HOME
*



picture info

Listed Buildings In Skegby
Skegby is a village in the Ashfield, Nottinghamshire, Ashfield district of Nottinghamshire, England. The village and its surrounding area contain ten Listed building#England and Wales, listed buildings that are recorded in the National Heritage List for England. All the listed buildings are designated at Grade II, the lowest of the three grades, which is applied to "buildings of national importance and special interest". The listed buildings consist of houses, a church, a animal pound, pinfold, and two war memorials. __NOTOC__ Buildings References Citations Sources

* * * * * * * * * * * {{DEFAULTSORT:Skegby Lists of listed buildings in Nottinghamshire Sutton-in-Ashfield ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Skegby
Skegby is a village and former civil parish, now in the unparished area of Sutton in Ashfield, in the Ashfield district of Nottinghamshire, England, located two miles west of Mansfield and one mile north of Sutton-in-Ashfield, close to Stanton Hill lying on the B6014 road. Skegby sits on both sides of a deep valley near the source of the River Meden. The parish covered about 1,433 acres and used to include the then hamlet of Stanton Hill. In 1931 the parish had a population of 6519. History The name of Skegby has a similar origin to the name of Skegness – originating from a Dane named ''Skeggi'' ("bearded one"). Skegby is mentioned in the Domesday Book as "a berewick of the King's manor at Mansfield". Skegby manor house (which is now in ruins) is located on Mansfield Road. In 1223 Godfrey Spigurnal became Lord of the Manor of Skegby. His descendants held the estate until 1334 when Elizabeth Spigurnal, who married Thomas Gobion, disposed of it to Richard Pensax. His descendan ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Coping (architecture)
Coping (from ''cope'', Latin ''capa'') is the capping or covering of a wall. A splayed or wedge coping is one that slopes in a single direction; a saddle coping slopes to either side of a central high point. A coping may be made of stone (capstone), brick, clay or terracotta, concrete or cast stone, tile, slate, wood, thatch, or various metals, including aluminum, copper, stainless steel, steel, and zinc. In all cases it should be weathered (have a slanted or curved top surface) to throw off the water. In Romanesque work, copings appeared plain and flat, and projected over the wall with a throating to form a drip. In later work a steep slope was given to the weathering (mainly on the outer side), and began at the top with an astragal; in the Decorated Gothic style there were two or three sets off; and in the later Perpendicular Gothic these assumed a wavy section, and the coping mouldings continued round the sides, as well as at top and bottom, mitring at the angles, as ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Bay (architecture)
In architecture, a bay is the space between architectural elements, or a recess or compartment. The term ''bay'' comes from Old French ''baie'', meaning an opening or hole."Bay" ''Online Etymology Dictionary''. http://www.etymonline.com/index.php?allowed_in_frame=0&search=bay&searchmode=none accessed 3/10/2014 __NOTOC__ Examples # The spaces between posts, columns, or buttresses in the length of a building, the division in the widths being called aisles. This meaning also applies to overhead vaults (between ribs), in a building using a vaulted structural system. For example, the Gothic architecture period's Chartres Cathedral has a nave (main interior space) that is '' "seven bays long." '' Similarly in timber framing a bay is the space between posts in the transverse direction of the building and aisles run longitudinally."Bay", n.3. def. 1-6 and "Bay", n.5 def 2. ''Oxford English Dictionary'' Second Edition on CD-ROM (v. 4.0) © Oxford University Press 2009 # Where there a ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Pantile
A pantile is a type of fired roof tile, normally made from clay. It is S-shaped in profile and is single lap, meaning that the end of the tile laps only the course immediately below. Flat tiles normally lap two courses. A pantile-covered roof is considerably lighter than a flat-tiled equivalent and can be laid to a lower pitch. Pantiles are used in eastern coastal parts of England and Scotland including Norfolk, East Yorkshire, County Durham, Perthshire, Angus, Lothian and Fife, where they were first imported from the Netherlands in the early 17th century. They are rarely used in western England or western Scotland, except in Bristol and the Somerset town of Bridgwater. Pantiles are best used in sheltered places or areas which are not subject to harsh weather conditions. In paving Roofing pantiles are not to be confused with the paving tiles also named "pantiles." The Pantiles in Royal Tunbridge Wells is named for the paving tiles installed there in 1699 — one-inch-thi ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Stucco
Stucco or render is a construction material made of aggregates, a binder, and water. Stucco is applied wet and hardens to a very dense solid. It is used as a decorative coating for walls and ceilings, exterior walls, and as a sculptural and artistic material in architecture. Stucco can be applied on construction materials such as metal, expanded metal lath, concrete, cinder block, or clay brick and adobe for decorative and structural purposes. In English, "stucco" sometimes refers to a coating for the outside of a building and "plaster" to a coating for interiors; as described below, however, the materials themselves often have little to no differences. Other European languages, notably Italian, do not have the same distinction; ''stucco'' means ''plaster'' in Italian and serves for both. Composition The basic composition of stucco is cement, water, and sand. The difference in nomenclature between stucco, plaster, and mortar is based more on use than composition. Until ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  




Close Studding
Close studding is a form of timber work used in timber-framed buildings in which vertical timbers ( studs) are set close together, dividing the wall into narrow panels. Rather than being a structural feature, the primary aim of close studding is to produce an impressive front.Looking at Buildings (Pevsner Architectural Guides): Close Studding
(accessed 20 October 2017)
Close studding first appeared in England in the 13th century and was commonly used there from the mid-15th century until the end of the 17th century. It was also common in France from the 15th century.


