|
Hulk (medieval Ship Type)
A hulk (or "holk") was a type of medieval sea craft, a technological predecessor of the carrack and caravel. The hulk appears to have remained a relatively minor type of sailing ship apparently peculiar to the Low Countries of Europe where it was probably used primarily as a river or canal boat, with limited potential for coastal cruising. The only evidence of hulks is from legal documents and iconography. History The name hulk may come from the Greek word ''holkas'', meaning a towed boat, which would be consistent with the use of the hulk as a river barge. The word hulk also has a medieval meaning of "hollowed-out" or "husk-like" which is also apposite for the shape of the basic hulk. It is not clear when the hulk first appeared in medieval Europe. There is a lack of archaeological evidence because no wreck has been found. The only evidence of hulks comes from iconography of ships scholars believe to be hulks and medieval documentation of trade and regulations. It is commonly ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Hulk (ship)
A hulk is a ship that is afloat, but incapable of going to sea. Hulk may be used to describe a ship that has been launched but not completed, an abandoned wreck or shell, or to refer to an old ship that has had its rigging or internal equipment removed, retaining only its buoyant qualities. The word hulk also may be used as a verb: a ship is "hulked" to convert it to a hulk. The verb was also applied to crews of Royal Navy ships in dock, who were sent to the receiving ship for accommodation, or "hulked". Hulks have a variety of uses such as housing, prisons, salvage pontoons, gambling sites, naval training, or cargo storage. In the days of sail, many hulls served longer as hulks than they did as functional ships. Wooden ships were often hulked when the hull structure became too old and weak to withstand the stresses of sailing. More recently, ships have been hulked when they become obsolete or when they become uneconomical to operate. Sheer hulk A sheer hulk (or shear hulk) w ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Stern
The stern is the back or aft-most part of a ship or boat, technically defined as the area built up over the sternpost, extending upwards from the counter rail to the taffrail. The stern lies opposite the bow, the foremost part of a ship. Originally, the term only referred to the aft port section of the ship, but eventually came to refer to the entire back of a vessel. The stern end of a ship is indicated with a white navigation light at night. Sterns on European and American wooden sailing ships began with two principal forms: the ''square'' or ''transom'' stern and the ''elliptical'', ''fantail'', or ''merchant'' stern, and were developed in that order. The hull sections of a sailing ship located before the stern were composed of a series of U-shaped rib-like frames set in a sloped or "cant" arrangement, with the last frame before the stern being called the ''fashion timber(s)'' or ''fashion piece(s)'', so called for "fashioning" the after part of the ship. This frame is d ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Ship Types
A ship is a large watercraft that travels the world's oceans and other sufficiently deep waterways, carrying cargo or passengers, or in support of specialized missions, such as defense, research, and fishing. Ships are generally distinguished from boats, based on size, shape, load capacity, and purpose. Ships have supported exploration, trade, warfare, migration, colonization, and science. After the 15th century, new crops that had come from and to the Americas via the European seafarers significantly contributed to world population growth. Ship transport is responsible for the largest portion of world commerce. The word ''ship'' has meant, depending on the era and the context, either just a large vessel or specifically a ship-rigged sailing ship with three or more masts, each of which is square-rigged. As of 2016, there were more than 49,000 merchant ships, totaling almost 1.8 billion dead weight tons. Of these 28% were oil tankers, 43% were bulk carriers, and 13% were con ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Worcester Chronicle - Henri I In A Hulk
Worcester may refer to: Places United Kingdom * Worcester, England, a city and the county town of Worcestershire in England ** Worcester (UK Parliament constituency), an area represented by a Member of Parliament * Worcester Park, London, England * Worcestershire, a county in England United States * Worcester, Massachusetts, the largest city with the name in the United States ** Worcester County, Massachusetts * Worcester, Missouri * Worcester, New York, a town ** Worcester (CDP), New York, within the town * Worcester Township, Montgomery County, Pennsylvania * Worcester, Vermont ** Worcester (CDP), Vermont, within the town * Worcester, Wisconsin, a town * Worcester (community), Wisconsin, an unincorporated community * Worcester County, Maryland * Barry, Illinois, formerly known as Worcester * Marquette, Michigan, formerly known as New Worcester Other places * Worcester, Limpopo, South Africa * Worcester, Western Cape, South Africa * Worcester Summit, Antarctica Transportati ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Shipbuilding
Shipbuilding is the construction of ships and other floating vessels. It normally takes place in a specialized facility known as a shipyard. Shipbuilders, also called shipwrights, follow a specialized occupation that traces its roots to before recorded history. Shipbuilding and ship repairs, both commercial and military, are referred to as "naval engineering". The construction of boats is a similar activity called boat building. The dismantling of ships is called ship breaking. History Pre-history The earliest known depictions (including paintings and models) of shallow-water sailing boats is from the 6th to 5th millennium BC of the Ubaid period of Mesopotamia. They were made from bundled reeds coated in bitumen and had bipod masts. They sailed in shallow coastal waters of the Persian Gulf. 4th millennium BC Ancient Egypt Evidence from Ancient Egypt shows that the early Egyptians knew how to assemble planks of wood into a ship hull as early as 3100 BC. Egyptian potte ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Hull (ship)
