|
Gun Trust
The National Firearms Act (NFA), 73rd Congress, Sess. 2, ch. 757, was enacted on June 26, 1934, and currently codified and amended as . The law is an Act of Congress in the United States that, in general, imposes an excise tax on the manufacture and transfer of certain firearms and mandates the registration of those firearms. The NFA is also referred to as Title II of the federal firearms laws, with the Gun Control Act of 1968 ("GCA") as Title I. All transfers of ownership of registered NFA firearms must be done through the National Firearms Registration and Transfer Record (the "NFA registry"). The NFA also requires that the permanent transport of NFA firearms across state lines by the owner must be reported to the Bureau of Alcohol, Tobacco, Firearms and Explosives (ATF). Temporary transports of some items, most notably suppressors (also referred to as silencers), do not need to be reported. Background The ostensible impetus for the National Firearms Act of 1934 was the ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Internal Revenue Code
The Internal Revenue Code (IRC), formally the Internal Revenue Code of 1986, is the domestic portion of federal statutory tax law in the United States, published in various volumes of the United States Statutes at Large, and separately as Title 26 of the United States Code (USC). It is organized topically, into subtitles and sections, covering income tax in the United States, payroll taxes, estate taxes, gift taxes, and excise taxes; as well as procedure and administration. The Code's implementing federal agency is the Internal Revenue Service. Origins of tax codes in the United States Prior to 1874, U.S. statutes (whether in tax law or other subjects) were not codified. That is, the acts of Congress were not separately organized and published in separate volumes based on the subject matter (such as taxation, bankruptcy, etc.). Codifications of statutes, including tax statutes, undertaken in 1873 resulted in the Revised Statutes of the United States, approved June 22, 1874, e ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bureau Of Alcohol, Tobacco, Firearms And Explosives
The Bureau of Alcohol, Tobacco, Firearms and Explosives (BATFE), commonly referred to as the ATF, is a domestic law enforcement agency within the United States Department of Justice. Its responsibilities include the investigation and prevention of federal offenses involving the unlawful use, manufacture, and possession of firearms and explosives; acts of arson and bombings; and illegal trafficking and tax evasion of alcohol and tobacco products. The ATF also regulates via licensing the sale, possession, and transportation of firearms, ammunition, and explosives in interstate commerce. Many of the ATF's activities are carried out in conjunction with task forces made up of state and local law enforcement officers, such as Project Safe Neighborhoods. The ATF operates a unique fire research laboratory in Beltsville, Maryland, where full-scale mock-ups of criminal arson can be reconstructed. The ATF had 5,285 employees and an annual budget of almost $1.5 billion in 2021. The ATF ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Gunsmiths
A gunsmith is a person who repairs, modifies, designs, or builds guns. The occupation differs from an armorer, who usually replaces only worn parts in standard firearms. Gunsmiths do modifications and changes to a firearm that may require a very high level of craftsmanship, requiring the skills of a top-level machinist, a very skilled woodworker, and even an engineer. Gunsmiths perform factory-level repairs and renovations to restore a well-used or deteriorated firearms to new condition. They may make alterations to adapt sporting guns to better fit the individual shooter that may require extensive modifications to the firearm's stocks and metal parts. Repairs and redesigns may require fabrication and fitting of unavailable parts and assemblies constructed by smiths themselves. Gunsmiths may also renew metal finishes or apply decorative carvings or engravings to guns. Many gun shops offer gunsmithing service on the premises. Overview Gunsmiths may be employed in: *factories by fi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Suppressor
A silencer, also known as a sound suppressor, suppressor, or sound moderator, is a muzzle device that reduces the acoustic intensity Sound intensity, also known as acoustic intensity, is defined as the power carried by sound waves per unit area in a direction perpendicular to that area. The SI unit of intensity, which includes sound intensity, is the watt per square meter (W/m2 ... of the muzzle report (sound of a gunshot) and muzzle rise when a gun (firearm or air gun) is discharged, by modulating the speed and pressure of the propellant gas from the muzzle and hence suppressing the muzzle blast. Like other muzzle devices, a silencer can be a detachable accessory mounted to the muzzle, or an integral part of the gun barrel, barrel. A typical silencer is a metallic (usually stainless steel or titanium) cylinder containing internal sound baffles, with a hollow bore to allow the projectile (bullet) to exit normally. During firing, the bullet flies through the bore with litt ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Smoothbore
A smoothbore weapon is one that has a barrel without rifling. Smoothbores range from handheld firearms to powerful tank guns and large artillery mortars. History Early firearms had smoothly bored barrels that fired projectiles without significant spin. To minimize inaccuracy-inducing tumbling during flight, their projectiles required an aerodynamically uniform shape, such as a sphere. However, surface imperfections on the projectile and/or the barrel will cause even a sphere to rotate randomly during flight, and the Magnus effect will curve it off the intended trajectory when spinning on any axis not parallel to the direction of travel. Rifling the bore surface with spiral grooves or polygonal valleys imparts a stabilizing gyroscopic spin to a projectile that prevents tumbling in flight. Not only does this more than counter Magnus-induced drift, but it allows a longer, more streamlined round with greater sectional density to be fired from the same caliber barrel, improvin ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Sawed-off Shotgun