Description

Although close studding is defined by the distance between the vertical timbers, the spacing used is variable, up to a maximum o ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Timber Framed
Timber framing (german: Holzfachwerk) and "post-and-beam" construction are traditional methods of building with heavy timbers, creating structures using squared-off and carefully fitted and joined timbers with joints secured by large wooden pegs. If the structural frame of load-bearing timber is left exposed on the exterior of the building it may be referred to as half-timbered, and in many cases the infill between timbers will be used for decorative effect. The country most known for this kind of architecture is Germany, where timber-framed houses are spread all over the country. The method comes from working directly from logs and trees rather than pre-cut dimensional lumber. Hewing this with broadaxes, adzes, and draw knives and using hand-powered braces and augers (brace and bit) and other woodworking tools, artisans or framers could gradually assemble a building. Since this building method has been used for thousands of years in many parts of the world, many styles ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


Hood Mould
In architecture, a hood mould, hood, label mould (from Latin ''labia'', lip), drip mould or dripstone, is an external moulded projection from a wall over an opening to throw off rainwater, historically often in form of a ''pediment''. This moulding can be terminated at the side by ornamentation called a ''label stop''. The hood mould was introduced into architecture in the Romanesque period, though they became much more common in the Gothic period. Later, with the increase in rectangular windows they became more prevalent in domestic architecture. Styles of hood moulding File:IMG 0817 - Perugia - Finestra - Foto G. Dall'Orto - 6 ago 2006 - 01.jpg, Circular hood moulding File:StBeesSchoolMusicBlock.JPG, Rectangular hood mouldings on a rendered Victorian building File:Mercer House 2017.jpg, Every window of the Mercer House in Savannah, Georgia Savannah ( ) is the oldest city in the U.S. state of Georgia (U.S. state), Georgia and is the county seat of Chatham County, Georgia, ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Impost (architecture)
In architecture, an impost or impost block is a projecting block resting on top of a column or embedded in a wall, serving as the base for the springer or lowest voussoir of an arch. Ornamental training The imposts are left smooth or profiled, and "then express a certain separation between abutment and arch." The Byzantine fighters are high blocks, which are sometimes referred to as pulvino. The Romanesque designed the impost ornamentally or figuratively, similar to the capitals. In the Gothic period, the fighter almost completely disappeared from the calyx bud capital. The architecture of the Renaissance returns to the formation of the imposts of the ancient column orders. See also * Capital (architecture) * Abacus (architecture) * Pulvino A pulvino (or impost block) is an architectural structural element ( dosseret) having the shape of an inverted pyramid cushion, which is placed between the column capital and the arch base. Overview Usually decorated with fretwork or relief ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Gable
A gable is the generally triangular portion of a wall between the edges of intersecting roof pitches. The shape of the gable and how it is detailed depends on the structural system used, which reflects climate, material availability, and aesthetic concerns. The term gable wall or gable end more commonly refers to the entire wall, including the gable and the wall below it. Some types of roof do not have a gable (for example hip roofs do not). One common type of roof with gables, the gable roof, is named after its prominent gables. A parapet made of a series of curves (Dutch gable) or horizontal steps (crow-stepped gable) may hide the diagonal lines of the roof. Gable ends of more recent buildings are often treated in the same way as the Classic pediment form. But unlike Classical structures, which operate through trabeation, the gable ends of many buildings are actually bearing-wall structures. Gable style is also used in the design of fabric structures, with varying degree ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Manor House
A manor house was historically the main residence of the lord of the manor. The house formed the administrative centre of a manor in the European feudal system; within its great hall were held the lord's manorial courts, communal meals with manorial tenants and great banquets. The term is today loosely applied to various country houses, frequently dating from the Late Middle Ages, which formerly housed the landed gentry. Manor houses were sometimes fortified, albeit not as fortified as castles, and were intended more for show than for defencibility. They existed in most European countries where feudalism was present. Function The lord of the manor may have held several properties within a county or, for example in the case of a feudal baron, spread across a kingdom, which he occupied only on occasional visits. Even so, the business of the manor was directed and controlled by regular manorial courts, which appointed manorial officials such as the bailiff, granted ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]