|
NSAP Address
A Network Service Access Point address (NSAP address), defined in ISO/IEC 8348, is an identifying label for a Service Access Point (SAP) used in OSI OSI may refer to: Places * Osijek Airport (IATA code: OSI), an airport in Croatia * Ősi, a village in Veszprém county, Hungary * Oši, an archaeological site in Semigallia, Latvia * Osi, a village in Ido-Osi, Ekiti State, Nigeria * Osi, Ekiti ... networking. These are roughly comparable to IP addresses used in the Internet Protocol; they can specify a piece of equipment connected to an Asynchronous Transfer Mode (ATM) network. A specific stream, analogous to a TCP/IP Computer port (software), port or Berkeley sockets, socket, is specified by using a Transport Service Access Point (TSAP). ATM can also use a Presentation (PSAP) and Session (SSAP) Access Point, but these may also be unspecified; this is up to the application. Allocation and scope NSAP addresses are allocated by the International Organization for Standardization (IS ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Service Access Point
A Service Access Point (SAP) is an identifying label for network endpoints used in Open Systems Interconnection (OSI) networking. The SAP is a conceptual location at which one OSI layer can request the services of another OSI layer. As an example, PD-SAP or PLME-SAP in IEEE 802.15.4 can be mentioned, where the medium access control (MAC) layer requests certain services from the physical layer. Service access points are also used in IEEE 802.2 Logical Link Control in Ethernet and similar data link layer protocols. When using the OSI Network system (CONS or CLNS), the base for constructing an address for a network element is an NSAP address, similar in concept to an IP address. OSI protocols as well as Asynchronous Transfer Mode Asynchronous Transfer Mode (ATM) is a telecommunications standard defined by American National Standards Institute (ANSI) and ITU-T (formerly CCITT) for digital transmission of multiple types of traffic. ATM was developed to meet the needs of ... ( ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Virtual Circuit Identifier
Asynchronous Transfer Mode (ATM) is a telecommunications standard defined by American National Standards Institute (ANSI) and ITU-T (formerly CCITT) for digital transmission of multiple types of traffic. ATM was developed to meet the needs of the Broadband Integrated Services Digital Network as defined in the late 1980s, and designed to integrate telecommunication networks. It can handle both traditional high-throughput data traffic and real-time, low-latency content such as telephony (voice) and video.ATM Forum, The User Network Interface (UNI), v. 3.1, , Prentice Hall PTR, 1995, page 2. ATM provides functionality that uses features of circuit switching and packet switching networks by using asynchronous time-division multiplexing.McDysan (1999), p. 287. In the OSI reference model data link layer (layer 2), the basic transfer units are called '' frames''. In ATM these frames are of a fixed length (53 octets) called ''cells''. This differs from approaches such as Internet Proto ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
OSI Protocols
The Open Systems Interconnection protocols are a family of information exchange standards developed jointly by the ISO and the ITU-T. The standardization process began in 1977. While the seven-layer OSI model is often used as a reference for teaching and documentation, the protocols originally conceived for the model did not gain popularity, and only X.400, X.500, and IS-IS have achieved lasting impact. The goal of an open-standard protocol suite instead has been met by the Internet protocol suite, maintained by the Internet Engineering Task Force (IETF). Overview The OSI protocol stack is structured into seven conceptual layers. The layers form a hierarchy of functionality starting with the physical hardware components to the user interfaces at the software application level. Each layer receives information from the layer above, processes it and passes it down to the next layer. Each layer adds encapsulation information ( header) to the incoming information before it is passed ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Address Resolution Protocol
The Address Resolution Protocol (ARP) is a communication protocol used for discovering the link layer address, such as a MAC address, associated with a given internet layer address, typically an IPv4 address. This mapping is a critical function in the Internet protocol suite. ARP was defined in 1982 by , which is Internet Standard STD 37. ARP has been implemented with many combinations of network and data link layer technologies, such as IPv4, Chaosnet, DECnet and Xerox PARC Universal Packet (PUP) using IEEE 802 standards, FDDI, X.25, Frame Relay and Asynchronous Transfer Mode (ATM). In Internet Protocol Version 6 (IPv6) networks, the functionality of ARP is provided by the Neighbor Discovery Protocol (NDP). Operating scope The Address Resolution Protocol is a request-response protocol. Its messages are directly encapsulated by a link layer protocol. It is communicated within the boundaries of a single network, never routed across internetworking nodes. Packet structure The ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Layer
In the seven-layer OSI model of computer networking, the network layer is layer 3. The network layer is responsible for packet forwarding including routing through intermediate routers. Functions The network layer provides the means of transferring variable-length network packets from a source to a destination host via one or more networks. Within the service layering semantics of the OSI network architecture, the network layer responds to service requests from the transport layer and issues service requests to the data link layer. Functions of the network layer include: ; Connectionless communication : For example, IP is connectionless, in that a data packet can travel from a sender to a recipient without the recipient having to send an acknowledgement. Connection-oriented protocols exist at other, higher layers of the OSI model. ; Host addressing :Every host in the network must have a unique address that determines where it is. This address is normally assigned from a hierar ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
