|
QuickPath Interconnect
The Intel QuickPath Interconnect (QPI) is a point-to-point processor interconnect developed by Intel which replaced the front-side bus (FSB) in Xeon, Itanium, and certain desktop platforms starting in 2008. It increased the scalability and available bandwidth. Prior to the name's announcement, Intel referred to it as Common System Interface (CSI). Earlier incarnations were known as Yet Another Protocol (YAP) and YAP+. QPI 1.1 is a significantly revamped version introduced with Sandy Bridge-EP (Romley platform). QPI was replaced by Intel Ultra Path Interconnect (UPI) in Skylake-SP Xeon processors based on LGA 3647 socket. Background Although sometimes called a "bus", QPI is a point-to-point interconnect. It was designed to compete with HyperTransport that had been used by Advanced Micro Devices (AMD) since around 2003. Intel developed QPI at its Massachusetts Microprocessor Design Center (MMDC) by members of what had been the Alpha Development Group, which Intel had acquired fro ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Microprocessor
A microprocessor is a computer processor where the data processing logic and control is included on a single integrated circuit, or a small number of integrated circuits. The microprocessor contains the arithmetic, logic, and control circuitry required to perform the functions of a computer's central processing unit. The integrated circuit is capable of interpreting and executing program instructions and performing arithmetic operations. The microprocessor is a multipurpose, clock-driven, register-based, digital integrated circuit that accepts binary data as input, processes it according to instructions stored in its memory, and provides results (also in binary form) as output. Microprocessors contain both combinational logic and sequential digital logic, and operate on numbers and symbols represented in the binary number system. The integration of a whole CPU onto a single or a few integrated circuits using Very-Large-Scale Integration (VLSI) greatly reduced the cost of ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Chipset
In a computer system, a chipset is a set of electronic components An electronic component is any basic discrete device or physical entity in an electronic system used to affect electrons or their associated fields. Electronic components are mostly industrial products, available in a singular form and are no ... in one or more integrated circuits known as a "Data Flow Management System" that manages the data flow between the Central processing unit, processor, computer memory, memory and peripherals. It is usually found on the motherboard. Chipsets are usually designed to work with a specific family of microprocessors. Because it controls communications between the processor and external devices, the chipset plays a crucial role in determining Computer performance, system performance. Computers In computing, the term ''chipset'' commonly refers to a set of specialized integrated circuit, chips on a computer's motherboard or an expansion card. In personal computers, the first ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Uncore
"Uncore" is a term used by Intel to describe the functions of a microprocessor that are not in the core, but which must be closely connected to the core to achieve high performance. It has been called "system agent" since the release of the Sandy Bridge microarchitecture. Details The core contains the components of the processor involved in executing instructions, including the ALU, FPU, L1 and L2 cache. Uncore functions include QPI controllers, L3 cache, snoop agent pipeline, on-die memory controller, on-die PCI Express Root Complex, and Thunderbolt controller. Other bus controllers such as SPI and LPC are part of the chipset. The Intel uncore design stems from its origin as the northbridge. The design of the Intel uncore reorganizes the functions critical to the core, making them physically closer to the core on-die, thereby reducing their access latency. Specifically, the microarchitecture of the Intel uncore is broken down into a number of modular units. The main u ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Clarksfield (microprocessor)
Clarksfield is the code name for an Intel processor, initially sold as mobile Intel Core i7. It is closely related to the desktop Lynnfield processor, both use quad-core dies based on the 45 nm Nehalem microarchitecture and have integrated PCI Express and DMI links. The predecessor of Clarksfield, Penryn-QC was a multi-chip module with two dual-core Penryn dies based on Penryn microarchitecture, a shrink of Core microarchitecture. The name of the direct successor of Clarksfield has not been announced. Arrandale is a later mobile processor but opens a new line of mid-range dual-core processors with integrated graphics. At the time of its release at the Intel Developer Forum on September 23, 2009, Clarksfield processors were significantly faster than any other laptop processor, including the Core 2 Extreme QX9300. The initial laptop manufacturers shipping products based on Clarksfield processors include MSI, Dell/Alienware, Hewlett-Packard, Toshiba and Asustek. [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Lynnfield (microprocessor)
Lynnfield is the code name for a quad-core processor from Intel released in September 2009. It was sold in varying configurations as Core i5-7xx, Core i7-8xx or Xeon X34xx. Lynnfield uses the Nehalem microarchitecture and replaces the earlier Penryn based Yorkfield processor, using the same 45 nm process technology, but with a new memory and bus interface. The product code for Lynnfield is 80605, its CPUID value identifies it as family 6, model 30 (0106Ex). Lynnfield is related to the earlier Bloomfield and Gainestown microprocessors, which are used in server and high-end desktop systems. The main difference between the two is Lynnfield's use of the LGA 1156 processor socket as opposed to the LGA 1366 socket used by Bloomfield and Gainestown processors. LGA 1156 processors include Direct Media Interface and PCI Express links, which Intel has previously connected to the processor with a dedicated northbridge chip, called the ''memory controller hub'' or ''I/O hub''. The Lynnf ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
LGA 1156
