ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Punch Down
A punch-down block (also punchdown block, punch block, punchblock, quick-connect block and other variations) is a type of electrical connection often used in telephony. It is named because the solid copper wires are "punched down" into short open-ended slots which are a type of insulation-displacement connector. These slots, usually cut crosswise (not lengthwise) across an insulating plastic bar, contain two sharp metal blades which cut through the wire's insulation as it is punched down. These blades hold the wire in position and make the electrical contact with the wire as well. Overview A tool called a punch down tool is used to push the wire down firmly and properly into the slot. Some will automatically cut any excess wire off. The exact size and shape of the tool blade varies by manufacturer, which can cause problems for those working on existing installations, especially when there is a poorly documented mix of different brands. Punch-down blocks are a very quick and e ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Distribution Frame
Distribution may refer to: Mathematics *Distribution (mathematics), generalized functions used to formulate solutions of partial differential equations *Probability distribution, the probability of a particular value or value range of a variable **Cumulative distribution function, in which the probability of being no greater than a particular value is a function of that value *Frequency distribution, a list of the values recorded in a sample *Inner distribution, and outer distribution, in coding theory *Distribution (differential geometry), a subset of the tangent bundle of a manifold *Distributed parameter system, systems that have an infinite-dimensional state-space *Distribution of terms, a situation in which all members of a category are accounted for *Distributivity, a property of binary operations that generalises the distributive law from elementary algebra * Distribution (number theory) *Distribution problems, a common type of problems in combinatorics where the goal i ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Lineman's Handset
A lineman's handset is a special type of telephone used by technicians for installing and testing local loop telephone lines. It is also called a test set, butt set, or buttinski. Components A typical lineman's handset integrates an earpiece, a mouthpiece, a dialing interface, and a set of test leads for connecting to the telephone circuit. Originally, lineman's handsets featured a rotary dial, but modern sets use some variant of the standard 12-button DTMF keypad and also employ an amplifier for speaker use. Most handsets are designed to be used with analog " POTS" lines, and have limited or no function with digital circuits. Older Telephone linemen also referred to the Buttset as a "Goat". In addition to the basic features listed above, handsets often include one or more of: * Speakerphone * Redial * A talk/monitor toggle switch * Mute * Hook flash button * Tone/pulse dialing selection switch * Low-pass filtering to prevent disruption of data communications (such as DSL) ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Heat Coil
Heat coils, also known as ''protectors'', ''bugs'' or ''carbons'' serve as a surge protector between the telephone exchange and outside plant. They are commonly the last point of appearance for a telephone circuit before it leaves the office, for example on the outside plant side of the main distribution frame. On some competitive local exchange carrier circuits there are two heat coils, the extra one being at the point of interface between their circuit and where the incumbent local exchange carrier or Regional Bell Operating Company receives it. Their primary purpose is to protect central office equipment from surges of high voltage. If a surge comes down the line it will melt the connection between the central office and outside plant sides, as in a fuse Fuse or FUSE may refer to: Devices * Fuse (electrical), a device used in electrical systems to protect against excessive current ** Fuse (automotive), a class of fuses for vehicles * Fuse (hydraulic), a device used in hydra ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Outside Plant
In telecommunication, the term outside plant has the following meanings: *In civilian telecommunications, outside plant refers to all of the physical cabling and supporting infrastructure (such as conduit, cabinets, tower or poles), and any associated hardware (such as repeaters) located between a demarcation point in a switching facility and a demarcation point in another switching center or customer premises. *In the United States, the DOD defines outside plant as the communications equipment located between a main distribution frame (MDF) and a user end instrument. The CATV industry divides its fixed assets between head end or inside plant, and outside plant. The electrical power industry also uses the term outside plant to refer to electric power distribution systems. Context Network connections between devices such as computers, printers, and phones require a physical infrastructure to carry and process signals. Typically, this infrastructure will consist of: * Cabl ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Interface Device
upTwo simple NIDs, carrying six lines each, on the outside of a building upA German copper phone line termination box called '' Abschlusspunkt LinienTechnik'' (APL, " Demarcation point") In telecommunications, a network interface device (NID; also known by several other names) is a device that serves as the demarcation point between the carrier's local loop and the customer's premises wiring. Outdoor telephone NIDs also provide the subscriber with access to the station wiring and serve as a convenient test point for verification of loop integrity and of the subscriber's inside wiring. Naming Generically, an NID may also be called a network interface unit (NIU), telephone network interface (TNI), system network interface (SNI), or telephone network box. Australia's National Broadband Network uses the term '' network termination device'' or NTD. A smartjack is a type of NID with capabilities beyond simple electrical connection, such as diagnostics. An ''optical network term ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Customer Premises Equipment
In telecommunications, a customer-premises equipment or customer-provided equipment (CPE) is any terminal and associated equipment located at a subscriber's premises and connected with a carrier's telecommunication circuit at the demarcation point ("demarc"). The demarc is a point established in a building or complex to separate customer equipment from the equipment located in either the distribution infrastructure or central office of the communications service provider. CPE generally refers to devices such as telephones, routers, network switches, residential gateways (RG), set-top boxes, fixed mobile convergence products, home networking adapters and Internet access gateways that enable consumers to access providers' communication services and distribute them in a residence or enterprise with a local area network (LAN). A CPE can be an active equipment, as the ones mentioned above, or passive equipment such as analogue telephone adapters (ATA) or xDSL-splitters. This incl ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Demarcation Point
In telephony, the demarcation point is the point at which the public switched telephone network ends and connects with the customer's on-premises wiring. It is the dividing line which determines who is responsible for installation and maintenance of wiring and equipment—customer/subscriber, or telephone company/provider. The demarcation point varies between countries and has changed over time. ''Demarcation point'' is sometimes abbreviated as demarc, DMARC, or similar. The term MPOE (minimum or main point of entry) is synonymous, with the added implication that it occurs as soon as possible upon entering the customer premises. A network interface device often serves as the demarcation point. History Prior to Federal Communications Commission (FCC) regulations separating the ownership of customer premises telecommunication equipment from the telephone network, there was no need for a public standard governing the interconnection of customer premises equipment (CPE) to the ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Point Of Presence
A point of presence (PoP) is an artificial demarcation point or network interface point between communicating entities. A common example is an ISP point of presence, the local access point that allows users to connect to the Internet with their Internet service provider (ISP). A PoP typically houses servers, routers, network switches, multiplexers, and other network interface equipment, and is typically located in a data center. ISPs typically have multiple PoPs. PoPs are often located at Internet exchange points and colocation centres. In the US, this term became important during the court-ordered breakup of the Bell Telephone system. A point of presence was a location where a long-distance carrier (IXC) could terminate services and provide connections into a local telephone network (LATA). See also * Content delivery network * Web cache * Meet-me room A "meet-me room" (MMR) is a place within a colocation centre (or carrier hotel) where telecommunications companies ca ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