SONET
Synchronous optical networking (SONET) and synchronous digital hierarchy (SDH) are standardized protocols that transfer multiple digital bit streams synchronously over optical fiber using lasers or highly coherent light from light-emitting diodes (LEDs). At low transmission rates data can also be transferred via an electrical interface. The method was developed to replace the plesiochronous digital hierarchy (PDH) system for transporting large amounts of telephone calls and data traffic over the same fiber without the problems of synchronization. SONET and SDH, which are essentially the same, were originally designed to transport circuit mode communications (e.g., DS1, DS3) from a variety of different sources, but they were primarily designed to support real-time, uncompressed, circuit-switched voice encoded in PCM format. The primary difficulty in doing this prior to SONET/SDH was that the synchronization sources of these various circuits were different. This meant that each ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Synchronous Optical Networking
Synchronous optical networking (SONET) and synchronous digital hierarchy (SDH) are standardized protocols that transfer multiple digital bit streams synchronously over optical fiber using lasers or highly coherent light from light-emitting diodes (LEDs). At low transmission rates data can also be transferred via an electrical interface. The method was developed to replace the plesiochronous digital hierarchy (PDH) system for transporting large amounts of telephone calls and data traffic over the same fiber without the problems of synchronization. SONET and SDH, which are essentially the same, were originally designed to transport circuit mode communications (e.g., DS1, DS3) from a variety of different sources, but they were primarily designed to support real-time, uncompressed, circuit-switched voice encoded in PCM format. The primary difficulty in doing this prior to SONET/SDH was that the synchronization sources of these various circuits were different. This meant that each ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IS-IS
Intermediate System to Intermediate System (IS-IS, also written ISIS) is a routing protocol designed to move information efficiently within a computer network, a group of physically connected computers or similar devices. It accomplishes this by determining the best route for data through a packet switching network. The IS-IS protocol is defined in ISO/IEC 10589:2002 as an international standard within the Open Systems Interconnection (OSI) reference design. The Internet Engineering Task Force (IETF) republished IS-IS in , but that RFC was later marked as ''historic'' by because it republished a draft rather than a final version of the (International Organization for Standardization) ISO standard, causing confusion. IS-IS has been called "the ''de facto'' standard for large service provider network backbones." Description IS-IS is an interior gateway protocol, designed for use within an administrative domain or network. This is in contrast to exterior gateway protocols, pr ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Frame Relay
Frame Relay is a standardized wide area network (WAN) technology that specifies the physical and data link layers of digital telecommunications channels using a packet switching methodology. Originally designed for transport across Integrated Services Digital Network (ISDN) infrastructure, it may be used today in the context of many other network interfaces. Network providers commonly implement Frame Relay for voice (VoFR) and data as an encapsulation technique used between local area networks (LANs) over a WAN. Each end-user gets a private line (or leased line) to a Frame Relay node. The Frame Relay network handles the transmission over a frequently changing path transparent to all end-user extensively used WAN protocols. It is less expensive than leased lines and that is one reason for its popularity. The extreme simplicity of configuring user equipment in a Frame Relay network offers another reason for Frame Relay's popularity. With the advent of Ethernet over fiber optics, ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
ITU-T
The ITU Telecommunication Standardization Sector (ITU-T) is one of the three sectors (divisions or units) of the International Telecommunication Union (ITU). It is responsible for coordinating standards for telecommunications and Information Communication Technology such as X.509 for cybersecurity, Y.3172 and Y.3173 for machine learning, and H.264/MPEG-4 AVC for video compression, between its Member States, Private Sector Members, and Academia Members. The first meeting of the World Telecommunication Standardization Assembly (WTSA), the sector's governing conference, took place on 1 March of that year. ITU-T has a permanent secretariat called the Telecommunication Standardization Bureau (TSB), which is based at the ITU headquarters in Geneva, Switzerland. The current director of the TSB is Chaesub Lee (of South Korea), whose first 4-year term commenced on 1 January 2015, and whose second 4-year term commenced on 1 January 2019. Chaesub Lee succeeded Malcolm Johnson (Director), Malc ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
OSI Model
The Open Systems Interconnection model (OSI model) is a conceptual model that 'provides a common basis for the coordination of SOstandards development for the purpose of systems interconnection'. In the OSI reference model, the communications between a computing system are split into seven different abstraction layers: Physical, Data Link, Network, Transport, Session, Presentation, and Application. The model partitions the flow of data in a communication system into seven abstraction layers to describe networked communication from the physical implementation of transmitting bits across a communications medium to the highest-level representation of data of a distributed application. Each intermediate layer serves a class of functionality to the layer above it and is served by the layer below it. Classes of functionality are realized in all software development through all and any standardized communication protocols. Each layer in the OSI model has its own well-defined functi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