A hull is the watertight body of a ship, boat, or flying boat. The hull may open at the top (such as a dinghy), or it may be fully or partially covered with a deck. Atop the deck may be a deckhouse and other superstructures, such as a funnel, derrick, or mast. The line where the hull meets the water surface is called the waterline. General features There is a wide variety of hull types that are chosen for suitability for different usages, the hull shape being dependent upon the needs of the design. Shapes range from a nearly perfect box in the case of scow barges to a needle-sharp surface of revolution in the case of a racing multihull sailboat. The shape is chosen to strike a balance between cost, hydrostatic considerations (accommodation, load carrying, and stability), hydrodynamics (speed, power requirements, and motion and behavior in a seaway) and special considerations for the ship's role, such as the rounded bow of an icebreaker or the flat bottom of a landing craft. ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Apron (other)
An apron is a functional accessory that has been worn for thousands of years as a protective, fashionable, and/or ceremonial top layer. Apron may also refer to: Architecture and construction * Apron (architecture), a raised section of ornamental stonework below a window ledge, stone tablet, or monument * Apron, an area of pavement on a motorsport circuit that separates the racing surface from the infield * Apron, the flexible lower container of the air cushion of a hovercraft, also known as its skirt * Apron, a ramp used to connect shoreside facilities with a barge or ferry, also known as a linkspan * Airport apron, an area where aircraft are parked and serviced * Apron stage, a part of a stage that extends past the proscenium arch and into the audience or seating area *Apron, a large plastic panel at the bottom of a pinball table that directs the ball towards the drain. Biology * Apron, elongated labia minora * ''Zingel asper'', a species of fish sometimes known as an apron Garme ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Stern Post
A sternpost is the upright structural member or post at the stern of a (generally wooden) ship or a boat, to which are attached the transoms and the rearmost left corner part of the stern. The sternpost may either be completely vertical or may be tilted or "raked" slightly aft. It rests on or "fays to" the ship's keel. See also * Boat building * Shipbuilding Shipbuilding is the construction of ships and other floating vessels. It normally takes place in a specialized facility known as a shipyard. Shipbuilders, also called shipwrights, follow a specialized occupation that traces its roots to befor ... References Watercraft components {{navy-stub ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Stem (ship)
The stem is the most forward part of a boat or ship's bow and is an extension of the keel itself. It is often found on wooden boats or ships, but not exclusively. Description The stem is the curved edge stretching from the keel below, up to the gunwale of the boat. It is part of the physical structure of a wooden boat or ship that gives it strength at the critical section of the structure, bringing together the port and starboard side planks of the hull. Plumb and raked stem There are two styles of stems: ''plumb'' and ''raked''. When the stem comes up from the water, if it is perpendicular to the waterline it is "plumb". If it is inclined at an angle to the waterline it is "raked". (For example, "The hull is single decked and characterized by a plumb stem, full bows, straight keel, moderate deadrise, and an easy turn of bilge.") Stemhead Because the stem is very sturdy, the top end of it may have something attached, either ornamental or functional in nature. On smalle ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Seakeeping
Seakeeping ability or seaworthiness is a measure of how well-suited a watercraft is to conditions when underway. A ship or boat which has good seakeeping ability is said to be very seaworthy and is able to operate effectively even in high sea states. Measure In 1976, St. Denis suggested four principal terms needed to describe a seakeeping performance. These are: *Mission: what the ship is intended to accomplish. The role of the ship while at sea. *Environment: the conditions under which the ship is operating. This can be described as sea state, wind speed, geographic region or some combination thereof. *Ship responses: the response of the ship to the environmental conditions. The responses are a function of the environment and the vessel characteristics. *Seakeeping performance criteria: the established limits for the ship's responses. These are based on the ship motions and the accelerations experienced, and include comfort criteria such as noise, vibration and sea sickness, perfo ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Clinker (boat Building)
Clinker built (also known as lapstrake) is a method of boat building where the edges of hull planks overlap each other. Where necessary in larger craft, shorter planks can be joined end to end, creating a longer strake or hull plank. The technique originated in Scandinavia, and was successfully used by the Anglo-Saxons, Frisians, Scandinavians, typically in the vessels known as cogs employed by the Hanseatic League. Carvel construction, where plank edges are butted smoothly, seam to seam, supplanted clinker construction in large vessels as the demand for capacity surpassed the limits of clinker construction. (See Comparison between clinker and carvel below.). Examples of clinker-built boats that are directly descended from those of the early medieval period are seen in the traditional round-bottomed Thames skiffs, and the larger (originally) cargo-carrying Norfolk wherries of England. Etymology From ''clinch'', or ''clench'', a common Germanic word, meaning “to fasten ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
.png "Click for more on -> Shipbuilding")
_during_Typhoon_Cobra%2C_December_1944.jpg "Click for more on -> Seakeeping")