A sawed-off shotgun (also called a sawn-off shotgun, short-barreled shotgun, shorty or a boom stick) is a type of shotgun with a shorter gun barrel—typically under —and often a shortened or absent stock. Despite the colloquial term, barrels do not, strictly speaking, have to be shortened with a saw. Barrels can be manufactured at shorter lengths as an alternative to traditional, longer barrels. This makes them easier to transport due to their smaller profile and lighter weight. The design also makes the weapon easy to maneuver in cramped spaces, a feature sought by military close-quarters combat units, law enforcement SWAT team users, and those concerned with home-defence. As a result of the shorter barrel length, any sawn-off shotgun with a magazine tube will have its capacity reduced. In the 1930s, the United States of America, Britain and Canada mandated that a permit be required to own these firearms. They are subject to legal restrictions depending upon jurisd ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Short-barreled Rifle
Short-barreled rifle broadly refers to any rifle with an unusually short barrel. The term carbine describes a production rifle with a reduced barrel length for easier handling in confined spaces. Concern about concealment for illegal purposes has encouraged regulations specifying minimum barrel lengths and overall lengths. Measurement method Barrel length is measured from the end of the muzzle to the front of the breechface, typically by inserting a measuring rod into the barrel. Barrel length may partially comprise a permanently attached muzzle accessory (such as a recoil compensator or flash suppressor). Overall length is measured between the extreme ends of the gun, along a centerline which passes through the middle of the barrel. For rifles fitted with folding or telescoping stocks (such as U.S. Carbine M1A1), US Federal guidelines state that measurement is performed with the stock unfolded as intended for use as a rifle. Some states – such as California and Michigan – ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
KG-9
The Intratec TEC-9, TEC-DC9, KG-99 and AB-10 are a line of blowback-operated semi-automatic pistols. They were developed by Intratec, an American subsidiary of the Swedish firearms manufacturer Interdynamic AB. Introduced in 1984, the TEC-9 was made of inexpensive molded polymers and a mixture of stamped and milled steel parts. The simple design of the gun made it easy to repair and modify. The TEC-9 developed a negative reputation for its association with organized crime, street gangs and mass shootings in the 1990s, with it most notably being used during the 101 California Street shooting and the Columbine High School massacre. However, it was a commercial success, with over 250,000 being sold. History Interdynamic AB, a Swedish firearms manufacturer based in Stockholm, designed the Interdynamic MP-9, intended as an inexpensive 9mm submachine gun based on the Carl Gustav M/45 for military applications. The firearm was initially intended for adoption by the South African ap ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Burst Fire
In automatic firearms, burst mode or burst-fire is a firing mode enabling the shooter to fire a predetermined number of rounds, usually two or three rounds on hand held weapons and 50-100+ on anti-aircraft weapons and autocannons, with a single pull of the trigger. This firing mode is commonly used in submachine guns and assault rifles. Other types of firearms, such as machine pistols, e.g., the Heckler & Koch VP70 and Beretta 93R also have a burst mode. The burst mode is normally employed as an intermediate fire mode between semi-automatic and fully automatic, although some firearms lack a "full auto" capability and use a burst mode instead. For instance, the M16A4 (the standard-issue service rifle of the USMC) has, in addition to the semi-automatic mode, a three-round burst mode, which replaced the fully automatic mode of the previous M16A1 and A3 models. The reason for this replacement was the massive waste of ammunition and very poor performance of soldiers who fired their ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Machine Gun
A machine gun is a fully automatic, rifled autoloading firearm designed for sustained direct fire with rifle cartridges. Other automatic firearms such as automatic shotguns and automatic rifles (including assault rifles and battle rifles) are typically designed more for firing short bursts rather than continuous firepower, and are not considered true machine guns. As a class of military kinetic projectile weapon, machine guns are designed to be mainly used as infantry support weapons and generally used when attached to a bipod or tripod, a fixed mount or a heavy weapons platform for stability against recoils. Many machine guns also use belt feeding and open bolt operation, features not normally found on other infantry firearms. Machine guns can be further categorized as light machine guns, medium machine guns, heavy machine guns, general purpose machine guns and squad automatic weapons. Similar automatic firearms of caliber or more are classified as autocannons, rat ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
United States Department Of The Treasury
The Department of the Treasury (USDT) is the national treasury and finance department of the federal government of the United States, where it serves as an executive department. The department oversees the Bureau of Engraving and Printing and the U.S. Mint. These two agencies are responsible for printing all paper currency and coins, while the treasury executes its circulation in the domestic fiscal system. The USDT collects all federal taxes through the Internal Revenue Service; manages U.S. government debt instruments; licenses and supervises banks and thrift institutions; and advises the legislative and executive branches on matters of fiscal policy. The department is administered by the secretary of the treasury, who is a member of the Cabinet. The treasurer of the United States has limited statutory duties, but advises the Secretary on various matters such as coinage and currency production. Signatures of both officials appear on all Federal Reserve notes. The depart ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Giuseppe Zangara
Giuseppe Zangara (September 7, 1900 – March 20, 1933) was an Italian immigrant and naturalized United States citizen who attempted to assassinate the President-elect of the United States, Franklin D. Roosevelt, on February 15, 1933, 17 days before Roosevelt's inauguration. During a night speech by Roosevelt in Miami, Florida, Zangara fired five shots with a handgun he had purchased a couple of days before. He missed his target and instead injured five bystanders and killed Anton Cermak, the Mayor of Chicago. Early life Zangara was born on September 7, 1900, in Ferruzzano, Calabria, Italy. After serving in the Tyrolean Alps in World War I, he did a variety of menial jobs in his home village before emigrating with his uncle to the United States in 1923. He settled in Paterson, New Jersey, and became a naturalized citizen of the United States in 1929. Health issues Zangara had little education and worked as a bricklayer. He suffered severe pain in his abdomen, which doc ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
