Single-ended (other)

	Single-ended (other) Single-ended may refer to: * Single ended recuperative burner, a type of gas burner used in industrial furnaces * Single-ended signaling, the simplest commonly used method of transmitting electrical signals over wires * Single-ended triode A single-ended triode (SET) is a vacuum tube electronic amplifier that uses a single triode to produce an output, in contrast to a push-pull amplifier which uses a pair of devices with antiphase inputs to generate an output with the wanted si ..., an audio amplifier * Single-ended playing card {{disambig ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu]
	Single Ended Recuperative Burner A single-ended recuperative (SER) burner is a type of gas burner used in high-temperature industrial kilns and furnaces. These burners are used where indirect heating is required, e.g. where the products of combustion are not allowed to combine with the atmosphere of the furnace. The typical design is a tubular (pipe) shape with convoluted pathways on the interior, closed on the end pointed into the furnace. A gas burner fires a flame down the center of these pathways, and the hot combustion gases are then forced to change direction and travel along the shell of the tube, heating it to incandescent temperatures and allowing efficient transfer of thermal energy to the furnace interior. Exhaust gas is collected back at the burner end where it is eventually discharged to the atmosphere. The hot exhaust can be used to pre-heat the incoming combustion air and fuel gas (recuperation) to boost efficiency. Such burners compete with electrical heating and can be more economical to operate tha ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu]
	Single-ended Signaling Single-ended signaling is the simplest and most commonly used method of transmitting electrical signals over wires. One wire carries a varying voltage that represents the signal, while the other wire is connected to a reference voltage, usually ground. The main alternative to single-ended signaling is called ''differential signaling'' where the two conductors carry signals equal in magnitude but of opposite electric polarity. Single-ended signaling is less expensive to implement than differential, but it has a distinct disadvantage: a single-ended system requires a power supply voltage equal to the maximum amplitude of the signal to be received whereas a differential system only requires a voltage half of the signal amplitude to be received. For a given power supply voltage then, a differential system produces signals of twice the amplitude and therefore has twice as good noise immunity (6 dB higher signal-to-noise ratio) as a single-ended system. The main advantage of single-end ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu]
	Single-ended Triode A single-ended triode (SET) is a vacuum tube electronic amplifier that uses a single triode to produce an output, in contrast to a push-pull amplifier which uses a pair of devices with antiphase inputs to generate an output with the wanted signals added and the distortion components subtracted. Single-ended amplifiers normally operate in Class A; push-pull amplifiers can also operate in Classes AB or B without excessive net distortion, due to cancellation. The term single-ended triode amplifier is mainly used for output stages of audio power amplifiers. The phrase directly heated triode single-ended triode amplifier (abbreviated to DHT SET) is used when directly heated triodes are used. There are also single-ended tetrode, beam tetrode/beam power tube/kinkless tetrode, and pentode amplifiers with the same functionality and similar circuitry; e.g. this Mullard design. Audio power amplifiers A typical triode audio power amplifier will have a driver that provides voltage gain ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu]