|
Combustion Detection Module
Trionic is an engine management system developed by Saab Automobile. It consists of an engine control unit (ECU) that controls 3 engine aspects: # Ignition timing # Fuel injection # Acts as a boost controller. The numerical prefix 'tri-' in Trionic. 'Ion' comes from the fact that it uses ion current, measured by the spark plugs between combustion events which acts as a sensor for knock, misfire and synchronization detection. The ion current stream which was developed within the ion sensing system due to combustion, can be deduced by monitoring the secondary current of the ignition coil. Using the value and wave shape of the current, after the actual spark event, the quality of the actual combustion process is determined, thus allowing the engine control unit to optimize the timing of the spark for the best engine performance while keeping emissions low on a much wider range of rpms. Since Trionic 7, the throttle and thereby the air charge has also been electronically controlled, ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Saab Automobile
Saab Automobile AB () is a defunct automotive industry, car manufacturer that was founded in Sweden in 1945 when its parent company, Saab AB, began a project to design a small automobile. The first production model, the Saab 92, was launched in 1949. In 1968 the parent company merged with Scania-Vabis, and ten years later the Saab 900 was launched, in time becoming Saab's best-selling model. In the mid-1980s the new Saab 9000 model also appeared. In 1989, the automobile division of Saab-Scania was restructured into an independent company, Saab Automobile AB. The American manufacturer General Motors (GM) took 50 percent ownership. Two well-known models to come out of this period were the Saab 9-3 and the Saab 9-5. Then in 2000, GM exercised its option to acquire the remaining 50 percent. In 2010 GM sold Saab Automobile AB to the Dutch automobile manufacturer Spyker Cars N.V. After many years establishing a sound engineering reputation and ultimately a luxury car, luxury price t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Kilobyte
The kilobyte is a multiple of the unit byte for digital information. The International System of Units (SI) defines the prefix ''kilo'' as 1000 (103); per this definition, one kilobyte is 1000 bytes.International Standard IEC 80000-13 Quantities and Units – Part 13: Information science and technology, International Electrotechnical Commission (2008). The internationally recommended unit symbol for the kilobyte is kB. In some areas of information technology, particularly in reference to solid-state memory capacity, ''kilobyte'' instead typically refers to 1024 (210) bytes. This arises from the prevalence of sizes that are powers of two in modern digital memory architectures, coupled with the accident that 210 differs from 103 by less than 2.5%. A kibibyte is defined by Clause 4 of IEC 80000-13 as 1024 bytes. Definitions and usage Base 10 (1000 bytes) In the International System of Units (SI) the prefix ''kilo'' means 1000 (103); therefore, one kilobyte is 1000 bytes. The u ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Throttle Position Sensor
A throttle position sensor (TPS) is a sensor used to monitor the air intake of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position sensor" (CTPS) may be employed to indicate that the throttle is completely closed. Some engine control units (ECUs) also control the throttle position by electronic throttle control (ETC) or "drive by wire" systems, and if that is done, the position sensor is used in a feedback loop to enable that control. Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor. The accelerator pedal sensors are used in electronic throttle control or "drive by wire" systems, and the most common use of a wide open throttle sensor is for the kick-down function on automatic transmissions. Modern day sensors are non contact type. These modern non ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Traction Control System
A traction control system (TCS), also known as ASR (from german: Antriebsschlupfregelung, lit=drive slippage regulation), is typically (but not necessarily) a secondary function of the electronic stability control (ESC) on production motor vehicles, designed to prevent loss of traction (i.e., wheelspin) of the driven road wheels. TCS is activated when throttle input and engine power and torque transfer are mismatched to the road surface conditions. The intervention consists of one or more of the following: *Brake force applied to one or more wheels *Reduction or suppression of spark sequence to one or more cylinders *Reduction of fuel supply to one or more cylinders *Closing the throttle, if the vehicle is fitted with drive by wire throttle *In turbocharged vehicles, a boost control solenoid is actuated to reduce boost and therefore engine power. Typically, traction control systems share the electrohydraulic brake actuator (which does not use the conventional master cylinder and ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Saab Information Display
Saab Information Display (SID) later also called "Saab Car Computer"1995 Saab 900SE owner's manual (SCC) is the name for various in-car computer systems found on most Saab automobiles beginning in 1985 with the Saab 9000 and followed in 1994 with the Saab 900 NG. SIDs typically provide functions useful to the driver such as multiple trip odometers, fuel efficiency, estimated range ("distance to empty" – DTE), current CD track or radio station, and also brief description of car system failures. SIDs designed prior to the full General Motors takeover of Saab in 2000 were mounted in the center console, usually just above the head unit and below climate control vents with the exception of 9000 models, possibly after the "facelift" in the early 1990s. The 9000 featured the SID on the standard instrument cluster, with a car pictogram, showing open doors/tailgate/boot (trunk), lamp failures and low oil pressure in red. If there were no warnings, the white pictogram would disappear. ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pulse-width Modulation
