|
FS Class E402
E.402A/B is a class of electric locomotives mainly used on medium speed passenger trains (max 200 km/h services like InterCity or Frecciabianca) by the Italian railway company FS Trenitalia. History After the positive experiences from the locomotive Class E.632 with DC traction motors with thyristors, FS wanted to order a new generation high performance locomotives with AC traction motors (also called Induction, three-phase or asynchronous motors). At the beginning of 1990s FS studied, in collaboration with the two companies Ansaldo Transporti (mechanical part) and TIBB (electric part, the Italian part of the BBC company) a new locomotive that could haul both heavy goods trains and high speed trains, the later at speeds up to 220 km/h. The result was class E.402.0. Later, Siemens took over the development for the electric part. A total of six prototypes have been built (E.402.000 - 005), which have seen a long phase of test runs before finally entering active service. The proto ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Volt
The volt (symbol: V) is the unit of electric potential, electric potential difference (voltage), and electromotive force in the International System of Units (SI). It is named after the Italian physicist Alessandro Volta (1745–1827). Definition One volt is defined as the electric potential between two points of a conducting wire when an electric current of one ampere dissipates one watt of power between those points. Equivalently, it is the potential difference between two points that will impart one joule of energy per coulomb of charge that passes through it. It can be expressed in terms of SI base units ( m, kg, second, s, and ampere, A) as : \text = \frac = \frac = \frac. It can also be expressed as amperes times ohms (current times resistance, Ohm's law), webers per second (magnetic flux per time), watts per ampere (power per current), or joules per coulomb (energy per charge), which is also equivalent to electronvolts per elementary charge: : \text = \tex ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Train Communication Network
The train communication network (TCN) is a hierarchical combination of two fieldbus for data transmission within trains. It consists of the Multifunction Vehicle Bus (MVB) inside each vehicle and of the Wire Train Bus (WTB) to connect the different vehicles. The TCN components have been standardized in IEC 61375. Multifunction vehicle bus (MVB) The multifunction vehicle bus connects individual nodes within a vehicle or in a closed train set. Unlike the WTB there is no requirement on a single international connector standard for the vehicle bus inside a coach, locomotive or train set – instead there are three predefined media and connector classes: # OGF (Fiber-optic cable, optical glass fibres) uses 240 μm fibers for a line distance of 2000 m, # EMD (electrical medium distance) uses shielded twisted pair with RS 485 transmitters and transformers for galvanical isolation), for a length reaching 200 m and # ESD (electrical short distance) uses a simple backplane ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
AnsaldoBreda Locomotives
Hitachi Rail Italy S.p.A. is a multinational rolling stock manufacturer company based in Pistoia, Italy. Formerly AnsaldoBreda S.p.A., a subsidiary of state-owned Finmeccanica, the company was sold in 2015 to Hitachi Rail of Japan. After the deal was finalized, the current name was adapted in November 2015 to reflect the new ownership. History Early history: Ansaldo and Breda Ansaldo In 1853, the company '' Gio. Ansaldo & C.'' was registered in Genoa as a manufacturer of steam locomotives, rail rolling stock and steam engines. The company was backed by Camillo Benso, Count of Cavour, the powerful finance minister of Piedmont-Sardinia, who aimed to reduce its dependence on imported trains and rolling stock. Ansaldo entered the age of the steam locomotive in 1854 with its model FS113, also known as ''Sampierdarena''. During the First world war, Ansaldo became a large supplier of weapons to the Italian army; facing insurmountable difficulties with post-war reconversion to civil ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
FS Class E
FS, fS or fs may refer to: Arts and entertainment * FS (musician) (real name Fred Sargolini), American dubstep producer and DJ from New York * FS Catalogue, a numbered list of all compositions by Carl Nielsen * FS Film, a Finnish film distributor *Flight simulator, a professional simulator of planes **Amateur flight simulation, a video game version of simulators ***''Microsoft Flight Simulator'', an amateur flight simulator series ****''Microsoft Flight Simulator X'', the 2006 edition, commonly referred to as ''FSX'' **** ''Microsoft Flight Simulator'' (2020 video game), the 2020 edition, commonly referred to as ''FS'' Businesses and organizations In transportation * ''Ferrocarril de Sóller'', a railway on Majorca * ''Ferrovie dello Stato'', Italian state railways * First ScotRail, a British rail train operator * ItAli Airlines (IATA airline designator FS) * FS Trenitalia Italian railway company Other businesses and organizations * Frankfurt School of Finance & Management, a B ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Volt-ampere
A volt-ampere ( SI symbol: V⋅A or V A, simplified as VA) is the unit for the apparent power in an electrical circuit. The apparent power equals the product of root mean square voltage (in volts) and root mean square current (in amperes). Volt-amperes are usually used for analyzing alternating current (AC) circuits. In direct current (DC) circuits, this product is equal to the real power, in watts. The volt-ampere is dimensionally equivalent to the watt: in SI units, 1 V⋅A = 1 W). VA rating is most used for generators and transformers (and other power handling equipment) where loads may be reactive (inductive or capacitive). Formulation For a simple electrical circuit running on direct current, the electrical current and voltage are constant. In that case, the real power (''P'', measured in watts) is the product of the electrical current (''I'', measured in amperes) and the voltage from one side of the circuit to the other (''V'', measured in volts): ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Gate Turn-off Thyristor
