|
IEEE 802.15
IEEE 802.15 is a working group of the Institute of Electrical and Electronics Engineers (IEEE) IEEE 802 standards committee which specifies wireless personal area network (WPAN) standards. There are 10 major areas of development, not all of which are active. The number of Task Groups in IEEE 802.15 varies based on the number of active projects. The current list of active projects can be found on thIEEE 802.15 web site IEEE 802.15.1: WPAN / Bluetooth Task group one is based on Bluetooth technology. It defines physical layer (PHY) and Media Access Control (MAC) specification for wireless connectivity with fixed, portable and moving devices within or entering personal operating space. Standards were issued in 2002 and 2005. IEEE 802.15.2: Coexistence Task group two addresses the coexistence of wireless personal area networks (WPAN) with other wireless devices operating in unlicensed frequency bands such as wireless local area networks (WLAN). The IEEE 802.15.2-2003 standard was publi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Ultra-wideband
Ultra-wideband (UWB, ultra wideband, ultra-wide band and ultraband) is a radio technology that can use a very low energy level for short-range, high-bandwidth communications over a large portion of the radio spectrum. UWB has traditional applications in non-cooperative radar imaging. Most recent applications target sensor data collection, precise locating, and tracking. UWB support started to appear in high-end smartphones 2019. Characteristics Ultra-wideband is a technology for transmitting information across a wide bandwidth (>500 MHz). This allows for the transmission of a large amount of signal energy without interfering with conventional narrowband and carrier wave transmission in the same frequency band. Regulatory limits in many countries allow for this efficient use of radio bandwidth, and enable high-data-rate personal area network (PAN) wireless connectivity, longer-range low-data-rate applications, and the transparent co-existence of radar and imaging systems with ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Ultra Wideband
Ultra-wideband (UWB, ultra wideband, ultra-wide band and ultraband) is a radio technology that can use a very low energy level for short-range, high-bandwidth communications over a large portion of the radio spectrum. UWB has traditional applications in non-cooperative radar imaging. Most recent applications target sensor data collection, precise locating, and tracking. UWB support started to appear in high-end smartphones 2019. Characteristics Ultra-wideband is a technology for transmitting information across a wide bandwidth (>500 MHz). This allows for the transmission of a large amount of signal energy without interfering with conventional narrowband and carrier wave transmission in the same frequency band. Regulatory limits in many countries allow for this efficient use of radio bandwidth, and enable high-data-rate personal area network (PAN) wireless connectivity, longer-range low-data-rate applications, and the transparent co-existence of radar and imaging systems with ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Working Group
A working group, or working party, is a group of experts working together to achieve specified goals. The groups are domain-specific and focus on discussion or activity around a specific subject area. The term can sometimes refer to an interdisciplinary collaboration of researchers working on new activities that would be difficult to sustain under traditional funding mechanisms (e.g., federal agencies). The lifespan of a working group can last anywhere between a few months and several years. Such groups have the tendency to develop a ''quasi-permanent existence'' when the assigned task is accomplished; hence the need to disband (or phase out) the working group when it has achieved its goal(s). A working group's performance is made up of the individual results of all its individual members. A team's performance is made up of both individual results and collective results. In large organisations, working groups are prevalent, and the focus is always on individual goals, performan ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
6LoWPAN
6LoWPAN (acronym of "IPv6 over Low-Power Wireless Personal Area Networks") in '6LoWPAN: The Embedded Internet', Shelby and Bormann redefine the 6LoWPAN acronym as "IPv6 over lowpower wireless area networks," arguing that "Personal" is no longer relevant to the technology. was a working group of the Internet Engineering Task Force (IETF). It was created with the intention of applying the Internet Protocol (IP) even to the smallest devices,Mulligan, Geoff"The 6LoWPAN architecture" EmNets '07: Proceedings of the 4th workshop on Embedded networked sensors, ''ACM'', 2007 enabling low-power devices with limited processing capabilities to participate in the Internet of Things. The 6LoWPAN group defined encapsulation, header compression, neighbor discovery and other mechanisms that allow IPv6 to operate over IEEE 802.15.4 based networks. Although IPv4 and IPv6 protocols do not generally care about the physical and MAC layers they operate over, the low power devices and small packet size d ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Free-space Optical Communication
Free-space optical communication (FSO) is an optical communication technology that uses light propagating in free space to wirelessly transmit data for telecommunications or computer networking. "Free space" means air, outer space, vacuum, or something similar. This contrasts with using solids such as optical fiber cable. The technology is useful where the physical connections are impractical due to high costs or other considerations. History Optical communications, in various forms, have been used for thousands of years. The ancient Greeks used a coded alphabetic system of signalling with torches developed by Cleoxenus, Democleitus and Polybius. In the modern era, semaphores and wireless solar telegraphs called heliographs were developed, using coded signals to communicate with their recipients. In 1880, Alexander Graham Bell and his assistant Charles Sumner Tainter created the photophone, at Bell's newly established Volta Laboratory in Washington, DC. Bell considered it ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bluetooth Mesh