LGA 1156 (land grid array 1156), also known as Socket H or H1, is an Intel desktop CPU socket. Its incompatible successor is LGA 1155. The last processors supporting it ceased production in 2011. LGA 1156, along with LGA 1366, were designed to replace LGA 775. Whereas LGA 775 processors connect to a northbridge using the Front Side Bus, LGA 1156 processors integrate the features traditionally located on a northbridge within the processor itself. The LGA 1156 socket allows the following connections to be made from the processor to the rest of the system: * PCI-Express 2.0 ×16 for communication with a graphics card. Some processors allow this connection to be divided into two ×8 lanes to connect two graphics cards. Some motherboard manufacturers use Nvidia's NF200 chip to allow even more graphics cards to be used. * DMI for communication with the Platform Controller Hub (PCH). This consists of a PCI-Express 2.0 ×4 connection. * FDI for communication with the PCH. Thi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Flit (computer Networking)
In computer networking, a flit (flow control unit or flow control digit) is a link-level atomic piece that forms a network packet or stream. The first flit, called the header flit holds information about this packet's route (namely the destination address) and sets up the routing behavior for all subsequent flits associated with the packet. The header flit is followed by zero or more body flits, containing the actual payload of data. The final flit, called the tail flit, performs some book keeping to close the connection between the two nodes. A virtual connection holds the state needed to coordinate the handling of the flits of a packet. At a minimum, this state identifies the output port of the current node for the next hop of the route and the state of the virtual connection (idle, waiting for resources, or active). The virtual connection may also include pointers to the flits of the packet that are buffered on the current node and the number of flit buffers available on the ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Differential Signaling
Differential signalling is a method for electrically transmitting information using two complementary signals. The technique sends the same electrical signal as a differential pair of signals, each in its own conductor. The pair of conductors can be wires in a twisted-pair or ribbon cable or traces on a printed circuit board. Electrically, the two conductors carry voltage signals which are equal in magnitude, but of opposite polarity. The receiving circuit responds to the difference between the two signals, which results in a signal with a magnitude twice as large. The symmetrical signals of differential signalling may be referred to as ''balanced'', but this term is more appropriately applied to balanced circuits and balanced lines which reject common-mode interference when fed into a differential receiver. Differential signalling does not make a line balanced, nor does noise rejection in balanced circuits require differential signalling. Differential signalling is to ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Full Duplex
A duplex communication system is a point-to-point system composed of two or more connected parties or devices that can communicate with one another in both directions. Duplex systems are employed in many communications networks, either to allow for simultaneous communication in both directions between two connected parties or to provide a reverse path for the monitoring and remote adjustment of equipment in the field. There are two types of duplex communication systems: full-duplex (FDX) and half-duplex (HDX). In a full-duplex system, both parties can communicate with each other simultaneously. An example of a full-duplex device is plain old telephone service; the parties at both ends of a call can speak and be heard by the other party simultaneously. The earphone reproduces the speech of the remote party as the microphone transmits the speech of the local party. There is a two-way communication channel between them, or more strictly speaking, there are two communication channel ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Non-uniform Memory Access
Non-uniform memory access (NUMA) is a computer memory design used in multiprocessing, where the memory access time depends on the memory location relative to the processor. Under NUMA, a processor can access its own local memory faster than non-local memory (memory local to another processor or memory shared between processors). The benefits of NUMA are limited to particular workloads, notably on servers where the data is often associated strongly with certain tasks or users. NUMA architectures logically follow in scaling from symmetric multiprocessing (SMP) architectures. They were developed commercially during the 1990s by Unisys, Convex Computer (later Hewlett-Packard), Honeywell Information Systems Italy (HISI) (later Groupe Bull), Silicon Graphics (later Silicon Graphics International), Sequent Computer Systems (later IBM), Data General (later EMC, now Dell Technologies), and Digital (later Compaq, then HP, now HPE). Techniques developed by these companies later feature ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Memory Controller
The memory controller is a digital circuit that manages the flow of data going to and from the computer's main memory. A memory controller can be a separate chip or integrated into another chip, such as being placed on the same die or as an integral part of a microprocessor; in the latter case, it is usually called an integrated memory controller (IMC). A memory controller is sometimes also called a memory chip controller (MCC) or a memory controller unit (MCU). A common form of memory controller is the memory management unit (MMU) which in many operating systems implements virtual addressing. History Most modern desktop or workstation microprocessors use an ''integrated memory controller'' (IMC), including microprocessors from Intel, AMD, and those built around the ARM architecture. Prior to K8 (circa 2003), AMD microprocessors had a memory controller implemented on their motherboard's northbridge. In K8 and later, AMD employed an integrated memory controller. Likewis ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Intel Core I7
The following is a list of Intel Core i7 brand microprocessors. Introduced in 2008, the Core i7 line of microprocessors are intended to be used by high-end users. Desktop processors Nehalem microarchitecture (1st generation) "Bloomfield" (45 nm) * All models support: MMX, SSE, SSE2, SSE3, SSSE3, SSE4.1, SSE4.2, Enhanced Intel SpeedStep Technology (EIST), Intel 64, XD bit (an NX bit implementation), Intel VT-x, Hyper-threading, Turbo Boost, Smart Cache. * FSB has been replaced with QPI. * Transistors: 731 million * Die size: 263 mm * Steppings: C0, D0 "Lynnfield" (45 nm) * All models support: MMX, SSE, SSE2, SSE3, SSSE3, SSE4.1, SSE4.2, Enhanced Intel SpeedStep Technology (EIST), Intel 64, XD bit (an NX bit implementation), TXT, Intel VT-x, Intel VT-d, Hyper-threading, Turbo Boost, Smart Cache. * Core i7-875K features an unlocked multiplier and does not support Intel TXT and Intel VT-d. * FSB has been replaced with DMI. *Moves the QPI link and ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
.svg "Click for more on -> Intel Core I7")