A gate turn-off thyristor (GTO) is a special type of thyristor, which is a high-power (.e.g. 1200V AC) semiconductor device. It was invented by General Electric. GTOs, as opposed to normal thyristors, are fully controllable switches which can be turned on and off by their gate lead. Device description Normal thyristors (silicon-controlled rectifiers) are not fully controllable switches (a "fully controllable switch" can be turned on and off at will). Thyristors can only be turned on using the gate lead, but cannot be turned off using the gate lead. Thyristors are switched on by a gate signal, but even after the gate signal is de-asserted (removed, reverse biased), the thyristor remains in the on state until a turn-off condition occurs (which can be the application of a reverse voltage to the terminals or a decrease of the forward current below a certain threshold value known as the "holding current"). Thus, a thyristor behaves like a normal semiconductor diode after it is turned ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Rectifier
A rectifier is an electrical device that converts alternating current (AC), which periodically reverses direction, to direct current (DC), which flows in only one direction. The reverse operation (converting DC to AC) is performed by an Power inverter, inverter. The process is known as ''rectification'', since it "straightens" the direction of current. Physically, rectifiers take a number of forms, including Vacuum tube#Diodes, vacuum tube diodes, wet chemical cells, mercury-arc valves, stacks of copper and selenium rectifier, selenium oxide plates, Diode#Semiconductor diodes, semiconductor diodes, silicon-controlled rectifiers and other silicon-based semiconductor switches. Historically, even synchronous electromechanical switches and motor-generator sets have been used. Early radio receivers, called crystal radios, used a "Cat's-whisker detector, cat's whisker" of fine wire pressing on a crystal of galena (lead sulfide) to serve as a point-contact rectifier or "crystal detec ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Chopper (electronics)
In electronics, a chopper circuit is any of numerous types of electronic switching devices and circuits used in power control and signal applications. A chopper is a device that converts fixed DC input to a variable DC output voltage directly. Essentially, a chopper is an electronic switch that is used to interrupt one signal under the control of another. In power electronics applications, since the switching element is either fully on or fully off, its losses are low and the circuit can provide high efficiency. However, the current supplied to the load is discontinuous and may require smoothing or a high switching frequency to avoid undesirable effects. In signal processing circuits, use of a chopper stabilizes a system against drift of electronic components; the original signal can be recovered after amplification or other processing by a synchronous demodulator that essentially un-does the "chopping" process. Comparison (step down chopper and step up chopper) Comparison bet ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Inverter (electrical)
A power inverter, inverter or invertor is a power electronic device or circuitry that changes direct current (DC) to alternating current (AC). The resulting AC frequency obtained depends on the particular device employed. Inverters do the opposite of rectifiers which were originally large electromechanical devices converting AC to DC. The input voltage, output voltage and frequency, and overall power handling depend on the design of the specific device or circuitry. The inverter does not produce any power; the power is provided by the DC source. A power inverter can be entirely electronic or may be a combination of mechanical effects (such as a rotary apparatus) and electronic circuitry. Static inverters do not use moving parts in the conversion process. Power inverters are primarily used in electrical power applications where high currents and voltages are present; circuits that perform the same function for electronic signals, which usually have very low currents and vol ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Electric Locomotive
An electric locomotive is a locomotive powered by electricity from overhead lines, a third rail or on-board energy storage such as a battery or a supercapacitor. Locomotives with on-board fuelled prime movers, such as diesel engines or gas turbines, are classed as diesel-electric or gas turbine-electric and not as electric locomotives, because the electric generator/motor combination serves only as a power transmission system. Electric locomotives benefit from the high efficiency of electric motors, often above 90% (not including the inefficiency of generating the electricity). Additional efficiency can be gained from regenerative braking, which allows kinetic energy to be recovered during braking to put power back on the line. Newer electric locomotives use AC motor-inverter drive systems that provide for regenerative braking. Electric locomotives are quiet compared to diesel locomotives since there is no engine and exhaust noise and less mechanical noise. The lack of re ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Direct Current
Direct current (DC) is one-directional flow of electric charge. An electrochemical cell is a prime example of DC power. Direct current may flow through a conductor such as a wire, but can also flow through semiconductors, insulators, or even through a vacuum as in electron or ion beams. The electric current flows in a constant direction, distinguishing it from alternating current (AC). A term formerly used for this type of current was galvanic current. The abbreviations ''AC'' and ''DC'' are often used to mean simply ''alternating'' and ''direct'', as when they modify ''current'' or ''voltage''. Direct current may be converted from an alternating current supply by use of a rectifier, which contains electronic elements (usually) or electromechanical elements (historically) that allow current to flow only in one direction. Direct current may be converted into alternating current via an inverter. Direct current has many uses, from the charging of batteries to large power sup ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