Bluetooth Mesh is a computer mesh networking standard based on Bluetooth Low Energy that allows for many-to-many communication over Bluetooth radio. The Bluetooth Mesh specifications were defined in the Mesh Profile and Mesh Model specifications by the Bluetooth Special Interest Group (Bluetooth SIG). Bluetooth Mesh was conceived in 2014 and adopted on . Overview Bluetooth Mesh is a mesh networking standard that operates on a flood network principle. It's based on the nodes relaying the messages: every relay node that receives a network packet that authenticates against a known network key that is not in message cache, that has a TTL ≥ 2 can be retransmitted with TTL = TTL - 1. Message caching is used to prevent relaying messages recently seen. Communication is carried in the messages that may be up to 384 bytes long, when using Segmentation and Reassembly (SAR) mechanism, but most of the messages fit in one segment, that is 11 bytes. Each message starts with an opcode, ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Mesh Networking
A mesh network is a local area network topology in which the infrastructure nodes (i.e. bridges, switches, and other infrastructure devices) connect directly, dynamically and non-hierarchically to as many other nodes as possible and cooperate with one another to efficiently route data to and from clients. This lack of dependency on one node allows for every node to participate in the relay of information. Mesh networks dynamically self-organize and self-configure, which can reduce installation overhead. The ability to self-configure enables dynamic distribution of workloads, particularly in the event a few nodes should fail. This in turn contributes to fault-tolerance and reduced maintenance costs. Mesh topology may be contrasted with conventional star/tree local network topologies in which the bridges/switches are directly linked to only a small subset of other bridges/switches, and the links between these infrastructure neighbours are hierarchical. While star-and-tree topologi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Telecommunications Industry Association
The Telecommunications Industry Association (TIA) is accredited by the American National Standards Institute (ANSI) to develop voluntary, consensus-based industry standards for a wide variety of Information and Communication Technologies (Information and communication technologies, ICT) products, and currently represents nearly 400 companies. TIA's Standards and Technology Department operates twelve engineering committees, which develop guidelines for private radio equipment, cellular towers, data terminals, satellites, telephone terminal equipment, accessibility, VoIP devices, structured cabling, data centers, mobile device communications, multimedia multicast, vehicular telematics, healthcare ICT, Machine to machine, machine to machine communications, and smart grid, smart utility networks. Active participants include communications equipment manufacturers, service providers, government agencies, academic institutions, and end-users are engaged in TIA's standards setting proc ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Smart Grid
A smart grid is an electrical grid which includes a variety of operation and energy measures including: *Advanced metering infrastructure (of which smart meters are a generic name for any utility side device even if it is more capable e.g. a fiber optic router) *Smart distribution boards and circuit breakers integrated with home control and demand response (''behind the meter'' from a utility perspective) **Load control switches and smart appliances, often financed by efficiency gains on municipal programs (e.g. PACE financing) *Renewable energy resources, including the capacity to charge parked (electric vehicle) batteries or larger arrays of batteries recycled from these, or other energy storage. *Energy efficient resources *Sufficient utility grade fiber broadband to connect and monitor the above, with wireless as a backup. Sufficient spare if "dark" capacity to ensure failover, often leased for revenue. Electronic power conditioning and control of the production and distr ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
RFID
Radio-frequency identification (RFID) uses electromagnetic fields to automatically identify and track tags attached to objects. An RFID system consists of a tiny radio transponder, a radio receiver and transmitter. When triggered by an electromagnetic interrogation pulse from a nearby RFID reader device, the tag transmits digital data, usually an identifying inventory number, back to the reader. This number can be used to track inventory goods. Passive tags are powered by energy from the RFID reader's interrogating radio waves. Active tags are powered by a battery and thus can be read at a greater range from the RFID reader, up to hundreds of meters. Unlike a barcode, the tag does not need to be within the line of sight of the reader, so it may be embedded in the tracked object. RFID is one method of automatic identification and data capture (AIDC). RFID tags are used in many industries. For example, an RFID tag attached to an automobile during production can be used to track ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
C-UWB
C-UWB is an acronym for continuous pulse ultra-wideband (UWB) technology. C-UWB derives its bandwidth by virtue of the short time duration of the individual pulses. Information can be imparted (modulated) on UWB signals (pulses) by encoding the polarity of the pulse, the amplitude of the pulse, or by using orthogonal pulse shape modulation. Polarity modulation is analogous to BPSK in conventional RF technology. In orthogonal wave shape modulation, two orthogonal UWB pulse shapes are employed. These are further polarity modulated in a fashion analogous to QPSK Phase-shift keying (PSK) is a digital modulation process which conveys data by changing (modulating) the phase of a constant frequency reference signal (the carrier wave). The modulation is accomplished by varying the sine and cosine inputs at a ... in conventional radio technology. Preferably, the modulating data bits are scrambled or "whitened" to randomize the occurrences of ones and zeros. The pulses are sent contiguously ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
