|
Bearing (angle)
In navigation, bearing or azimuth is the horizontal angle between the direction of an object and north or another object. The angle value can be specified in various angular units, such as degrees, mils, or grad. More specifically: * Absolute bearing refers to the angle between the magnetic north (''magnetic bearing'') or true north (''true bearing'') and an object. For example, an object to due east would have an absolute bearing of 90 degrees. Thus, it is the same as azimuth.U.S. Army, ''Advanced Map and Aerial Photograph Reading'', Headquarters, War Department, Washington, D.C. (17 September 1941), pp. 24-2/ref> * #Relative, Relative bearing refers to the angle between the craft's forward direction (heading) and the location of another object. For example, an object relative bearing of 0 degrees would be immediately in front; an object relative bearing 180 degrees would be behind. Bearings can be measured in mils, points, or degrees. Thus, it is the same as an ''azimuth ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Brunton
Brunton may refer to: Places *Brunton, Northumberland, England (near Alnwick) *Low Brunton, Northumberland, England (near Hexham) *Brunton, Wiltshire, England *Brunton Memorial Ground, Radlett, Hertfordshire, England *Brunton, Fife, Scotland; a List of United Kingdom locations: Bru-Bun, location in the U.K. Other uses *Brunton (surname) *Brunton, Inc., manufacturers of the Brunton compass See also *Colmar Brunton, a market research company *Brunton compass {{disambiguation, geo ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Angular Mil
A milliradian ( SI-symbol mrad, sometimes also abbreviated mil) is an SI derived unit for angular measurement which is defined as a thousandth of a radian (0.001 radian). Milliradians are used in adjustment of firearm sights by adjusting the angle of the sight compared to the barrel (up, down, left, or right). Milliradians are also used for comparing shot groupings, or to compare the difficulty of hitting different sized shooting targets at different distances. When using a scope with both mrad adjustment and a reticle with mrad markings (called an "mrad/mrad scope"), the shooter can use the reticle as a ruler to count the number of mrads a shot was off-target, which directly translates to the sight adjustment needed to hit the target with a follow up shot. Optics with mrad markings in the reticle can also be used to make a range estimation of a known size target, or vice versa, to determine a target size if the distance is known, a practice called "milling". Milliradian ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