Pulse-width modulation (PWM), or pulse-duration modulation (PDM), is a method of reducing the average power delivered by an electrical signal, by effectively chopping it up into discrete parts. The average value of voltage (and current) fed to the load is controlled by turning the switch between supply and load on and off at a fast rate. The longer the switch is on compared to the off periods, the higher the total power supplied to the load. Along with maximum power point tracking (MPPT), it is one of the primary methods of reducing the output of solar panels to that which can be utilized by a battery. PWM is particularly suited for running inertial loads such as motors, which are not as easily affected by this discrete switching, because their inertia causes them to react slowly. The PWM switching frequency has to be high enough not to affect the load, which is to say that the resultant waveform perceived by the load must be as smooth as possible. The rate (or frequency) a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Manifold Absolute Pressure
The manifold absolute pressure sensor (MAP sensor) is one of the sensors used in an internal combustion engine's electronic control system. Engines that use a MAP sensor are typically fuel injected. The manifold absolute pressure sensor provides instantaneous manifold pressure information to the engine's electronic control unit (ECU). The data is used to calculate air density and determine the engine's air mass flow rate, which in turn determines the required fuel metering for optimum combustion (see stoichiometry) and influence the advance or retard of ignition timing. A fuel-injected engine may alternatively use a mass airflow sensor (MAF sensor) to detect the intake airflow. A typical naturally aspirated engine configuration employs one or the other, whereas forced induction engines typically use both; a MAF sensor on the Cold Air Intake leading to the turbo and a MAP sensor on the intake tract post-turbo before the throttle body on the intake manifold. MAP sensor data can ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Electronic Throttle Control
Electronic throttle control (ETC) is an automobile technology which electronically "connects" the accelerator pedal to the throttle, replacing a mechanical linkage. A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). The ECM is a type of electronic control unit (ECU), which is an embedded system that employs software to determine the required throttle position by calculations from data measured by other sensors, including the accelerator pedal position sensors, engine speed sensor, vehicle speed sensor, and cruise control switches. The electric motor is then used to open the throttle valve to the desired angle via a closed-loop control algorithm within the ECM. The benefits of electronic ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Exhaust Gas Temperature
Exhaust gas or flue gas is emitted as a result of the combustion of fuels such as natural gas, gasoline (petrol), diesel fuel, fuel oil, biodiesel blends, or coal. According to the type of engine, it is discharged into the atmosphere through an exhaust pipe, flue gas stack, or propelling nozzle. It often disperses downwind in a pattern called an ''exhaust plume''. It is a major component of motor vehicle emissions (and from stationary internal combustion engines), which can also include crankcase blow-by and evaporation of unused gasoline. Motor vehicle emissions contribute to air pollution and are a major ingredient in the creation of smog in some large cities. A 2013 study by the Massachusetts Institute of Technology (MIT) indicates that 53,000 early deaths occur per year in the United States alone because of vehicle emissions. According to another study from the same university, traffic fumes alone cause the death of 5,000 people every year just in the United Kingdom. Compo ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Engine Control Unit
An engine control unit (ECU), also commonly called an engine control module (ECM), is a type of electronic control unit that controls a series of actuators on an internal combustion engine to ensure optimal engine performance. It does this by reading values from a multitude of sensors within the engine bay, interpreting the data using multidimensional performance maps (called lookup tables), and adjusting the engine actuators. Before ECUs, air–fuel mixture, ignition timing, and idle speed were mechanically set and dynamically controlled by mechanical and pneumatic means. If the ECU has control over the fuel lines, then it is referred to as an electronic engine management system (EEMS). The fuel injection system has the major role of controlling the engine's fuel supply. The whole mechanism of the EEMS is controlled by a stack of sensors and actuators. Workings Control of air–fuel ratio Most modern engines use some type of fuel injection to deliver fuel to the cylinders. ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Automatic Performance Control
Automatic Performance Control (APC) was the first engine knock and boost control system. The APC was invented by Per Gillbrand at the Swedish car maker SAAB. SAAB introduced it on the turbo charged Saab H engines in 1982, and the APC was fitted to all subsequent 900 Turbos through 1993 (and 1994 convertibles), as well as 9000 Turbos through 1989. The APC was sold to Maserati to equip the carbureted Maserati Biturbo, with different settings for the Biturbo, and was known as the Maserati Automatic Boost Controller (MABC). The APC allowed a higher compression ratio (initially, 8.5:1 as opposed to 7.2:1, and, on 16-valve variants introduced in 1985, 9.0:1). This improved fuel economy and allowed the use of low-octane petrol without causing engine damage caused by knock. The APC controls boost pressure and the overall performance, specifically the rate of rise and maximum boost level - and it detects and manages harmful knock events. To control the turbocharger, the APC monito ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
_(crop).jpg "Click for more on -> Saab Automobile")
